Calculate the current " I " to give air-gap flux of 20 mwb

Q: Compared between three_ phase induction generator and synchronous them at impedance field and EMF…

A: The three phase Synchronous generator and induction generators are used for different application…

Q: List the reasons why the modulation is desired in a wireless communication system considering the…

A: Modulation is a technique that is used in carrier wave to transmit some information at low…

Q: Q-2. A. A lighting load of 2000 kW and a motor load of 4000 kW at a p.f. 0.8 lagging are supplied by…

A:

Q: If the initial content of a 3-bit ripple down counter is 000. After the first clock trigger, the…

A:

Q: Example 3.8: ELECTRIC Consider the circuit in Fig. 16.12(a). Find the value of the voltage across…

A: For the above given question we need to calculate the value of capacitor voltage. With reference to…

Q: Ques2: For the periodic signals, find the coefficients of trigonometric Fourier series. -π/4 th TT/4…

A: Types of signals Even Symmetric signals Odd symmetric signals Skew symmetric signals.......based on…

Q: . Answer whether each of the following questions is (True) or (False)? Write the true answer if it…

A: Phasor diagrams consists of RMS value of quantity and angle.

Q: Q.3 The bode plot of the open-loop transfer function G(s) of a unity negative feedback system is…

A: The bode plot of the open-loop transfer function G(s) of a unity negative feedback system is…

Q: An npn transistor circuit as shown in figure below has a = 0.985 and VBE= 0.3V. If Vcc=16V,…

A:

Q: H.W : Find the Parallel Realization for. ; Z² H(Z) (2-1) (2-0.5)

A: For the above given question we need to perform the parallel realization of the given transfer…

Q: connection of C1=0.2F, C2=0.3F and L=0.10H. It is connected to a supply voltage (Vi). Find the…

A:

Q: Use rules of block diagram reduction to determine the closed loop transfer function:(see the…

A: By using Rule of block diagram reduction determine the closed loop transfer function: Options are:…

Q: . Determine the Fourier series of full wave rectified signal whose amplitude is Vm and period is π

A:

Q: 4. A coil whose resistance is 10 ohms and inductance of 50mH is connecte in parallel with a series…

A: According to the given data, equivalent circuit is shown below. At resonance, the circuit should be…

Q: Determine I in a circuit shown in figure 2.

A: this problem can be solved by using nodal analysis. In the nodal analysis we use KCL and ohm's law…

Q: Q1: For the J-K flip-flop, determine the Q output for the inputs in figure below Assume that Q…

A:

Q: A) Three conductors of a 3-phase line are arranged at the corners of a triangle of sides 2m, 2.5 m…

A:

Q: If the surface-leakage current is 2 nA for a reverse voltage of 25 V, what is the surface leakage…

A: Given: Surface-leakage current, I=2 nA,Reverse voltage, V=25 V

Q: State the equations of the following voltages (V₁ & V₂) shown in fig. (1) in time domain and in…

A:

Q: The code to be run is called a and it is entered into a file that is called a module, script…

A: The code to be run is called ... It is entered into a file that is called a ...

Q: Exercise #4 - MOSFET Bias The following circuit is used to bias an NMOS type MOSFET transistor. In…

A:

Q: Design the fixed bias circuit from the load line given in the figure below. Ic sat. =10mA IB=60UA…

A: We need to find out the value of Rc and RB for fixed bias circuit .

Q: unctions

A:

Q: 14. 1+1=0 is an example of a logical — A. OR B. NAND C. NOT D. NOR statement.e 8 form is

A:

Q: In a 4-bit magnitude comparator with first input A= 1101 and second input B=1110, the output

A:

Q: 8. Two edge-triggered J-K flip-flops are shown in Figure 7-77. If the inputs are as shown, draw the…

A: Given: Two edge-triggered J-K flip-flops are shown in the figure below: To find: If the inputs are…

Q: Q5) A linear variable differential sensor gives the movement signal shown in Figure 2. If the sensor…

A: Here both opamps are in inverting configuration which means output is exactly 180° phase shift to…

Q: 4. What are the advantages of FM? 15. What are the drawbacks of slope detector? 8. How FM wave can…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: A 3300/230 V, 50-kVA, transformer is found to have impedance of 4% and a Cu loss of 1.8% at…

A: Given data, A 3300/230 V, 50-kVA transformer  percentage impedance = 4% and Cu loss =  1.8% at…

Q: Calculate the skin depth (in microns) for bronze ( = frequency f= 100 MHz $) a S.) m 107 S at a

A: Given data, For bronze Conductivity, σ=107 S/m Frequency, f=100 MHz

Q: Determine the y parameters for the two-port shown in Fig. 19.17. 2i 1. 89 www www 452 www 252

A:

Q: rd = 40 kn. Good Luck ad Jassim Figure (5) + V₁ H 40 MS2 10 ΜΩ www H 930V 3.3 ΚΩ www HE VGS(Th) = 3…

A:

Q: In the transverse electromagnetic TEM mode....... ********** Ez = 0, Hz #0 Ez #0, Hz = 0 Ez = 0,…

A: We need to select correct option for TEM mode .

Q: / Construct 4-to-16 live decoder with 2-to-41 a line decoders with enable.

A: We need to design 4 to 16 decoder by using of 2 to 4 decoders .

Q: A group of 4 adjacent minterms in a Karnaugh map reduces variables from the product term 4 O 2 O 1 O…

A:

Q: Vols) Vols) = 3 How? 5485+18 3 3 [S²+ 2.4.5+ 47+2 (5+2)³ +2

A: It is given that: Vos=3s2+8s+18

Q: E5.18 A system is shown in Figure E5.18(a). The response to a unit step, when K=1, is shown in…

A: The given system is shown below:  The transfer function of the above system is,…

Q: 1. A real load of ZL = 100 is attached to 50 2 line, insert a matching circuit of two- section using…

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: * If X= (1100101)excess-3 X=(65) decimal O X=(110000) gray O X=(101)octal

A: If X= (1100101)excess-3

Q: delivered to each of the three elements. W R=6Q V1 (t)=50 sin (wt+30) XL=90

A:

Q: The progressive phase shift k=180, the direction of the main beam Bo for a uniform linear array with…

A:

Q: A decoder with 4-bit input signal has outputs 4 O 16 O 1 O none of the mentioned O 20

A:

Q: If a 10-bit ring counter has an initial state 1101000000, what is the state after the second clock…

A: We need to find out output for ring counter after two clock cycle

Q: Q5:-An electron [pc-620 keV and Eo-511 keV]. Find the phase and group velocities of its de Broglic I…

A:

Q: Define: 1)self-regulating 2)non-self-regulating

A: A self-regulating control is a system that compares a measured value of a process to a desired set…

Q: We have two small electric lamps on which it is written 8V, 1W. We have a 20V battery and negligible…

A: To solve above problem, we must know Ohm’s law and Kirchhoff’s law: Ohm's law state that in a…

Q: We need a three-stage time-space-time switch with N = 100. We use 10 TSIs at the first and third…

A: Given a three-stage time-space-time switch with, N =100 No of TSIs at the first stage= 10 No of TSIs…

Q: 4. In smith chart, moving in the clockwise direction means moving. a) From load to generator b) From…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: 16. The following serial data are applied to the flip-flop through the AND gates as indicated in…

A:

Q: Using superposition theorem find the output voltage Vo for the circuit below. All resistances in…

A: Given circuit :

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.