Being a meticulous student, suppose you just want to consume the 772- calorie food that you ate during dinner in lifting a 1,865-kg car using the master cylinder of a hydraulic lift. The master cylinder has a diameter of 2-cm and a stroke length of 30.7 cm. The second cylinder has a diameter of 25 cm. By how much vertical distance (in m) does the car ascends? Note that 1 calorie = 4.184 J. Assume that there is no energy loss due to friction and viscosity. Final answer in three decimal places.

Being a meticulous student, suppose you just want to consume the 772- calorie food that you ate during dinner in lifting a 1,865-kg car using the master cylinder of a hydraulic lift. The master cylinder has a diameter of 2-cm and a stroke length of 30.7 cm. The second cylinder has a diameter of 25 cm. By how much vertical distance (in m) does the car ascends? Note that 1 calorie = 4.184 J. Assume that there is no energy loss due to friction and viscosity. Final answer in three decimal places.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A man is standing on a board on a frozen lake where there is no friction between the board and the ice surface. Tha man's mass is 2 m and the boaf's mass is 4 m. The board has length L. He walks from 1/5 Lfrom the left end of the board to 1/5 L from the right end of the board. How far and in which direction does the board move during this process?
A hydraulic cylinder is to compressa car body 10 seconds. The operation requires a stroke of 0.51m and a force of 23 KN . If a 7.5 N/mm2 pump has been attached to it then the power will be ______
Q6: A hydraulic lift is to be used to lift a 2500 kg weight by putting a weight of 25 kg on a piston with a diameter of 10 cm. Determine the diameter of the piston on which the weight is to be placed.
A tank half full of water is accelerated to the right at 9.81 m/s^2. If the motion is laong the side with a length of 4 m, the water surface on the rear wall will: a. rise 2 m b. rise 1.5 m c. drop 2 m d. drop 1.5 m
A 0.5 lbm apple is thrown from the edge of a tall building with an initial speed of 20 m/s. What is the change in kinetic energy of the apple in lbf-ft if it strikes the ground at 9840 ft/min? complete solution.
1. A downward force of 100 N is applied to the small piston with a diameter of 50 cm in the hydraulic lift system shown below.a. What is the upward force exerted by the large piston with a diameter of 2m?b. What is the mechanical advantage of this hydraulic lift?c. If the input force of 100N pushes the small piston down by 2m, how high will the large piston rise? 2. Water flows through a circular pipe with a constant radius of 10cm. The speed and pressure at point A is 4m/s and 250,000Pa respectively.a. What is the speed of the fluid at Point B? b. What is the pressure at point B which is 10m higher than point A?
A pipe of diameter 10cm conveying 200 liters/s of water has bend of angle (θ = 90⁰) and θ = 0⁰ through horizontal plane. Find theresultant force exerted on the bend if the pressure at the inlet and outlet of the bend are 15N/cm2 and 10 N/cm2respectively
If a pump is capable of lifting 5000kg of water through a vertical height of 60m in 15 min, the power of the pump is
A fan when driven by a 5.8 Hp motor at a speed of 800 rpm delivers 510 m3/min at a total pressure of 5 cm water gage. If in the same installation, 6.5 cm water gage pressure is required. What power will the fan be driven?
A reducing elbow is used to deflect water flow at a rate of 95 kg/s in a horizontal pipe upward 45° while accelerating it (Figure below). The elbow discharges water into the atmosphere (ρ= 1000 kg/m3). The crosssectional area of the elbow is 113 cm2 at the inlet and 7 cm2 at the outlet. The elevation difference between the centers of the outlet and the inlet is 30 cm. The weight of the elbow and the water in it is considered to be negligible. Determine(a) the gage pressure at the center of the inlet of the elbow and (b) the anchoring force FRZ needed to hold the elbow in place.
A vertical lock gate is 4 m wide and seperates 20oC water levels of 2 m and X m respectively (ρw=1000 kg/m3). Finda) the forces exerted on the gate by water levels.b) the moment about the bottom required to keep the gate stationary. X=94 m
The container in Figure below is (W= 1.2 m) wide and is filled with crude oil ( ρ oil= 796 Kg/m3)to a height of (x= 3 m) and base length L= 2.15 m), and a crane begins to hoist the container upwards with an acceleration of av= 7 m/s^2 The magnitude of the exerted force on the lateral side of the tank is equal to -----------KN ? 2- The magnitude of the exerted force on the bottom side of the tank is equal to -----------KN ?