C1 (i). Three Identical capacitors are connected in delta to 420 Volts, F = 50 Hz, 3 phase supply. If the line current is 14 A. Calculate its reactance and capacitance value. [3 marks) Reactance Xc is The capacitance of each capacitor, C

C1 (i). Three Identical capacitors are connected in delta to 420 Volts, F = 50 Hz, 3 phase supply. If the line current is 14 A. Calculate its reactance and capacitance value. [3 marks) Reactance Xc is The capacitance of each capacitor, C

Electrical Transformers and Rotating Machines

4th Edition

ISBN:9781305494817

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter3: Inductance In Alternating-current Circuits

Section: Chapter Questions

Problem 6RQ

See similar textbooks

Related questions

Q: A coil of resistance 52 and inductance 120 mH in series with a 100 µF capacitor, is connected to 300…

A: Now, the below figure shows the circuit diagram of the given data :

Q: Find trequencies arnd mode shapes of the thso 9/ian systems, assuming m=z ton/m hz 3m lest lant (b)…

A: (a) as per our guidelines. I am giving the answer of 1st question. if you want to know the solution…

Q: DC motor is a class of rotary electrical machines that converts direct current elec echanical…

A: GivenJa=5kg.m2Da=3N-ms/radJL=700kg.m2Dl=800N-ms/radN1=290N2=580kTRa=10Kb=1

Q: Musical Instruments: A man wants to learn to play guitar. He finds a model he likes for $559. He…

A: When a string's end is fixed, the string's displacement at that end must be zero. A transverse wave…

Q: Investigate the complex potential function f(z) = U∞ z +m ln [(z + a)/(z-a)] and interpret the fl ow…

A: The complex potential function is, Here, the above expression is very similar to the velocity…

Q: Resonance occurs when o is equal to.

A: Given: Equation of motion for a spring-mass system excited by a harmonic force is: M=F cosωtwhere,…

Q: What is the value of a sinusoidal voltage at 7 us (micro second) from the positive going zero…

A: Solution:

Q: Water at 10°C stands in a clean glass tube of 2 mm diameter at a height of 35 mm. What is the true…

A: GIVEN DATA- Diameter of tube d=2mm Height h=35mm Specific weight =9804 N/m3 Surface tension=0.0742…

Q: what is unit impulse response?

A: Impulsive excitations are considered to be a large magnitude force that acts over a very short time…

Q: Damped natural frequency is not valid for an underdamped response. True False

A: "TRUE" Damped natural frequency is not valid for an underdamped response.

Q: Define Variable separable

A: A differential equation in which the variables can be simply segregated on each side and the…

Q: A 3-phase, 50 Hz, 3000 V motor develops 600 H.P. (447·6 kW), the power factor being 0·75 lagging and…

Q: Problem 6.2 a.) Determine the relative phase relationship of the two waves v,(t) = 10 cos(377t –…

Q: C2 (ii). A sinusoidal waveform is displayed on a C.R.O. screen, the time/cm switch is on 50 µs/cm…

Q: A resistance of 2002 is connected in series with inductance of 318.3 mH capacitor, is connected to a…

A: As per the Bartleby answering guidelines we are supposed to answer first three subparts of the…

Q: C2 (ii). A sinusoidal waveform is displayed on a C.R.O. screen, the time/cm switch is on 20 µs/cm…

Q: A single phase motor of 210 V, its circuit shown below, calculate motor slip, forward torque and…

Q: In a star connected system, the three phase currents are mutually displaced by

A: Given :- In a star connected system, the three phase currents are mutually displaced by

Q: A transistor has a DC Beta of 250 and a base current, IB, of 20 microA. Th collector current, IC,…

A: Given Base current, IB = 20 microA Beta = 250 Find Collector current, IC

Q: Problem 2: Given this network of capacitors: C2 C1 4 uF 1 uF C3 3 uf C4 2 uf C5 2 uf Assuming the…

Q: Determine the two natural frequencies and mode shapes of thể two-mass syst

A: Given: To determine: Natural frequency mode shape

Q: The harmonic excitation means that there is external force with any form. Select one: O True False

A: Given:

Q: Given mass1=10kg Jo=20kg-m2 mass2=15kg, a is half of b. The rocker is 30 centimeters long. k1=10N/m,…

Q: Q/1/ Given w = 500 rad/sec. Determine the time in seconds for sinusoidal Waveform to pass through an…

Q: The following circuit is known as a peak detector. When a time-varying signal Vin is applied at the…

Q: 2-Calculate characteristic length, (m); L̟ =V/ Biot number Bi =".L k :Fourier number ; diffusivity a…

A: Solution The characteristic length of the wall LC=VAS=t2×w2t×w=t2 where t =…

Q: Given the following Resistances and Inductors in Series and Voltage Source: R1 = 1,664 ohms R2 =…

A: Expression of the impedance when two resistance and two inductance in series z=R1+R2+iω(L1+L2) Let's…

Q: 34. Four 10 mH inductors are in series. The total inductance is (a) 40,000 µH (b) 40 mH (с) 30 Н (d)…

A: Option (b) is correct. 40 mH

Q: What is the amplitude of the output signal at steady state (in mV)?

Q: If f(x) = x² + cos(x) is a periodic function with period 2W, then a. It is an odd function which…

A: To find :- Correct option

Q: Write the SI units of natural frequency.

Q: amplitude of waveform Q. Opeak to peak value of waveform P, ) frequency of waveform P and :) phase…

Q: Suppose I wanted to make a 100 TeV synchrotron for protons. Estimate the minimum diameter of such a…

A: Suppose I wanted to make a 100 TeV synchrotron for protons. Estimate the minimum diameter of such a…

Q: 2- A uniform plane wave of angular frequency w = 5x10® propagates in a lossless medium with…

A: Given that wave of angular frequency w = 5 x 10°rad sec propagates in a lossless medium with…

Q: The input voltage to a full-wave rectifier employing a center-tapped step- down transformer and two…

A: This question is related to the full-wave rectifier. As we know, the full-wave rectifier converts…

Q: m1 and m2 = 26kg 2nd natural frequency = 30rad/s find k

A: Solution: Given Data: m1=m2=26 kgω2=30 rad/s To Find: k

Q: 6. Referring to Figure 5, given that the peak current Ip = 5 mA. i. Briefly explain the terms:…

Q: A thermionic generator with a cathode work function of 2.2 V and an anode work function of 1.6 V…

Q: An armature has a resistance of 0.2 Ω at 150°C and the armature Cu loss is to be limited to 600…

A: Given data: Resistance R1 = 0.2 Ω Find :- T1 = 150oC…

Q: Ex: Consider copper as a = 5.8 x 107 S/m, u = 4 x 10- H/m. Solution: the phase velocity in a good…

Question

C1 (i). Three Identical capacitors are connected in delta to 420 Volts, F = 50 Hz, 3 phase supply. If the line
current is 14 A. Calculate its reactance and capacitance value. [3 marks]
Reactance Xc is
The capacitance of each capacitor, C

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Types of Phase Diagrams and Its Applications in Metallurgy

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Three Identical capacitors are connected in star to 430 Volts, F = 50 Hz, 3 phase supply. If the line current is 16 A. Calculate its reactance and capacitance value. Reactance Xc is? The capacitance of each capacitor, C?
Define Denavit-Hartenberg (DH) parameters (DH-parameters table).
In the P branch of the rotational-vibrational spectrum the first possible transition starts from V=0, J=0. Select one: True False
A flexible string 1.0 m long is connected to an oscillator. When the oscillator is set to vibrate the string at 100Hz, a standing wave is formed in the fundamental mode of oscillation. What is the speed of waves on the string?
Define natural frequency.
10/. A capacitor of 1 μF is connected to a 50 Hz supply. The capacitive reactance (Xc) is ___________. 1591.54 Ω 3183.09 Ω 3.141 Ω 6.283 Ω
Investigate the complex potential function f(z) = U∞ z +m ln [(z + a)/(z-a)] and interpret the fl ow pattern.
An armature has a resistance of 0.2 Ω at 150°C and the armature Cu loss is to be limited to 600 wattswith a temperature rise of 55°C. If α0 for Cu is 0.0043/°C, what is the maximum current that can bepassed through the armature ?
what is the critical point termperature of water is a. 0.01 0C b. 373 0K c. 373 0C d. 647.15 0C
An inductor has an inductive reactance of 250 Ω when connected to a 60-Hz line. What will be the inductive reactance if the inductor is connected to a 400-Hz line?
In last week's assignment, you calculated mean free path, total absorption, and reverberation time for a room that is 4 m long, 7 m wide, and has a ceiling height of 3 m. The floor is hardwood, = .15 at 500 Hz. The walls are gypsum wallboard (GWB), = .30 at 500 Hz. The ceiling is acoustic ceiling tile (ACT), = .95 at 500 Hz. 1) What is the room constant for this room?