C₁ = [0.05P2 + 20P₂ + 30]; $ hr C₂ = [0.056P2 + 15P₂ +40]; hr Here P₁ and P₂ are in MW. Each generated is rated for 210 MW and load is 400 MW. Determine (i) the values of P₁ and P₂ when the load sharing is most economic and (ii) increase in operation cost for generator 1 when load is shared equally.

C₁ = [0.05P2 + 20P₂ + 30]; $ hr C₂ = [0.056P2 + 15P₂ +40]; hr Here P₁ and P₂ are in MW. Each generated is rated for 210 MW and load is 400 MW. Determine (i) the values of P₁ and P₂ when the load sharing is most economic and (ii) increase in operation cost for generator 1 when load is shared equally.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter12: Power System Controls

Section: Chapter Questions

Problem 12.10P

See similar textbooks

Similar questions

A single-phase, 120V(rms),60Hz source supplies power to a series R-L circuit consisting of R=10 and L=40mH. (a) Determine the power factor of the circuit and state whether it is lagging or leading. (b) Determine the real and reactive power absorbed by the load. (c) Calculate the peak magnetic energy Wint stored in the inductor by using the expression Wint=L(Irms)2 and check whether the reactive power Q=Wint is satisfied. (Note: The instantaneous magnetic energy storage fluctuates between zero and the peak energy. This energy must be sent twice each cycle to the load from the source by means of reactive power flows.)
Suppose two generators supplying a load. Generator-1 has a no-load frequency of 61.5 Hz and a slopesp1 of 1 MW/Hz. Generator-2 has a no-load frequency of 62 Hz and a slope sp2 of 1MW/Hz. The twogenerators are supplying a real load totaling 2.5 MW at 0.8 PF lagging. Draw the resulting systempower-frequency or house-diagrams. Determine (a) at what frequency is the system operating, andhow much power is supplied by each of the generators? (b) if an additional 0.75-MW load wereattached to this power system. What would the new system frequency be, and how much powerwould the each generator supply now? (c) with the system in the configuration described in part (b),what will the system frequency and generators power be if the governor set points on generator-1 areincreased by 0.5 Hz?
If the generator cost function of three generators are given as: F1 = 484.8 + 7.67P1 + 0.5P12 (OMR/h/MW) F2 = 465.9 + 8.07P2 + 0.2P22 (OMR/h/MW) F3 = 478.9 + 7.76P3 + 0.62P32 (OMR/h/MW) Find the optimal dispatch of the three generators. Total load demand is 1740 MW. Lambda() Answer for part 1 Power P1 Answer and unit for part 2 PowerP2 Answer and unit for part 3 Power P3 Answer and unit for part 4
A440V,22.5-hp,50Hz,3-phase,4-pole,star-connectedinductionmotorhasthefollowing impedances in ohms per phase referred to the stator circuit:R1 = 0.55Ω R2 = 0.35ΩX1 = 1.105Ω X2 = 0.456Ω XM = 27.1ΩThe total rotational losses are 1105 W and are assumed to be constant. The core loss is lumped in with the rotational losses. For a rotor slip of 2.3% at the rated voltage and rated frequency, calculate:d) Electrical power, e) Output power,f) Efficiency.
A440V,22.5-hp,50Hz,3-phase,4-pole,star-connectedinductionmotorhasthefollowing impedances in ohms per phase referred to the stator circuit:R1 = 0.55Ω R2 = 0.35ΩX1 = 1.105Ω X2 = 0.456Ω XM = 27.1ΩThe total rotational losses are 1105 W and are assumed to be constant. The core loss is lumped in with the rotational losses. For a rotor slip of 2.3% at the rated voltage and rated frequency, calculate:g) The shaft torque of the motor at rated load
The yearly load duration curve of a certain power station can be approximated as a straight line; the maximum and minimum loads being 40 MW and 10 MW respectively. To meet this load, three turbine generator units, two rated at 20 MW each and one at 10 MW are installed. Draw the load duration curve and determine: (i) Installed capacity (ii) Plant capacity factor (iii) kWh output per year (iv) Load factor.
A polyphase system is generated by______? a.Both a and c b.Having two or more generator windings separated by equal electrical angle c.Having generator windings at equal distances d.None of these
Define derating, why must a 60Hz generator be derated if it is to be operated at 50Hz? Find percentage of derating done. (4) A generator connected with an infinite bus bar, the frequency indicator shows that frequency is decreasing from 50Hz. What action you will take for restoration of frequency. (2) A generator is loaded with certain load, and its voltage regulation is very poor. What are various ways by which you can improve its regulation? (2)
L-type equivalent circuit and parameters for a continuous sinusoidal phase of a 5.5 kW, 1450 rpm, line voltage 220 V and frequency 50 Hz star-connected 3-phase ASM, ignoring core (iron) losses given as follows: R1=0.21 Ohm, R2=0.18 Ohm, X1=X2=0.66 Ohm and Xm=9.9 Ohm How many times the rated current will the inrush current be when the ASM is started directly?
L-type equivalent circuit and parameters for a continuous sinusoidal phase of a 5.5 kW, 1450 rpm, line voltage 220 V and frequency 50 Hz star-connected 3-phase ASM, ignoring core (iron) losses given as follows: R1=0.21 Ohm, R2=0.18 Ohm, X1=X2=0.66 Ohm and Xm=9.9 Ohm How many times the inrush current will be the rated current when the ASM is started directly?
A generator of 50 MVA, 4kV, Xd" = 25% and transformer of 50 MVA, 4 2 kV, delta/115 kV wye grounded, operating on 3.8 kV tap where XT" = 10% are to be connected into single equivalent reactance. What is the single equivalent reactance on a 100 MVA, 110 kV base? A. j0.6039 pu B. j0.6667 pu C. j0.8241 pu D. j0.8663 pu The answer for this is letter C based in my reviewer but I dont know the solution. Please send me solution for this
A 3 phase, wye-connected salient-pole generator has on per phase basis Xd = 2 ohms, Xq = 1.5 ohms and R∅ = 0. When delivering its maximum power output to an infinite bus bar, the terminal and excitation voltages/phase are 1,430 V and 1,495 V, respectively. Find the power angle in electrical degrees at the above conditions