(b)find the α rating  of transistor shown in below Figure 4 determine the value of ic both α and β

Q: The transistor shown in Figure 1 are characterized by Vto = 1 V and K = 4 mA/V?. Find the voltages…

A: We need to find voltage for given circuit.

Q: 2K blue IK R R Sr wr

A: We should the find the value of voltage across resistor ,VR.

Q: Find the minimum Vin required to put the transistor in saturation. Find Vout. Β = 100.

A:

Q: 500 k Ohm 1- Find the VCE and IB. 2- What is the Ic value that will saturate the transistor? (You…

A:

Q: oericדורושורוהע profile in the base is linear (equation 11.44 text) QUESTION 3 What applied VCB…

A:

Q: 2. The three terminals of the BJT are called: a) Larry, Moe, and Curly b) Thing-1, Thing-2, and…

A: BJT (bi polar junction transistor)   BJT have three terminal, name of Three terminal of BJT?

Q: 10. The Si transistor has negligible leakage current and B= 100. If Vcc= 15V, VEE= 4V, RE= 3.3k2 and…

A:

Q: In a transistor....... Ic = lE+IB IE= IC - IB E = IC + IB B = Ic+IE

A: Lets consider the NPN Bipolar junction transistor circuit,

Q: The collector current is 3.08 mA when the base current is 26 mA. What is the alpha of the…

A:

Q: 40HA (Your Roll number) -> Ie Ie: 1imA

A:

Q: 0,317MH IC 549 2202 1,5 v

A:

Q: b läi 5 A transistor has IB = 105 µA and IC = 2.05 mA. Find (a) B of the transistor (b) a of the…

A:

Q: For the circuit in Figure 1, calculate the following with the exact analysis. (Make the solutions…

A:

Q: In a transistor if β = 100 and collector current is 10 mA Find IE: 100 mA 10.1 mA 110 mA

A: The solution is given below

Q: A certain transistor has a PD(max) of 1 W at 25°C. The derating factor is 5 mW/°C. What is the…

A:

Q: esign (Z, = 2 kn), (Z, = 1.8 kn). Assume that the transistor is silicon with, (B = 80) (r. = %3D =…

A:

Q: 4. A meter reads a high resistance when its positive lead is connected to a transistor's base lead,…

A: The solution is provided in the next step.

Q: For the circuit shown below, Assume that |VBE of a conducting transistor is approximately 0.7V and…

A: Given: The given figure is,

Q: Determine all current and voltage values exactly even if any transistor is on. saturation. R1 = 1k…

A:

Q: 2.5 V For the transistors in the circuit shown: ki = 4 mA/V? k2 = 2 mA/V? VTH1 = VTH2 = -0.5 V T1 T2…

A: First we will find out current then voltage then we will verify region of operations.

Q: In the circuit on the left, the specified voltage value has been measured. Find the IC, IB, IE and β…

A: In the BJT circuit  Find the IC, IB, IE and β values of the transistor. Assume | VBE | = 0.7 V

Q: Determine the following in Figure 5–38: (a) Q-point values (b) The minimum power rating of the…

A:

Q: 1) For the circuit in Figure 1, calculate the following with the exact analysis. (Make the solutions…

A: We need to calculate voltage at different point at bjt . We need to do DC analysis.

Q: 2.5 V For the transistors in the circuit shown: k1 = 4 mA/V? k2 = 2 mA/V? VTH1 = VTH2 = -0.5 V T1 T2…

A: First we will find out the current from drain current equation then we will find out voltage for…

Q: Find the time interval for which the transistor in the figure on next page will be in active region…

A: Given the circuit: Given X=22 & Y=7  Given the input voltage: Vp=50 V, Time period, T=2 s We…

Q: The Base current is 15µA and B=147 for an 5. NPN transistor. Calculate emitter current.

A: Fore transistor Emitter current(IE)=collector current (IC)+Base current(IB) IE=Ic+IB relation…

Q: For the FET transistor circuit in Figure 1, a) Determine: i. voltage, VGso ii. current, Ipo iii.…

A: As per company guidelines we can solve only first three sub parts kindly post another parts…

Q: An NPN transistor with ICBO=0.5µA ,ICEO=45 µA and collector current 2mA.  Calculate the value of α,…

A: Right Answer option D. 0.989

Q: In the circuit shown, measurement indicates VB to be +1V and Ve to be +1.7V. What are a O +1OV and ß…

A:

Q: +9 V 2 kM 100 2 80 kM Z D2 R 2 k2 40 kM E 2 kN 100 2

A: When the diodes are in forward biased, β=∞ when the resistor R is not connected  to the circuit and…

Q: if the emmiter current of a transistor is 8 mA and Ib is 1/100 of Ic, determine the levels of Ic and…

A:

Q: Q1: For the circuit shown in figure (1), B=50 for the two transistors. Find the D.C. values of IEI,…

A: By dc analysis we will find out the current t

Q: A transistor has IB = 105 µA and IC = 2.05 mA. Find (a) B of the transistor (b) a of the transistor…

A: So according to the question  Ib =105 uA  Ic = 2.05 mA  We need to find emitter current also beta of…

Q: An NPN transistor with ICBO=0.5µA ,ICEO=45 µA and collector current 2mA.  Calculate the value of…

A:

Q: The collector current is 6.41 mA when the base current is 56 mA. What is the alpha of the…

A: It is given that: IC=6.41 mAIB=56 mA

Q: For proper operation of the transistor, its collector should have Select one: a. Very small size b.…

A: For proper operation of the transistor, it's collector should have........?

Q: In the circuit on the below, the specified voltage value has been measured. Find the IC, IB, IE and…

A: The given is BJT circuit,   Find the IC, IB, IE and β values of the transistor. Assume (| VBE | =…

Q: For each case given below, determine the operating region of the transistor in the circuit given in…

A: The condition to operate transistor in the cut-off region is IB=0 IC=0 Vbe<0.7 V The condition…

Q: Figure 1 shows a voltage-divider biased transistor circuit. If βDC=200, Determine (i) Collector…

A:

Q: (c) A 60 W power transistor is to be cooled by attaching it to a heat sink. Calculate the maximum…

A:

Q: Determine all current and voltage values ​​exactly even if any transistor is on. saturation. R1=7k…

A:

Q: - A base current of 1.25 mA is applied to the transistor in Figure 3 , and a voltage of 6.5 V is…

A: Given circuit is as follows Given data is  base current IB=1.25mA, Voltage across collector…

Q: An NPN transistor with ICBO=0.5µA ,ICEO=45 µA and collector current 2mA.  Calculate the value of α,…

A:

Q: A transistor has a Bpc of 250 and a base current, IB, of 20 u A. The collector current, 50 mA O 5 mA…

A: In this question we will find collector current of transistor with given data...

Q: +V- 20 V For the circuit in Figure 1, calculate the following with the exact analysis. (Make the…

A: The given circuit is a voltage divider biasing method for which given quantities are.  Vcc=20…

Q: For a certain transistor, IC = 5.505 mA, IB = %3D 50 mA, ICO = 5 mA. Determine (i) values of a, ß…

A: Transistor: It is a semiconductor device that is used to amplify or switch a electronic signals and…

Q: Ver Vor 10 V Van 10 V

A:

Q: In a transistor, IC = 100 mA and IE = 100.5 mA. The value of β is    a  100 b  50 c  about 1 d  200

A:

Q: A transistor has Ib = 105 µA and IC = 2.05 mA. Find (a) β of transistor…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: In the circuit on the left, the specified voltage value has been measured. Find the IC, IB, IE and β…

A:

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.