Calculate the absolute pressure when a submarine is at a depth of 500 m in the ocean. Assumed that the density of seawater is about 1024 kg/m3and the surface above the ocean is at atmospheric pressure.

Calculate the absolute pressure when a submarine is at a depth of 500 m in the ocean. Assumed that the density of seawater is about 1024 kg/m3and the surface above the ocean is at atmospheric pressure.

Name: Calculate the absolute pressure when a submarine is at a depth of 500
Uploaded: 2022-11-23T13:49:28.000Z
Channel: Bartleby
Description: Calculate the absolute pressure when a submarine is at a depth of 500 m in the ocean. Assumed that the density of seawater is about 1024 kg/m3and the surface above the ocean is at atmospheric pressure.

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter14: Fluid Mechanics

Section: Chapter Questions

Problem 35CQ: Water pressure inside a hose nozzle can be less than atmospheric pressure due to the Bernoulli...

See similar textbooks

Similar questions

A submarine is stranded on the bottom of the ocean with its hatch 25.0 m below surface. Calculate force needed to open the hatch from the inside, given it is circular and 0.450 m in diameter. Air pressure inside the submarine is 1.00 atm.
The greatest ocean depths on Earth are found in the Marianas Trench near the Philippines. Calculate the pressure due to ocean at bottom of this trench, given its depth is 11.0 km and assuming density of seawater is constant all way down.
What must be the contact area between a suction cup (completely evacuated) and a ceiling if the cup is to support the weight of an 80.0-kg student?
What fraction of ice is submerged when it floats in freshwater, given the density of water 0°C is very close to 1000 kg/m3?
Why does atmospheric pressure decrease more rapidly than linearly with altitude?
How tall must be to measure blood pressure as high as 300 mm Hg?
An oil gusher shoots crude 25.0 m the through a pipe with a 0.100-m diameter. Neglecting resistance but not resistance of the pipe, and assuming laminar flow, calculate pressure at be entrance of be 50.0-m-Iong vertical pipe. Take of the oil to be 900 kg/m3 and its viscosity to be 100(N/m2) s (or 1.00 Pa s). Note that you must take into account the pressure due to 50.0-m column of oil in pipe.
(a) Verify that a 19.0% decrease in laminar flow through a tube is caused by a 5.00% decrease in radius, assuming that all other factors remain constant. (b) What increase in flow is obtained from a 5.00% increase in radius, again assuming all other factors remain constant?
Why is it difficult to swim under water in the Great Salt Lake?
Logs sometimes float vertically a lake because one end has become water-logged and denser than the other. What is the average density of a uniform-diameter log that floats with 20.0% of its length above water?
A man has a mass of 80 kg and a density of 955kg/m3 (excluding the air in his lungs). (a) Calculate his volume. (b) Find the buoyant force air exerts on him. (c) What the ratio of the buoyant force to his weight?
A horizontal pipe 10.0 cm in diameter has a smooth reduction to a pipe 5.00 cm in diameter. If the pressure of the water in the larger pipe is 8.00 104 Pa and the pressure in the smaller pipe is 6.00 104 Pa, at what rate does water flow through the pipes?