Based on the amplifier given in Fig. 2, draw the small signal equivalent and  derive the two time constants associated with capacitances C1 and C2. Assume  early voltage is infinity. Finally, indicate which formula out of the two should be  used for the lower 3 dB frequency calculation? Formulate the maximum gain.  Draw a rough frequency response based on your formulation

Q: Consider the system transfer function for input X(s) and output Y(s), assuming zero ini- conditions:…

A: I have written this solution as handwritten solution. Hope you find the solution clear.

Q: What is the minimum sized PVC Schedule 80 conduit we should use for the above wire run if it is over…

A: To determine the minimum sized PVC Schedule 80 conduit needed for the above wire run if it is over…

Q: 1. Realize the given admittance function Y(s) in the circuit form given in Figure 1. Y(s) s² + 4s +3…

A:

Q: Determine which of the logic circuits In Figure bellow are equivalent. BDB B'. A D'.

A: Given data, Circuit diagram is given as,

Q: In the following network, the voltage magnitudes at all buses are equal to 1 p.u., the voltage phase…

A: Given- Voltage magnitudes at all buses = 1 p.u. Voltage phase angles are small, Line resistance are…

Q: PROBLEM NUMBER 1 a. Draw the basic construction of a p-channel JFET. b. Apply the proper biasing…

A: Given  We need to draw the construction of a p channel JFET and also sketch depletion region in case…

Q: 1) Solve the circuit of Fig. 1 to determine the output voltage vo(t) and the current i(t). 2)…

A: The required parameters can be calculated by using the ideal operational amplifier characteristics…

Q: Consider the following modulated signal in an Amplitude Modulation with Large Carrier (AM-LC), or…

A:

Q: Problem 8 Find values of Vc, Vo at t= (a) 0- (b) 0+ (c) 1.3ms 250 Ω 600 Ω 4 μF 카 + VC - 1250 Ω t=0 2…

A:

Q: A sinusoidal voltage trace displayed by an oscilloscope is shown, if the 'time/div' or Hs, switch is…

A:

Q: How do semiconductor diodes and transistors compare?

A:

Q: Considering terminals a and b: a) Use any method to solve for the Thevenin equivalent voltage. b)…

A: The thevenin's equivalent circuit can be obtained by calculating the open circuit voltage and…

Q: Q2) Use mesh analysis to find the voltage "V." in the circuit shown 1 ΚΩ I, 1ΚΩ Μ + )12V TRAI 51 ΚΩ…

A:

Q: With the conditions given below, if voltage is v(t) = 8Sin4000ft mV, with the oscilloscope, Vs, Vd,…

A:

Q: To produce a digital audio bit stream of an audio signal that contains tones at 350 Hz, 1000 Hz and…

A: Note: Relation between Sampling Frequency and Maximum analog Frequency Outcomes after…

Q: A discharging RC current has a resistor with R equals 40€ and T= 16s. It is known that one T equals…

A: In a discharging RC circuit, the voltage across the capacitor decreases over time and the current…

Q: Solve the following problem in the paper then answer it correctly. GIVEN: REQUIRED: SOLUTION:…

A:

Q: Please show the work in between the rearranged formula and the answer

A: Given: Calculate the S/N in dB if the passband circuit is 48kHz to 64kHz and the maximum bit rate is…

Q: ___ readings can be taken at the incoming power leads or the motor leads. a. Current. b Frequency…

A: The power supply leads will provide the measurements related to the input quantity and it can't…

Q: Problem 3: Passive Component Equivalences Consider the following network of inductors, with their…

A:

Q: INCLUDE BLOCK DIAGRAM & FRONT PANEL PLEASE!!! Assume that you have a resistive DC circuit with V =…

A:

Q: 60° c

A: In the given figure it is a two sinusoidal signal v1 and v2 , we need to find the angle between the…

Q: In the circuit shown what is the time period of oscillations? 0.1μf 5k R = 2k ww 10K V₂

A: Given circuit:

Q: QUESTION 1 The charge taken by a capacitor is 0.4 HC when terminal voltage is 32 V. The plate area…

A:

Q: Formulate the condition for maximizing SNR of a digital communication receiver system.

A: Introduction The Signal-to-Noise Ratio (SNR) is a metric used in communication systems to…

Q: Find the voltage V, shown in the figure below. 10/30°v (+ degrees 5Ω ww j120 -j14Ω Enter (a) the…

A: Given data, To find V0 in the above circuit.

Q: A sinusoidal voltage trace displayed by an oscilloscope is shown, if the 'time/div' or Hs, switch is…

A: Option c is correct    Calculation of amplitude:- since amplitude is 2 division up and below, Each…

Q: Series Inductance The supply across the terminals of this circuit is 470 V, 50 Hz. An ammeter is…

A:

Q: What is the minimum sized Rigid Metal Conduit we should use for the above wire run if it is 24…

A: To determine the minimum size of Rigid Metal Conduit (RMC) required for the given wire run, we need…

Q: Use the mesh current method to find the branch currents i₁- ¡6. Figure P4.14 125 V 125 V 10 ww 41…

A:

Q: 7.5 V V1=1.125V V1=2.25V O V1= 4.5V O V1=9V Vo=2.7V Vo=3.4V Vo=4.5V Vo=5.4V v1=-v2 v1=v2 v1>v2 y1<y²…

A:

Q: 7. GIVEN THE SECOND ORDER INPut SYSTEM SHOWN BELOW dzy4) dt² +8 dy(t) वट +16y(t) = 4(t) WHERE ult) =…

A:

Q: Find the Laplace transform of the following function. That is, determine coefficient H. f(t) =…

A:

Q: single-phase Consider an ideal full-bridge DC - AC inverter with a DC bus voltage magnitude of 1000…

A: Given: An ideal full bridge single phase DC-AC inverter with, DC voltage magnitude, Vdc=1000 V. A…

Q: to 3. Using mesh analysis, what is the loop current 13 in the circuit? R15.0 ww 8.0 4.0 4.0 ww O…

A: In this given problem , we need to find the value of current I3

Q: Draw a 3-phase wye-connected generator with transmission lines connected to a 3-phase…

A: In this question we need to draw a 3 phase system having generator, transmission line and load.

Q: = 10t 3. Two open circuits are, respectively, placed in a time-varying magnetic field B mWb/m²…

A:

Q: Q1: Use Superposition theorem to find the voltage VSI 12 V 2k ww -www RL 2k 2k ww 26 Vs: Juv

A:

Q: Consider a series RLC circuit with L = 0.5H, C = 3.0 μF, R = 10.02 is connected to an AC voltage…

A: Given: L = 0.5H, C = 3μF, R=10Ω and V = 10V. Need to calculate the quality factor of series and…

Q: a) Find the Thevenin equivalent resistance b) Find the Thevenin equivalent voltage c) Find the…

A: The thevenin's equivalent circuit can be obtained by calculating the open circuit voltage and…

Q: What percentage of the initial energy stored in the capacitor is dissipated in the 10 ks resistor?…

A: Given an electrical circuit To find the percentage of the initial energy stored in the capacitor is…

Q: 6A(1 + >3Ω >9Ω 0,913 Μ • 15Ω M 6Ω *6Ω + 4A

A:

Q: Question4 A 10nC point charge exists at the origin in free space. a- Find The flux density D and the…

A: Given the point charge at the origin, q=10 nc In a free space  εr=1

Q: Calculation ( please show all work) a) find the minimum sampling rate, if the bandwidth of the…

A: Given information is written below. The bandwidth of the channel is 6 kHz. 4096 quantization levels…

Q: (a) Use Thévenin's theorem to find Vo in the circuit below. 12 V + 21x 1 ΚΩ Μ 1 ΚΩ I www 1 ΚΩ 1 ΚΩ Γ…

A: Given circuit to find V0 using thevenin's theorem

Q: In the figure shown, if t = 0.3 mS, v1 is equivalent to * 0.707 V OV 0.5 V O 1 V H = 200µs/div and…

A: In this question We need to determine the value of voltage V1 (t) at time t= 0.3ms Assume sinusoidal…

Q: Let the impulse response of a system is a delta function. Consider a sinusoidal discrete signal as…

A: In this question we need to find the output of the given system.

Q: f(x) = {x 0 ). Calculate the Fourier Transform of * - 1<x<0 otherwise

A:

Q: Square wave: even or odd function? -5 1 0 -1 5

A: asked to find the given waveform is odd or even.

Q: Solve the following problem in the paper then answer it correctly. GIVEN: REQUIRED: SOLUTION:…

A:

BJT (Bipolar Junction Transistor)

A BJT is a semiconductor device with 3 terminals that consist of a p-n junction diode that can amplify the signal or current. It is a current-controlled device. The three BJT terminals are base, collector, and emitter. The BJT works with the charge carrier, the two type of carriers in the BJT are holes and electrons, the charge carriers flow by the process of recombination. The signal to be amplifier is generally given as the input at the base terminal and an amplified form of it is available at the collector terminal.