Answered: Calculate the AQI and give a…

Calculate the AQI and give a description of air that contains 5 ppm CO (8-hour average), 300 pg/m3 PM-10 {24-hour average), and 0.10 ppm SO2 (24-hour average).

Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)

5th Edition

ISBN:9781305084766

Author:Saeed Moaveni

Publisher:Saeed Moaveni

Chapter11: Temperature And Temperature- Related Variables In Engineering

Section: Chapter Questions

Problem 10P: Calculate the thermal resistance due to convection for the following situations: a. warm water with...

See similar textbooks

Related questions

Q: Sanitary Engineering laboratory the test " Relative Humidity of Air" discuss

Q: 10 psig H 2 3 Te Free jet 1 in. dia. 3 ft 2 in. dia.

A: It is asked to find out the velocity at point 2 from the given information in the figure.

Q: Find the dew point temperature for the following air/water vapor mixture for 85°F dry bulb and 50%…

A: Given data- Current temperatue(T)=85oFRelative Humidity(RH)=50% To Find- The dew point temperature.

Q: 2. At 1:00 pm, a thermometer reading 90°F is taken outside where the air temperature is 15°F. At…

A: Given data, Room temperature T0 = 90oF Outside temperature Ts = 15oF

Q: A room is to be maintained at 25°C dry bulb temperature and 55% relative humidity under the…

A: Given data, Dry bulb temparature=25oC Relative humidity=55% Sensible heat=5100W Laten heat=3400W…

Q: List three characteristics of the atmospheric conditions that affect evaporation of the body

A: Evaporation is the process of conversion of liquid into gaseos state. It takes place due to rise in…

Q: 12. If an air/water vapour mixture starts at 30% relative humidity, and you add more water vapour to…

A: For questions 12, 13 In both the cases, If we keep temparature and moisture constant by changing…

Q: A room is to be maintained at 25°C dry bulb temperature and 55% relative humidity under the…

A: Given that, dry bulb temparature=25oC sensible heat=5100 W latent heat=3400 W RELATIVE HUMIDITY=55%…

Q: An incompressible air is flowing at a velocity of 60 mph through a duct 4 sq. ft. in cross-section.…

A: Given, Velocity in duct (V) = 60 mph or 88 ft/s Area of duct = 4 ft2 Pressure difference (∆P) = 8 in…

Q: Suppose the ambient atmospheric temp profile of an area is given by the following equation: ɼ (°C) =…

A: The variation coeffecient is a statistical indicator of the data points' relative dispersion. Mostly…

Q: The air in a certain room 150’ x 50’ x 12’ tested 0.2% CO2. Fresh air containing 0.05% CO2 was then…

Q: 3. At 2:00P.M, a thermometer reading is 80°F is taken outside where the air temperature is 20°F. At…

Q: MAXIMUM AVAILABLE CONCENTRATION (MAC) CO2 FOR AIR OF RESIDENTIAL AND PUBLIC BUILDINGS 1. 0,5 2. 0,1…

A: There are different categories of the buildings in civil engineering. These buildings are having…

Q: Provide a reasonable design for a 99,4% efficient ESP treating 30,000 m3/mm of gas, The dust has a…

A: The given data is shown below: Efficiency=99.4 %Discharge=30,000 m3/minResistivity=7.1×1010 ohm-cm

Q: What is passive cooling of buildings? explain various passive cooling technologies with the help…

A: Passive cooling of building: Passive cooling can be an alternative cooling system of the building…

Q: Calculate the fan power if the average pressure drop m 0.6 in, H2O, and the fan/motor efficiency is…

A: The given data is shown below: Pressure drop=0.6 in. H2OFan efficiency=70%Discharge=800,000…

Q: Heat power loss from a district heating line with two separate pipes: How big is the loss in W / m?…

Q: The dry bulb temperature and relative humidity for the conditions (WBT=12.6 and specific volume=0.85…

A: Given data, Wet Bulb Temperature= 12.6 C Specific Volume = 0.85 m3/kg of dry air We have to find the…

Q: For a particular location, the average net radiation is 185 W/m2, air temperature is 28.5 deg C,…

Q: If the air temperature on the ground is 25˚C, and the dry adiabatic lapse rate is 10˚C, and the…

Q: In the thermal dose formulation for cumulative effective minutes at 43°C (i.e., CEM43), calculate…

Q: Q6: Consider a 3 bedroom apartment with 3 roommates. The apartment has a volume of 11,742 m^3 with 3…

Q: A jet of water issuing from a nozzle at 80 kph. Neglecting air resistance, how high could the jet of…

A: Given data, Speed of water jet = 80 kph = (80×5/18) = 22.22 m/s Height of water jet to rise = H

Q: Determine the required FRP duct diameter assuming a duct velocity (Uduct) of 2,000 ft/min, and an…

A: Given: The duct velocity is 2000 ft/min. The actual air emission rate is 15300 ft3/min.

Q: For an air-conditioning system, the outdoor and indoor design dry bulb temperatures are 45°C and…

A: The given values are as followsThe room dimension is 30×20×5Density(ρ)=1.2kg/m3The specific…

Q: Free jet 1 in. dia. 2) 3 ft 10 psig 2 in. dia. to

Q: A steel tape is 30 meters long at 20 degree Celsius with a pull of 60 N. A rectangular lot is…

Q: If the air quality standard for CO is given as 9.0 ppmv, express this standard as percent by volume…

A: Solution: We know that, 1 ppmv=1 part of pollutant106 parts of…

Q: 8- If air content and degree of saturation are represented as ac and S respectivery then the…

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: The moisture removed from a material is 250 lb/hr and change of humidity ratio in dryer is 0.0175.…

A: To determine the fan capacity for a given dryer. Given, Change in humidity ratio = 0.0175 Rate of…

Q: 10 psig H to Free jet 1 in. dia. 3 ft 2 in. dia. *.?=In fig. V2 25.9 ft/s O 35.9 ft/s 15.9 ft/s

Q: 1 Which of the following produces pure water day and night? a. Passive solar water still b.…

A: The process of cleaning water is depending on the removal of the dirt, and the pathogenics in the…

Q: Compute the average velocity

Q: Air at 30 deg. Celsius and 110KPA flows at 20N/s through a rectangular duct that measures 160mm x…

A: Given:Temperature of air, T=30o CPressure of air, P=110 kPaF=20 N/ssize of duct, A=160 mm×320 mmgas…

Q: What is the pH of a solution made by dissolving 3.71 grams of calcium fluoride in enough water to…

A: Given Data: The mass of the calcium fluoride is M=3.71 g. The volume of resulting solution is V=450…

Q: 7. What is the default value of specific heat ratio in pipelines? a) 1 b) 1.2 c) 1.4 d) 2

Q: 2. At 2:00 PM, a thermometer reading 80°F is taken outside where the air temperature is 20°F. At…

Q: Air flows from a 10 cm pipe in which the temperature and pressure are 4-C and 280 kPa, respectively,…

Q: Q5: Imagine that you do not want the CO2 concentration to exceed 766 ppm. What is the minimum…

A: Cin=Cout+GNKQ Cin= 766 ppm Cout= 400 ppm G= 0.005 N= 4 people K=1000000

Q: If the air pressure at 18°C is 102.6kPa abs, determine the specific humidity of the air. Air Density…

A: According to given data

Q: Q2- Estimate the temperature of dry air at elevat sea level if the temperature on the ground 30 Cº ?

Q: Residential annual energy use. For a house with: Air exchange rate of 0.5 h−1 Cp = 1000 J/kg.K…

A: Given data- Air exchange rate of 0.5 h−1 Cp = 1000 J/kg.K Density of air = 1.2 kg/m3 Roof area = 144…

Q: 2. Consider a "tight" 300 m³ home with o.2 ach infiltration rate. The only source of CO in the home…

A: Considering a tight 300 m3 home with 0.2 ach infiltration rate. The source strength of oven…

Q: A rectangular lot was measured using a 50-m steel tape at 30 oC. If the recorded length and width of…

Q: Which statement is TRUE about displaceme ventilation in UFAD systems? air from the floor is prone to…

A: In UFAD, mixing is enhanced resulting in even air temperature.

Q: Q3: Calculate the steady-state CO2 concentration of a single family home with 3 bedrooms, 3 people,…

A: Cin=Cout+GNKQ

Question

Calculate the AQI and give a description of air that contains 5
ppm CO (8-hour average), 300 pg/m³ PM-10 {24-hour average), and
0.10 ppm SO² (24-hour average).

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

The 1-hour National Ambient Air Quality Standard for nitrogen dioxide (NO2) is 0.10 ppmv. Calculate the corresponding concentration in mg/m3 at a temperature of 25°C? show all work
If a 136.51 g Al rod (c=0.900 J/g°C) is at 100.0°C and placed into 250.0 g of water at 21.8°C, what is the temperature of the system (rod+water) at equilibrium assuming no losses to the surrounding?
1. Determine if what type of ventilation to be use (negative or positive pressure) 2. Determine the required air change per hour (ACH) at each room using the fomula ACH = 60(CFM)/VOL CFM = CUBIC FEET PER MINUTE OR FAN CAPACITY VOL = SPACE VOLUME A = FLOOR AREA H = CEILING HEIGHT
4.2. What is the normal range of the air relative humidity for residential premises? Choose the correct answer:1. 20-40%;2. 20-50%;3. 30-60%;4. 35-70%;5. 40-80%;
If the air temperature on the ground is 25˚C, and the dry adiabatic lapse rate is 10˚C, and the environmental lapse rate is 5˚C. Give the temperature of the atmosphere after 1 km above the ground
Air at 30 deg. Celsius and 110KPa flows at 20N/s through a rectangular duct that measures 160mm x 320mm. Compute the average velocity (m/s) and flow rate (? ^3/s) using gas constant equal to 289 J/kg-K.
If the air quality standard for CO is given as 9.0 ppmv, express this standard as percent by volume and in mg/m3 at 1 atm and 25 °C
If the atmosphere in the afternoon during a humid period is at 90°F and 80% relativehumidity (barometer reads 738 mmHg) while at night (fully saturated) it is at 68°F(barometer reads 745 mmHg), what percent of the water in the afternoon air is depositedas dew. (Assume 100lb of afternoon air) 4 decimal places
Q3: Calculate the steady-state CO2 concentration of a single family home with 3 bedrooms, 3 people, a total area of 114m^2. Assume an outdoor concentration of CO2 of 400 ppm and that each of the house’s occupants produce .005 L/s of CO2/person. Assume 100% outside air with no recirculating. Assume that the ventilation rate is 23 L/s. Report your answer in ppm and round to the nearest integer.
1. In undisturbed air stream, where the pressure is 14.7 psi and density is 101325Pa, where the velocity is 500 ft/sec. What are the density, temperature, speed of sound, and specific weight where the velocity is 590ft/sec? g=9.8066 m/s^2
Determine the required FRP duct diameter assuming a duct velocity (Uduct) of 2,000 ft/min, and an actual air emission rate (Qa) of 15,300 acfm.
1)When designing forced hot water heating system for a residential building, which of the following mass flow rate values is acceptable for stainless steel pipe's diameter of 40 mm. (Given that water density= 983 kg/m3) Select one: a. 3 kg/s b. 1 kg/s c. 2 kg/s 2)When designing forced hydronic heating system, which of the following pressure drop values is recommended for equivalent length of 60 m : Select one: a. 50 kPa b. 30 kPa c. 20 kPa