By measuring the currents and times and then draw the current vs time graph using the measurement at the lab for ε =8 V, R=1M Ω and C=4.7μF. What is the current at t=12 s? values obtained after the experiment: I0=8μA

By measuring the currents and times and then draw the current vs time graph using the measurement at the lab for ε =8 V, R=1M Ω and C=4.7μF. What is the current at t=12 s? values obtained after the experiment: I0=8μA

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter9: Current And Resistance

Section: Chapter Questions

Problem 24P: A conductor carries a current that is decreasing exponentially with time. The current is modeled as...

See similar textbooks

Related questions

Q: The calibration circuit of the ECG device used to give a 1mV calibration signal to the patient to…

Q: :. Dimensions of the resistance in an electrical circuit in terms of dimension of mass M, length L,…

Q: An electric current in a conductor varies with time according to the expression I(t) = 100 sin…

Q: The amount of charge that passes through a system is given by Q(t), measured in coulombs. Current is…

Q: The resistance of a wire is given by R = Ro[1+ a(T – T.)] where T. - 20 °C, R. = 6 N ± 0.3 % is the…

A: Formula for resistance; Base temperature Resistance at base temperature Temperature coefficient…

Q: By measuring the currents and times and then draw the current vs time graph using the measurement at…

Q: A certain lightbulb has a tungsten filament with a resistance of 22.4 N when at 20.0°C and 143 N…

Q: An electric current in a conductor varies with time according to the expression I(t) = 84 sin…

Q: A cauterized, used to stop bleed in surgery, supplies 1.95 mA at 14 kV. Part (a) what is its power…

A: Given: Current, I=1.95 mA=1.95 x 10-3 A. Voltage, V=14 kV=14x103 kV. Required: Power output and…

Q: An electric current in a conductor varies with time according to the expression I(t) = 94 sin…

A: Given that,An electric current in a conductor varies with time according to the expression I(t) = 94…

Q: Based on your data, what is the resistance of the resistor used in this virtual experiment? In this…

Q: resistor R = 10MΩ is connected in series with a 1µF capacitor and a 12V source. Find the charge of…

Q: By measuring the currents and times and then draw the current vs time graph using the measurement at…

A: Given: Experimental value of, E.m.f, ε=8 V Resistance, R=1M Ω=106 Ω Capacitance, C=1 μF=10-6 F…

Q: By measuring the currents and times and then draw the current vs time graph using the measurement at…

Q: An electric current in a conductor varies with time according to the expression I(t) = 110 sin…

A: I(t)=110sin90πttime, is from 0 to 1/180 sec.

Q: What do you think will happen to a load that was rated at 1.8v, 35mA if it was connected on a 5v…

Q: A capacitor, C'is connected across an emf given by: v(t) = Vo sin(wt) Write an expression for the…

Q: If the instantaneous current drawn from a 50-hz source is –263 mA when t = 0.013 s, what is the…

Q: y measuring the currents and times and then draw the current vs time graph using the measurement at…

A: THIS is the case of R C circuit ANS I = I0 ( e - t / RC ) I0 = V/ R at t = 0 this time…

Q: Determine the time constant T, in units of microseconds, for charging the capacitor.

A: (A) Answer 9.198 (B) Answer 7.015

Q: 20 volts. The slope of the graph In the Potentiometer experiment, let the known emf of the power…

A: A potentiometer is an electric device used to control the EMF and internal resistance of a cell.…

Q: A 225 µH choke coil of negligible resistance is to limit the current through it to 25 mA when 40 V…

Q: By measuring the currents and times and then draw the current vs time graph using the measurement at…

A: Given that R=1MΩ=10^6Ω C=1*10-6F I0=8*10-6A we have time constant RC=1s using equation…

Q: An electric current in a conductor varies with time according to the expression I(t) = 110 sin…

A: Solution:-current in conductor is given by It=110 sin90πtwe have to find total charge…

Q: 3.6 O 106 J, what does it cost to operate a window- type air conditioning for one hour if the unit…

Q: Given a capacitor with capacitance 10.0 ± 0.1 µF and a resistor with resistance 10.0 ± 0.2 MΩ. What…

Q: In Figure, suppose the switch has been closed for a time interval sufficiently long for the…

Q: 1) What was the relative percentage error of your results? jemfexp - emferue x 100% emfirae.…

A: In part (1)and part (2) we don't have the experimental value of emf and the internal resistance.…

Q: Calculate B(0). Draw B (measured values)- n curve for current 1A B(0) (mT) I (mm) R (mm) Measured…

A: All the required data is given . To find = Calculated magnetic field

Q: 3V Calculate the currents with Kirchoff, Mesh and Nodal analysis 902 802 12 :)) 202 60. II. 602

Q: During the Potentiometer experiment, which of the following is true when we find the balance point?…

A: at balance condition The unknown emf is balanced by voltage drop in the resistive wire…

Q: A wire of diameter d, length l and resistivity ρ forms a circular loop. A current enters and leaves…

Q: n electric oven of 2kW power rating is operated in a domestic electric circuit that has a current…

A: Power = 2 kW = 2000 Watts Current = 5 A Voltage = 220V Power = current × voltage

Q: k 34. Translate "The current (x) in a wire varies directly as the potential energy (P) and inversely…

A: solution as

Q: assume that the voltage of the current is given by V = 170 sin (120πt), where t is in seconds. Find…

A: V = 170 sin (120πt) Current= I To find- wattage rating.

Q: The formula for the power output P of a battery is P- VI - RI“, where V is the electromotive force…

A: (1) Given : P = VI -RI2 R = 0.5 ohm V = 10 volts At maximum value of power…

Q: emperature and Current A tungsten wire with resistance R_0, at T_0 = 20◦C, and temperature…

Q: The data shows the voltage reading during charging across the 10-µF capacitor in a circuit with 6-MΩ…

Q: The instantaneous current (I) at time t is given by equation I = (10 + 5) e ^ -t / CRwhen the…

Q: In the Wheatstone bridge experiment shown in 2,2 kn the figure the values of the resistors are R=2.2…

Q: Given the equation, V – Voe-(2.6x10-3)t, at what time will | %3D oe the voltage drop by its original…

A: According to guidelines we need to solve only first question kindly repost other questions in the…

Q: An electric current in a conductor varies with time according to the expression I(t) = 106 sin…

A: Given: The current variation in conductor is I=106sin180πt

Q: aldjob of berloss eviiso natapnu From the figure calculate the effective emf. of the cell WA(E 2V 2V…

Q: The current through a conductor is modeled as I(t) = Im sin (2π[60 Hz]t) . Write an equation for the…

A: We have the equation for current I(t) = Im sin (2π60 Hzt) We need to find out the equation of charge…

Q: In the Power Transfer experiment, which of the following is true? a. The power generated by the…

Q: By measuring the currents and times and then draw the current vs time graph using the measurement at…

Concept explainers

Ohm's law

Ohm’s law is a prominent concept in physics and electronics. It gives the relation between the current and the voltage. It is used to analyze and construct electrical circuits. Ohm's law states that the voltage across a conductor is directly proportional to the current flowing through it.

Path of Least Resistance

In a series of alternate pathways, the direction of least resistance is the actual or metaphorical route that offers the least resistance to forwarding motion by a given individual or body.

Question

By measuring the currents and times and then draw the current vs time graph using the measurement
at the lab for ε =8 V, R=1M Ω and C=4.7μF. What is the current at t=12 s?

values obtained after the experiment:
I0=8μA
Approximate time until current becomes zero= 25 s

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

By measuring the currents and times and then draw the current vs time graph using the measurementat the lab for ε =8 V, R=1M Ω and C=1μF. What is the current at t=2.5 s? f values obtained after the experiment:I0=8μAApproximate time until current becomes zero= 5.7 s
An electric current in a conductor varies with time according to the expression I(t) = 94 sin (180?t), where I is in amperes and t is in seconds. What is the total charge passing a given point in the conductor from t = 0 to t = 1/240 s?
By measuring the currents and times and then draw the current vs time graph using the measurement at the lab for ε =8 V, R=1M Ω and C=60μF. What is the current at t=50 s?
The formula for the power output P of a battery is P=VI−RI2P=VI−RI2, where V is the electromotive force in volts, R is the resistance in ohms, and I is the current in amperes. Find the current that corresponds to a maximum value of P in a battery for which V = 12 volts and R = 0.8 ohm. Assume that a 10-ampere fuse bounds the output in the interval 0≤I≤100≤I≤15
When an electric current is maintained in an electrolytic cell of slightly acidic water and 1 mole of water is electrolyzed in to hydrogen and oxygen, two faradays of charge are transferred through a source of emf (E). The energy change of the system is +286500 J and 50,000 J of heat is absorbed. Calculate the emf (E) ? Given 1 Faraday = 96500 C/mol.?
The charge on a capacitor in a circuit is modeled as Q(t) = Qmax cos (ωt + ϕ). What is the current through the circuit as a function of time?
A capacitor with square plates, each with an area of 34.0 cm2 and plate separation d = 2.64 mm, is being charged by a 215-mA current. (a) What is the change in the electric flux between the plates as a function of time? (Use the following as necessary: t. Do not use other variables, substitute numeric values. Assume that dΦE/dt is in V · m/s and t is in seconds. Do not include units in your answer. Enter the magnitude.) dΦE dt = (b) What is the magnitude of the displacement current between the capacitor's plates?
The current through a conductor is modeled as I(t) = Im sin (2π[60 Hz]t) . Write an equation for the charge as a function of time.
What is the current in the element of an electric clothes dryer with a resistance of 7.4 Ω when it is connected to 240 V? Express your answer to two significant figures and include the appropriate units. I= How much charge passes through the element in 50 min? (Assume direct current.) Express your answer to two significant figures and include the appropriate units. Q=
While conducting the voltage divider experiment a student measures V1 = 0.97 V and V2 = 3.13 V. The current through the potentiometer is observed to be 78 mA. What is the resistance of length l2, Remember to work in SI units.
assume that the voltage of the current is given by V = 170 sin (120πt), where t is in seconds. Find thewattage ratingmaximum wattageV2of each electric device ifthe current flowing through the device is I amps.A quarterback throws a ball with an initial velocity of v, feet per second at an angle 0 with the horizontal. The horizontal distance x in feet that the ball is thrown is modelled by a equation x=vo/16sin theta cos theta.for a fixed vo.find the angle that produces the maximum distance x.
The voltage V (volts), current I (amperes), andresistance R (ohms) of an electric circuitare related by the equation V = IR. Suppose that V is increasing atthe rate of 1 volt/sec while I is decreasing at the rate of 1/3 amp/sec. Let t denote time in seconds. What is the value of dV/dt?