Answered: Below, the most intense peaks of x-ray…

Below, the most intense peaks of x-ray diffraction patterns obtained from two samples the same material. What could have caused the differences in the XRD peaks give below? Explain?

University Physics Volume 3

17th Edition

ISBN:9781938168185

Author:William Moebs, Jeff Sanny

Publisher:William Moebs, Jeff Sanny

Chapter4: Diffraction

Section: Chapter Questions

Problem 33P: Consider the single-slit diffraction pattern for =600 nm, D=0.025 mm , and x=2.0 m. Find the...

See similar textbooks

Related questions

Q: An electron beam is mirrored by a pair of slits separated by a distance d. On a screen placed at a…

A: The position of bright fringe is given by yn= nLλ/d And we know, E = hc/λ So, λ = hc/E yn=…

Q: What are the different monochromators used in UV Visible spectrophotometers? For higher sensitivity…

A: Introduction: Structural confirmation of the material, UV-Visible spectrophotometric technique is…

Q: a) by ight? (b) Give a diagram showing clearly how coherent sources are produced in a biprism.…

A: Fresnel Bi-prism: It is an optical device of producing interference of light by joining two bases…

Q: I need help with this problem I got it wrong on my homework and wanted to know how to do it. The…

A: Consider plane wave solution of a photon and write the expression fotr the wavefuntion.

Q: From the figure, approximate the (a) smaller and (b) larger wavelength at which the eye of a…

A: Part A. We need smaller wavelength at which eye has half the maximum sensitivity (50), from given…

Q: A collimated beam of microwaves is incident on a metal screen containing a horizontal slit. long 20…

A: We have givenwidth of slit (d)=20 cm = 0.2 mA detector, placed in the far field region, moves in a…

Q: A beam of light was passed through a diffraction grating with 684 lines/mm, and the pattern was…

A: Given: Number of line on diffraction grating, N = 684 lines/mm Distance between grating and screen…

Q: Below, the most intense peaks of x-ray diffraction patterns obtained from two samples of the same…

A: Required : Reason for the difference in the intensity peaks.

Q: 2. For diffraction to occur, why would you need a very small gap?

Q: Early investigators (including Thomas Young) measured the thickness of wool fibers using…

Q: Write the distinguishing features between a diffraction pattern due to a single slit and the…

A: Diffraction: It refers to the bending of light wave when passed through the corners of an obstacle…

Q: Draw the setup of Young's two-slit experiments (wave versus particle).

A: Young's double slit experiment helps to understand the wave nature of light. The basic requirments…

Q: The diagram below shows a double-slit interference in (a) and car headlights in (b). Would th…

A: For interference light sources must be coherent that is they should emit light waves of the same…

Q: The structure molecules can be confirmed by using X-ray diffraction analysis, which are explained by…

Q: Collimated laser light of wavelength 548 nm is incident on a grating with 1554 lines/mm in the…

A: In this question we are given that a collimated laser light of wavelength 548 nm is incident on a…

Q: X-rays of wavelength 0.158 nm fall on a crystal whose atoms, lying in planes, are spaced 0.200 nm…

Q: Waves of wavelength λ pass through an opening of width w. What relationship between λ and w is…

A: When a wave falls on a barrier with a slit in it, only the points on wavefront comes out of the…

Q: If you add one more slit to a double slit apparatus and beam the same laser on it as you did on the…

A: Here given that the number of slit is increased by one. We have to define what happen.

Q: In a different young's experiment with 488nm light the second dark fringe is 1.2x10-3 (power of)m…

A: The given values with suitable variables are listed below. Here, λ denotes the wavelength, y2…

Q: When the width of the slit is made double, how would this effect the size and intensity of the…

Q: ellow light has a wavelength l = 590 nm. How many of thesewaves would span the 1.35-mm thickness of…

Q: Question: As you increase in wavelength what happens to the width of the fringe patterns? Please…

A: Since You've asked multiple different questions at a time so, as per strict guidelines we will only…

Q: In a two slits experiment, write down the condition for obtaining interference and diffraction…

A: For obtaining interference and diffraction patterns on screen the sources of waves should be…

Q: The first-order diffraction maximum is observed at 13.9° for a crystal having an interplanar spacing…

Q: See the diagram and choices for reference. The questions is, two coherent sources of radio waves…

Q: For an spectrometer lecture of 172 degrees- 30’, what would be the diffraction angle? Select the…

A: As we know that: 1 degree equivalent to 60 minutes: So, 30 minutes equivalent to 30/60 degrees which…

Q: 2. In a different Young's experiment with 488 nm light the second dark fringe is 1.2x 10-3 m away…

A: Young's double slit experiment demonstrates the interference of light. In this experiment, when a…

Q: How does the angular separation of interference fringes change in Young’s experiment, if the…

A: A monochromatic light source is illuminated on the nearly spaced slits in Young’s experiment. The…

Q: First-order Bragg diffraction is observed at 26.0° relative to the crystal surface, with spacing…

Q: The grating in this experiment has a line separation d (size of the gap through which light…

A: Given that grating constant N=300 lines per mm

Q: Demonstrate (with a formula) in the refraction time of the "n" layer refraction wave is faster than…

A: In this question we are have to demonstrate that the refraction time of the "n" layer refraction…

Q: The beautiful colors of a blue morpho butterfly are known to be originated from nanoscale structures…

Q: In a different Young's experiment with 488 nm light the second dark fringe is 1.2x 10-3 m away from…

A: Given: The wavelength of the light is 488 nm. The distance of the second dark fringe is…

Q: Suppose that Young's experiment is performed with light of wavelength 631 nm. The slits are 1.10 mm…

A: Given that λ= 631 ×10-9m d=1.1×10-3m D=3.79 m

Q: Light from a slit passes through a transmission diffraction grating of 400 lines/mm, which is…

A: Given: Number of lines per mm= 400 lines/mm Distance from the screen = 3 m

Q: a = 3 mm A: b00nm Find the angie for the S th dork for of size a singie Slit using 600 wave lenght

Q: The first-order diffraction maximum is observed at 12.6° for a crystal having a spacing between…

A: A crystal has space between planes of atoms is 0.250 nm and first order diffraction maximum is at…

Q: What is the width of a single slit through which 510-nm orange light passes to form a first…

A: For the first diffraction minimum , the relation is d sin θ =λ where, d is the slit width, θ is the…

Q: Following figure shows the positions of the first bright fringes B, and B, on either side of the…

Q: Figure 5 below shows the setup for Young's slits experiment to produce fringes. 1.8 m laser slits…

A: Given:- The center of the fringes is measured to be at = 2.4 mm Find:- a) Explain, in terms of…

Q: The diffraction grating we used in one of the demos was characterized by 528 lines/cm. What is the…

A: The grating has 528 lines/cm. That means in each centimeter it has 528 lines. The line separation…

Q: Suppose that Young's experiment is performed with light of wavelength 457 nm. The slits are 1.78 mm…

Q: If you had a grating that contained fewer lines per meter than another, what differences would you…

A: The spreading out of a wave when it passes through a narrow opening is usually referred to as…

Q: S1 and S2 in the figure below are effective point sources of radiation, excited by the same…

Q: A red light of wavelength ( 664 = 2 nm) was used in Yunk's experiment and the distance between the…

Q: : For the geometry below, assume the carrier frequency is 900 MHz Tx Rx 50 m 50 m 500 m 500 m…

A: in this knife edge diffraction method is used to find height of obstacle.

Q: Red light of wavelength of 635nm is used in a diffraction grating experiment. The first bright…

Concept explainers

Interference of Light

The word "constructive" signifies addition in interference. Constructive interference occurs when the path of the waves that start from the slit differs by 1 entire wavelength or in the intervals of the same. Hence, the waves that are presented on the screen are in phase (crest to crest/trough to trough). The waves interfering constructively forms bright fringes on the screen.

Question

Below, the most intense peaks of x-ray diffraction patterns obtained from two samples
the same material. What could have caused the differences in the XRD peaks give
below? Explain?
A
В
20 (Degrees)
Intensity (arbitrary units)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A diffraction grating with 2000 lines per centimeter is used to measure the wavelengths emitted by a hydrogen gas discharge tube. (a) At what angles will you find the maxima of the two first-order blue lines of wavelengths 410 and 434 nm? (b) The maxima of two other first-order lines are found at 1=0.097 rad and 2=0.132 rad . What are the wavelengths of these lines?
X-rays of wavelength 0.103 nm reflects off a crystal and a second-order maximum is recorded at a Bragg angle of 25.5°. What is the spacing between the scattering planes in this crystal?
As the width of the slit producing a single-slit diffraction pattern is reduced, how will the diffraction pattern produced change?
What is the maximum number of lines per centimeter a diffraction grating can have and produce a complete firstorder spectrum for visible light?
The yellow light from a sodium vapor lamp seems to be of pure wavelength, but it produces two first-order maxima at 36.093° and 36.129° when projected on a 10,000 line per centimeter diffraction grating. What are the two wavelengths to an accuracy of 0.1 nm?
Two slits of width 2 m, each in an opaque material, are separated by a center-to-center distance of 6 m. A monochromatic light of wavelength 450 nm is incident on the double-slit. One finds a combined interference and diffraction pattern on the screen. (a) How many peaks of the interference will be observed in the central maximum of the diffraction pattern? (b) How many peaks of the interference will be observed if the slit width is doubled while keeping the distance between the slits same? (c) How many peaks of interference will be observed if the slits are separated by twice the distance, that is, 12 m, while keeping the widths of the slits same? (d) What will happen in (a) if instead of 450-nm light another light of wavelength 680 nm is used? (e) What is the value of the ratio of the intensity of the central peak to the intensity of the next bright peak in (a)? (f) Does this ratio depend on the wavelength of the light? (g) Does this ratio depend on the width or separation of the slits?
As an example of diffraction by apertures of everyday dimensions, consider a doorway of width 1.0 m. (a) What is the angular position of the first minimum in the diffraction pattern of 600-nm light? (b) Repeat this calculation for a musical note of frequency 440 Hz (A above middle C). Take the speed of sound to be 343 m/s.
Consider the single-slit diffraction pattern for =600 nm, D=0.025 mm , and x=2.0 m. Find the intensity in terms of Io at =0.5 , 1.0°, 1.5°, 3.0°, and 10.0°.
How far apart must two objects be on the moon to be distinguishable by eye if only the diffraction effects of the eye’s pupil limit the resolution? Assume 550 nm for the wavelength of light, the pupil diameter 5.0 mm, and 400,000 km for the distance to the moon.
A grating with 4000 lines per centimeter is used to diffract light that contains all wavelengths between 400 and 650 nm. How wide is the first-order spectrum on a screen 3.0 m from the grating?
Fifty-one narrow slits are equally spaced and separated by 0.10 mm. The slits are illuminated by blue light of wavelength 400 nm. What is angular position of the twenty-fifth secondary maximum? What is its peak intensity in comparison with that of the primary maximum?
Three discrete spectral lines occur at angles of 10.1, 13.7, and 14.8, respectively, in the first-order spectrum of a diffraction grating spectrometer. (a) If the grating has 3 660 slits/cm, what are the wavelengths of the light? (b) At what angles are these lines found in the second-order spectra?