Answered: By measuring the currents and times and…

By measuring the currents and times and then draw the current vs time graph using the measurement at the lab for ε =8 V, R=1M Ω and C=4.7μF. When is the capasitor charged fully?

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter9: Current And Resistance

Section: Chapter Questions

Problem 46P: An electronic device designed to operate at any temperature in the range from 10.0C to 55.0C...

See similar textbooks

Related questions

Q: A rod of length /=5 m and a square cros sectional area with side length of 1.5 cm is made of…

Q: Problem 9: A capacitor is charged with a total charge of q = 7.2E-05 C. The capacitor is wired in…

A: Given Initial charge qo = 7.2 × 10-5 C R = 13 ohm C =10-6 F Final charge q = qo /2

Q: TA charge of 20C flows out from a battery in 6 seconds and as a result 120 Jor anergy is supplied to…

A: A wire wound resistor is an electrical passive element that limits or restricts current flow in a…

Q: An uncharged capacitor and a resistor are connected in series to a battery. If V=35V, C=6µF, and…

A: Maximum charge = C * V = 6 * 10-6 * 35 = 2.1 * 10-4 CoulombMaximum current = V/R = 35/8 = 4.375…

Q: A microwave is rated at 975 Watts. If it receives 240 Volts of potential difference, a) What is the…

Q: By measuring the currents and times and then draw the current vs time graph using the measurement at…

Q: What is the fractional change in the resistance of an iron filament when its temperature changes…

Q: Write a mathematical relation for E (Stored Energy) in terms C (Capactiance) and V (Voltage)

A: Here we have to Write a mathematical relation for E (Stored Energy) in terms C (Capactiance) and V…

Q: In a typical lightning strike, 2.5 C flows from cloud to ground in 0.20 ms. What is the current…

A: Current in terms of charge

Q: D. - If you have a resistor of colors (red, brown, orange, silver) and it was measured by ohmmeter…

A: Given four Band Resistor Color bands red brown orange and silver Value of resistor 20000 Ohms To…

Q: A silver wire of radius r0.5 mm and resistance 0.06 Q is connected to a voltage source of 1.6 mV.…

A: Solution: radisu r = 0.5 mmresistance R = 0.06 Ohmvoltage V= 1.6 mVcharge density, n =1.59x1028 m-3

Q: Based on your data, what is the resistance of the resistor used in this virtual experiment? In this…

Q: The following graph represents the charge-discharge profile of a Li-ion battery in the 1st and 50th…

Q: What is the current I through the resistor at t= 50 micro seconds, and immediately after the switch…

A: Write the given values with the suitable variables. t1=50 μs=50×10-6 st2=200 μs=200×10-6 sC=4…

Q: By measuring the currents and times and then draw the current vs time graph using the measurement at…

A: Given: Experimental value of, E.m.f, ε=8 V Resistance, R=1M Ω=106 Ω Capacitance, C=1 μF=10-6 F…

Q: By measuring the currents and times and then draw the current vs time graph using the measurement at…

Q: (4%) Problem 4: AAV =1.5 V battery loses E = 5.5 J of energy each day (t 24 hrs) powering a cell…

A: Given: ∆V=1.5 V Energy loss, E=5.5 J Time, t=24 hrs To find (a) write an expression for current.…

Q: e clear and step by step solution A certain waffle iron is carrying 8.33A when connected to a…

A: GivenI=8.33 AV=120 V

Q: y measuring the currents and times and then draw the current vs time graph using the measurement at…

A: THIS is the case of R C circuit ANS I = I0 ( e - t / RC ) I0 = V/ R at t = 0 this time…

Q: What is the electric field of a material when the current is equal to 25A, the resistance is…

A: Write the given value of this problem. Current(I)=25 AResistance(R)=78 ohmCurrent density(J)=24…

Q: A Nichrome heater dissipates 526 W when the applied potential difference is 110 V and the wire…

A: Given: The power loss due to the nichrome heater at 800 oC is 526 W. The potential difference is 110…

Q: A material is inserted between a pair of concentric metallic cylinders of radii a and b where b > a…

A: Resistance is given by:R=ρ×LAwhere ρ is resistivity of the materialL, is the length of the material…

Q: By measuring the currents and times and then draw the current vs time graph using the measurement at…

A: Given that R=1MΩ=10^6Ω C=1*10-6F I0=8*10-6A we have time constant RC=1s using equation…

Q: 30pc In the region / = 30r? är A/m?,p, a) Find I b) Find the velocity and explain its direction. c)…

A: Given in the region j=30r^-2arA/m^2 We have to find the following question's answer

Q: A heater dissipates 1000 W when the applied potential difference is 100 V and the wire temperature…

A: The temperature difference between the heater is, ∆T=TL-TH=200°C-800°C=-600°C The power dissipated…

Q: A 3.5m long wire with a radius of 22.0mm has a resistance of 29.1ohms at 20degreesC. If its…

A: Given data: Length of the wire is, L = 3.5 m The radius of the wire is, r =22 mm= 0.022 m Initial…

Q: By measuring the currents and times and then draw the current vs time graph using the measurement at…

A: ε = 8V R = 1 M Ω = 106 Ω C = 1 μF = 10-6 F I0 = 8 μA = 8 x 10-6 A To find = Current at t= 2.5 s

Q: A coil of Nichrome wire is 25.0 m long. The wire has a diameter of .400 mm and is at 20.0C. If it…

A: a)The equation to find electric field using resistivity and current density is,

Q: A Nichrome heater dissipates 500 W when the applied potential difference is 110 V and the wire…

Q: Starting from the uncharged state, how long does it take for the current to drop from its initial…

Q: By measuring the currents and times and then draw the current vs time graph using the measurement at…

A: SOlution: Given that ε =8 V, R=1M Ω and C=4.7μF. What is the current at t=12 s?

Q: The charge across the area A= 10-4 m2 varies with time according to the relation Q(t) = 4 + 2t + t2…

A: Current is nothing but the flow of charge in time. When a charge is static, it gives rise to an…

Q: A cylindrical resistor of length L, cross section area A and conductivity o is connected to battery…

A: Given: Length= L Cross section area=A Conductivity=σ Voltage=ε Current density=J Current=I

Q: A typjcal lightning jolt may last for 0.197 s and transfer 1.19 x 1040 electrons. Calculate the…

A: Given Information:- The lightning bolt lasts for t=0.197 s Total number electrons transferred by the…

Q: A 500-W heating coil designed to operate from 110 V is made of Nichrome wire 0.500 mm in diameter.…

Q: A silver wire of radius r-0.5 mm and resistance 0.06 2 is connected to a voltage source of 4.2 mV.…

A: The drift speed of the free charge in μms-1.given,resistanceR=0.06 Ωradiusr=0.5 mm=0.5×10-3 mcharge…

Q: A 70 Coulomb charge is flowing to a copper wire whose length is 2500 m and has a cross sectional…

Q: Suppose that we have 2.10 X 10 doubly charged positive ions per cubic centimeter, all moving north…

A: Let's convert the unit into the base SI unit. n=2.10×108 /cm3n=2.10×1014 /m3

Q: If three cells of 1V, 1.5V, 2V are connected in series, then the total e.m.f will be:

A: Given, Three celss are connected in series

Q: 1.00 MQ A conducting sphere is charged by an emf source & through a 1.00 MO resistor. When the…

A: Given, Resistance,R=1 MΩ=106Ω Current,I=1 mA=10-3A Charge on sphere,Q=2μC=2×10-6C

Q: How much energy is imparted to an electron as it flows through a 20 V battery from the positive to…

A: Given: particle = electron charge q =e = 1.6*10-19 C potential V = 20 V

Q: A potential difference of 3.00 µV is set up across a 2.00 cm length of a wire (with resistivity of…

A: Given data: The potential difference is V=3.00 μV. Length of wire is l=2.00 cm. The resistivity of…

Q: A capacitor is charged from the battery with EMF E = 10 V through the resistor R. What energy is…

Q: What is the value of the unknown R if the voltage across the 500Ω resistances is 4 V?

Q: The ratio of the resistivity of Tungsten (W) to the resistivity of Copper (Cu) is pw/pcu~ 3.0. If…

Q: The circuit shown in the figure consists of ideal batteries ɛ =20V and ɛ2 =20V, resistors R =6002,…

A: After solving equation (1) and (2), we will get the value of i1(t) and i2(t). And with the help of…

Question

100%

By measuring the currents and times and then draw the current vs time graph using the measurement at the lab for ε =8 V, R=1M Ω and C=4.7μF. When is the capasitor charged fully?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A lightbulb is connected to a variable power supply. As the potential across the bulb is varied, the resulting current and the filaments temperature are measured. The data are listed in Table P28.38. a. Find R for each entry in Table P28.38, and then plot R as a function of T. b. Assume that room temperature is at 293 K. Find R0 (resistance at room temperature). Comment on your result.
An electronic device designed to operate at any temperature in the range from 10.0C to 55.0C contains pure carbon resistors. By what factor does their resistance increase over this range?
In the figure, does the graph indicate the time constant is shorter for discharging than for charging? Would you expect ionized gas to have low resistance? How would you adjust R to get a longer time between flashes? Would adjusting R affect the discharge time?
By measuring the currents and times and then draw the current vs time graph using the measurementat the lab for ε =8 V, R=1M Ω and C=60μF. What is the current at t=50 s? values obtained after the experiment:I0=8μAApproximate time until current becomes zero= 180 s
In a 2 ns interval, 10^8 electrons are discharged from a capacitor. What is the average current flow, in mA, due to this discharge?
Please help: Pacemakers designed for long-term use commonly employ a lithium-iodide battery capable of supplying 0.42 A•h of charge (A) How many coulombs of charge can such a battery supply? Express your answer using two significant figures (B) If the average current produced by the pacemaker is 5.6 micro Amps, what is the expected lifetime of the device? Express answer using two significant figures
A capacitor with a charge of 5 micro coulombs has its terminals shorted by a metal wire so that the charge flows off within 2 microseconds. The average current flowing during that time is 2.5 mA? a. TRUE b. FALSE
By measuring the currents and times and then draw the current vs time graph using the measurementat the lab for ε =8 V, R=1M Ω and C=1μF. What is the current at t=2.5 s? f values obtained after the experiment:I0=8μAApproximate time until current becomes zero= 5.7 s
A constant current transfers 10*10^14 electrons onto one plate of a capacitor in 3 minutes [min]. (a) What is the current, in units of amperes [A]? Express the answer using an appropriate SI prefix such that there are only 1, 2, or 3 digits shown to the left of the decimal. (b) If the capacitor has a capacitance of microfarads [F], what is the voltage in units of volts [V] across the capacitor?
What is the value of the unknown R if the voltage across the 500 resistances is 4.00 V?
A capacitor with capacitance C = 2.5 μF is charged to a voltage V = 5V. It is then discharged through a resistor R = 100Ω. What is the initial discharge current through the resistor?
Write a mathematical relation for E (Stored Energy) in terms C (Capactiance) and V (Voltage)