Brietly explain the process of constructing a pavement using roller-compacted concrete (RCC). What are the advantages and disadvantages of this method of construction?

Q: DRAW ISOMETR VIEW

A:

Q: At what conditions can the contractor appeal for a suspension of work?

A: Explanation- Absolutely, the Contractors may suspend or cancel the Contract with fifteen (15) days'…

Q: 15’K 5K/FT 3 BA 4 + 3'→ 13'

A:

Q: Determine the beam deflection at point H. A

A:

Q: Problem 3 - 112 Would a wooden cylinder (sp. gr. be stable if placed vertically in oil (sp. gr. =…

A:

Q: A hollow circular shaft has an outer diameter of 100 mm and a wall thickness of 25 mm. The allowable…

A:

Q: A plate with width of 400mm and thickness of 12mm is to be connected as shown in the figure. The…

A:

Q: Problem 3 - 103 Freshly poured concrete approximates a fluid with sp. gr. of 2.40. The figure shown…

A: Solution-Considering the following free body diagram of a panel. To  Determine,The force in the…

Q: E P Cable 4 m D В C A -2 m -2 m- 3 m

A:

Q: A hollow circular shaft has an outer diameter of 100 mm and a wall thickness of 25 mm. The allowable…

A:

Q: 60 30 80 30 80 60 220 mm Determine the coordevates of the eentroid ogthe shaded area

A:

Q: Problem 4. Determine the reactions at the supports for the structures Shown. 2225 AN 135.7 22 AN/m…

A: As per our guidelines we are supposed to answer only one question. Kindly repost the other questions…

Q: lations & Drawings QI/ Connect the tangents shown in the fig. with simple circular curve and…

A: Given Intersection angle, I = 50° Degree of curve, D = 2° To Determine L, R T, M

Q: If a bus travelling at 18 m/s is subjected to a steady deceleration of 3 m/s?, how long will it take…

A: Given data : The value of initial velocity U=18 m/s The value of final velocity V=0 m/s The value of…

Q: A railway fill is 12 m wide. The ground is level in a direction transverse to the centerline. The…

A:

Q: Please make your own question about traverse survey and solve it on your own.

A:

Q: Figure Q2 shows the steel C-section, a) Show the centre of gravity of the steel C-section b) Based…

A:

Q: A bed consists of compressible clay of 4 m thickness with pervious sand on top and impervious rock…

A: Please find step by step solution below:

Q: Determine the x-, y-, and z-coordinates of the mass center of the body constructed of uniform…

A: Calculate x and y-coordinates of the mass centre of given body.

Q: Determine the volume V and total surface area A of the solid generated by revolving the area shown…

A: We will find both for each section.

Q: A cylinder weighing 20 pounds slides in a free pipe as shown in the figure. The clearance between…

A:

Q: Question 1 Design a square shape reinforced concrete colunn to withstand the following dead and live…

A: Square Column: This is the most commonly used in the construction of buildings. It is very easy to…

Q: A parabolic curve has the following elements : The tangent grades are -1.8% and +2.2% respectively…

A:

Q: In a circumstances in a private construction where there are any indications that the work done is…

A: Following is required answer :

Q: Draw the LOAD (w) and the BENDING MOMENT (M) diagrams that correspond to the given shear force…

A:

Q: Problem 3 - 101 A vertical semi-circular area of radius r is submerged in a liquid with its diameter…

A:

Q: The intensity of the rain and time interval of a typical storm are Time interval (minutes) Rainfall…

A: Given data:

Q: Load factor17 usomm 4So mM

A:

Q: Find the water content of soil if weight of water is 20 gm and weight of soil solids is 80 gm

A: Introduction : The given question is related with geotechnical engineering . In this question we are…

Q: (in %, up to two decimal places) is outer diameters of 100 mm and 106 mm. respectively. The area…

A: Find area ratio of core cutter,Ar=?

Q: A A remforced rectangul. beam has a wid th of sooma and an effectie depth to battom bars 450mm The…

A:

Q: a. determine the active force, Pa, per unit length of the wall for Rankine’s active state. b.…

A:

Q: 3) An bronze rod is rigidly attached between a aluminum rod and a steel rod as shown. Axial loads…

A:

Q: A vertical rectangular gate 2 m wide and 1.2 m high has water on one side with surface 3 m above its…

A:

Q: (in %, up to two decimal places) is outer diameters of 100 mm and 106 mm. respectively. The area…

A:

Q: Find the value of pressure at dpeth of 12.5 m from free surface of water. Tale density of water 1000…

A: Introduction : The given question is related with fluid mechanics . In this question we are provide…

Q: Q.43 A bend in pipeline conveying water gradually reduces from 30 cm² to 10 cm2 and deflects the…

A: given and required diagram-

Q: Question: Illustrate a compound curve with corresponding labels. Subject: Curves and Earthworks…

A: Types of Curves in Surveying: Curves are generally classified into two types. They are, 1)…

Q: A semi-circular gate is submerged under water as shown. The base of the gate is pin supported and…

A:

Q: 5.00m clay overlain with a 5.00m sand. The sand has a specific gravity of 2.65 and a void ratio of…

A:

Q: ) Use the following log and determine for section 12342-12358ft: eded equations can be found in the…

A:

Q: Determine the x- and y-coordinates of the centroid of the shaded ar ! 3", 3" 4" 1.25" 10" 1.25" 3" B…

A:

Q: What is the importance of concrete compression test in engineering design? Complete explanation,…

A: The question is about Concrete compressive strength test  importance in engineering   so, let's get…

Q: Body A weighs Soolb, B weighs 300lb, and the brake C has negligible werght. The coefficiets of…

A:

Q: A =? P = ? T = ? %3D

A: For the given cross-sections, the area(A), wetted perimeter(P) and the top width(T) are to be…

Q: In the figure shown, the 1.20 m dia. cylinder 1.20 m long is acted upon by %3D water on the left and…

A:

Q: For the beam loaded as shown, determine the beam deflection at point C. Assume that E = 25500 ksi…

A: Intensity of UDL (w) = 3.2 kips/ft Intensity of point load (P) = 36 kips Young's modulus of…

Q: Given: f= 0.02 for all pipes, Determine discharge in each pipe if total head loss is 20m. L1 = 250…

A:

Q: Compute the side slope of the given cross section: а. 2:1 b. 1.5:1 c. 2.5:1 d. 3:1 Cross-section…

A:

Q: Measurement of a line was taken ten times with a steel tape and found to be as under 100.54 m,…

A:

Pavement Management

Pavement management is the process of planning the maintenance and repair of a roadway network or other paved infrastructure to improve road conditions throughout the network. It is also used on runways and airports. Every highway superintendent undertakes walkway management. Traffic management includes the cost of living cycles in a systematic way of repairing minor and major roads and reconstruction projects. The needs of the entire network and budget estimates are considered before the projects are undertaken, as the cost of data collection can change significantly. Pavement management incorporates many of the features and functions required to maintain the quality of the paved material as well as to ensure that the entire road network can sustain itself at the required levels. Although pedestrian management involves the life cycle of commuting from planning to maintenance of any transport infrastructure, road asset management, and road maintenance planning is primarily aimed at road infrastructure.