Both batteries in Figure (a) are ideal. Emf 8, of battery 1 has a fixed value, but emf 82 of battery 2 can be varied between 20.0 V and 200.0 V. The plots in Figure (b) give the currents through the two batteries as a function of 82. The vertical scale is set by is = 0.32 A. You must decide which plot corresponds to which battery, but for both plots, a negative current occurs when the direction of the current through the battery is opposite the direction of that battery's emf. What are (a) emf 81, (b) resistance R1, and (c) resistance R2? R 100.0 200.0 Ez (V) (a) (b) (a) Number Units (b) Number Units (c) Number Units

Both batteries in Figure (a) are ideal. Emf 8, of battery 1 has a fixed value, but emf 82 of battery 2 can be varied between 20.0 V and 200.0 V. The plots in Figure (b) give the currents through the two batteries as a function of 82. The vertical scale is set by is = 0.32 A. You must decide which plot corresponds to which battery, but for both plots, a negative current occurs when the direction of the current through the battery is opposite the direction of that battery's emf. What are (a) emf 81, (b) resistance R1, and (c) resistance R2? R 100.0 200.0 Ez (V) (a) (b) (a) Number Units (b) Number Units (c) Number Units

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

The efficiency for incandescent light bulbs is typically about 14 lumens per watt (lm/W) and that for LED bulbs is typically about 90 lm/W. Use Ohm’s law to calculate the total light output in lumens of each type of bulb if the incandescent bulb has resistance of 10 Ω and the LED bulb has resistance of 2 Ω and each are supplied with a current of 2 A. Question 1 options: Incandescent: 230 lm. LED: 360 lm. Incandescent: 7840 lm. LED: 64800 lm. Incandescent: 112 lm. LED: 3600 lm. Incandescent: 560 lm. LED: 720 lm.
A) Find the equivalent resistor of the circle between points a and b?B) If a constant voltage source (15V) is placed between points a and b, calculate a valueCurrent iS
The figure shows a circuit in which the emf voltage e is not known. However, by placing an ammeter at point b, a current of 2 A is measured. Find: a) The currents that pass through each element of the circuit. b) The potential difference V_ab c) The power consumed by the circuit.
A 30-Wp SHS has a charging current of 1.7A at 1000 W/m2 irradiance. When the irradiance is decreased to 800W/m?, how much charging current is expected?
A PMMC instrument has internal resistance of 0.8 kΩ and gives full scale deflection for 33 mA. The required resistance value of multiplier resistors for employing the meter as a multi range voltmeter for voltage range 75 V will be __________________ ohms. a. 226.47 b. -360.00 c. 1472.73 d. 93717.00
A coil of copper wire has resistance of 90 Ω at 20°C and is connected to a 230- V supply. By how much must the voltage be increased in order to maintain the current constant if the temperature of the coil rises to 60°C ? Take the temperature coefficient of resistance of copper as 0.00428 from 0°C.
1) Determine the magnitude of the potential difference, ∆{Vab}, for the circuit in the figure below. Note that each battery has an internal resistance, R1 = 1.80 ohm, R2 = 7.50 ohm, R3 = 2.80 ohm, R4 = 4.90 ohm, R5 = 6.00 ohm, R6 = 3.70 ohm and R7 = 1.30 ohm. Assume that E1 = 16.0 V and E4 = 10.0 V and E6 = 39.0 V, as indicated in the figure. 2) If points a and b are connected by a R8 = 7.10 ohm resistor, what is the magnitude of the current through this resistor?
A coil of copper wire in a resistance of 90 Ω at 20o C and is connected to a 230 V supply. By how much must the voltage be increased in order to maintain the current constant if the temperature of the coil rises to 60C. Take the temperature coefficient of resistance of copper 0 0.00428/ oC A kilometer of wire having a diameter of 11.77 mm and a resistance of 0.031 Ω is drawn down so that its diameter is 5.0 mm. What does its resistance become?
Materials in parallel, supplying a load of 500 amps, with a terminal voltage of 240 volts, and the resistance of the product circuit 0.04 Ohm The resistance of the field circuit is 60 ohms. Calculate a. Product current b. field current c. electromotive force
A rear-window defogger in a car consists of 13 resistive wires connected in parallel to a 12-v battery. Assume that the defogger can melt 2.1 x 10-2 kg of ice at 0C to liquid water at 0C in two minutes. Each wire has a length of 1.30m. What should the resistance/ length of the wires be? Your answer should be in ohms/m.
In the figure the resistances are R1 = 0.97 Ω and R2 = 1.9 Ω, and the ideal batteries have emfs ε1 = 2.1 V, and ε2 = ε3 = 5.3 V. Whatare the (a) size and (b) direction (up or down) of the current in battery 1, the (c) size and (d) direction of the current in battery 2, and the (e) size and (f) direction of the current in battery 3? (g) What is the potential difference Va - Vb?
The resistance of a given device is 46ohms at 25degrees celcius. If the temperature coefficient of resistance of the material is 0.00454 at 20degrees celius, determine the temperature of the device when its resistance is 92ohms.