C4 AV C3 C2 C5 In the circuit above Cq=3nF, C2=7nF, C3=9nF, C4=12NF, C5=16nF, the battery emf = 17V. Find the energy stored on C3., when al capacitors are fully charged. State your answer in nJ (nanoJoules) to the nearest nJ. In addition to entering your final numerical answer into the box, solve this problem in detail on paper. Make sure that you write your solution neatly, starting with the clear diagram and all variables on it.

C4 AV C3 C2 C5 In the circuit above Cq=3nF, C2=7nF, C3=9nF, C4=12NF, C5=16nF, the battery emf = 17V. Find the energy stored on C3., when al capacitors are fully charged. State your answer in nJ (nanoJoules) to the nearest nJ. In addition to entering your final numerical answer into the box, solve this problem in detail on paper. Make sure that you write your solution neatly, starting with the clear diagram and all variables on it.

College Physics

10th Edition

ISBN:9781285737027

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter17: Current And Resistance

Section: Chapter Questions

Problem 40P: A typical cell phone consumes an average of about 1.00 W of electrical power and operates on 3.80 V....

See similar textbooks

Similar questions

network of capacitors: Assuming the dialect of each is air and the network is connected to Vab=30V supply, calculate the equivalent capacitance between a and b?
Using the exact exponential treatment, find how much time is required to discharge a 268-µF capacitor through a 498-Ω resistor down to 1.00% of its original voltage?____ s
Calculate the voltage Vi and the current Ii for the following two cases where the resistance is R1,2,3,=8, 2, and 3 Ω, Vo=82 V
Given a 10 uF capacitor and a 14 uF capacitor, what are all of the equivalentcapacitances that you can create by connecting them together?Now for each configuration that you have above, imagine that you connect 12V across the full circuit. What is the energy for the 10 uF and 14 uF capacitor in each configuration that you determined above?
Find the total capacitance of the combination of capacitors in microfarads. C = ______
In the circuit shown in the figure, the S switch closed at t=0 and the capacitors, which are completely empty, begin to fill. Here ε=10 V, C=5 μF and R=55 Ω. What is the time constant of the circuit, τ, in units of microseconds? When t= τ, what is the total charge, in units of microcoulomb, accumulated in the capacitors?
Considering the circuit below, determine the equivalent capacitance of the capacitors
Note: Need an answer in number 2 1. Three capacitors with individual capacitances of 2 μF, 5 μF, and 10 μF respectively are connected in series with a 12V battery. What are the total capacitance and total charge in the network? 2. Same capacitors in number 1 connected in the parallel. If the combined charged in the network is 50 μC, what are the total voltage and total capacitance in the network?
Imagine that two parallel plates are charged to achieve a voltage difference Vo between the plates. They have area A and spacing d. The plates are then electrically isolated so that no charge can be added or taken away. A good conductor of thickness d/2 is placed in between the two plates, as shown. How about the electrical stored energy, using the formula U = (1/2) QV? What was it before, and what is it now?
An electrical circuit contains a capacitor of Z picofarads and a resistor of X ohms. If the capacitor is fully charged, and then the voltage is interrupted, in how much time will about 95% of its charge be transferred to the resistor? Show your calculations.
in the curcuit shown in the figure , the S switch is closed at t = 0 and the capacitors, which are completely empty, begin to fill. Here E = 20 V , C = 4uF and R = 30 ohm. a) what is the time constant of the circuit , T in units of microseconds? b)when t=T , what is the total charge , in units of microcloumb accumulated in the capacitors ?
(Indicates a review question, which means it requires only a basic understanding of the material to answer. Questions without this designation typically require integrating or extending the concepts presented thus far.) . Six resistors, all having the same temperatures and compositions, are each attached to a battery with voltage V to form a simple circuit. The resistors have different lengths, l, but the same diameters. Rank the circuits according to the current that flows through the resistor from smallest to greatest. If two (or more) circuits have the same current flowing, give them the same ranking. Explain the rationale you used to establish your rankings. Circuit 1: l = 2 cm; V = 3 V Circuit 2: l = 2 cm; V = 6 V Circuit 3: l = 1 cm; V = 3 V Circuit 4: l = 1 cm; V = 6 V Circuit 5: l = 3cm; V = 2 V Circuit 6: l = 3cm; V = 6 V