For the circuit shown in Figure B2, when the switch opened at t=0 sec,ヒ-ロ120V =3.3KN10 mHFigure B2Calculate the following:i.Current through inductor.ii.Voltage across inductor and resistor.

Given, R=3.3 K ohm L=10 mH Current through the circuit when the switch is closed…

Answered: Calculate the following: i. Current…

Science

Physics

Calculate the following: i. Current through inductor. ii. Voltage across inductor and resistor.

Physics for Scientists and Engineers, Technology Update (No access codes included)

9th Edition

ISBN:9781305116399

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter32: Inductance

Section: Chapter Questions

Problem 32.19P

See similar textbooks

Related questions

Q: A co-efficient coupling of 0.58 linked the two inductors with a mutual inductance of 25 uH. What is…

A: Coupling factor is given by : k = M/√L1L2 Where M = Mutual inductance L1= inductance of one…

Q: 6. When a camera uses a flash, a fully charged capacitor discharges through an inductor. Inwhat time…

Q: When a camera uses a flash, a fully charged capacitor discharges through an inductor. In what time…

Q: 30.55 An L-C circuit consists of a 60-mH inductor and a 250-microFarad capacitor. The initial…

A: Since there are multiple subparts, we will answer the first three subparts.

Q: Older radios used an inductor with a fixed value and a variable capacitor to tune into a particular…

A: WKSU radio station frequency,

Q: Problem 23.63 An engineer proposes to store 80 kJ of energy by flowing 1.2 kA of current through a…

A: Given : U = 80 kJ = 80 × 103 J I = 1.2 kA = 1.2 × 103 A r = 1.2 m n = 3 turns/m

Q: How much energy is stored is M mH inductor with N amp current. Calculate the power if you consume…

A: Given: The inductance (L) of the inductor is M mH. The current through the inductor is N A. The…

Q: 8. The inductor shown in the Figure 8 has inductance 0.260 H and carries a current in the direction…

A: The given Inductance of the Inductor is L = 0.26H and L = magnetic flux per unit current Now if the…

Q: When a voltage V is applied to a series circuit consisting of a resistor R and an inductor L, the…

Q: 4. An inductor of inductance 0.45 H has a current in the direction shown of 2.0 Amperes. This…

Q: voltage equal to the emf

Q: 10) In the figure, the current in a solenoid having no appreciable resistance is flowing from b to a…

Q: 22. A simple RL circuit includes a 0.125-H inductor. If the circuit is to have a characteristic time…

Q: 30.55 An L-C circuit consists of a 60-mH inductor and a 250-microFarad capacitor. The initial…

A: The given values are,

Q: In the circuit, the capacitor is fully charged when switch S is closed. Calculate the time needed…

Q: Suppose there is a steady current in an inductor. If you attempt to reduce the current to zero…

A: The current voltage relationship for an inductor is given by the following equation. Here, L is the…

Q: A series circuit contains a 4.70-H inductor, a 3.50-0 resistor, anda 7.00-V battery. The current is…

A: Given, inductor L = 4.70 H Resistor R = 3.50 Ohm's Voltage V = 7 V t = 0

Q: Explain the parallel and series form of Inductors?

A: InductanceL is defined as the tendency of the conductor to oppose the change in the electric current…

Q: What is its inductance?

Q: When the current through a large inductor is interrupted with a switch, an arc appears across the…

A: In an inductor an induced emf is produced when current flows through it due to mutual inductance.

Q: A-At time t = 0 the charge on the capacitor in the circuit of (figure 3) is 1 coulomb, while the…

A: For capacitorq=Qe-t/RCFor inductori=E/R(1-e-Rt/L)

Q: When the current in the RL circuit of Figure 14.12 (b) reaches its final value ɛ/R,E/R, what is the…

A: The current in the RL circuit is given as It=εR1-e-tτ…

Q: A7.00 µF capacitor is connected to a 12.5 mH inductor as shown in the circuit above. What happens to…

A: A circuit containing both an inductor (L) and a capacitor (C) can oscillate without a source of emf…

Q: 5. Determine the current as a function of time for the following circuit: (20 pt) E=10 volt and is…

Q: An inductor (L = 20 mH), a resistor (R = 100 and a battery (E = 10 V) are connected in series. Find…

A: The inductance of the inductor is L=20 mH The resistance of the resistor is R=100Ω The voltage of…

Q: the R-L circuit shown below, is the current in the resistor always the same as the current in the…

A: The expression for the current (i) in the resistor in the RL circuit is, i=εRsinωt Here, ε is the…

Q: 85. The emf induced in an 80-mH inductor is -0.72 V when the current through th inductor increases…

Q: M=4 N=3 How much energy is stored is M mH inductor with N amp current. Calculate the power if you…

A: Given Inductance ( L ) = 4mH = 0.004H Current ( I ) = 3A

Q: Ohm's law if applied to two coils in series treats the equivalent inductance the same way as a. none…

A: Equivalent Inductance in series combination is given by Leq = L1 + L2+......+Ln

Q: Which of the following represents the variation of current and inductance of inductor? D O a. A O b.…

Q: A series RLCcircuit consists of a 75 Ω resistor, a 0.19 H inductor, and a 25 μFcapacitor. It is…

A: Resistance, R = 75 Ω Inductance , L = 0.19 H Capacitance , C = 25 μF Frequency , f = 60 Hz VRMS =…

Q: In Fig. 6, after switch S is closed at time t = 0, the emf of the source is automatically adjusted…

A: Let i be the current drawn from the constant current source, i1 be the current in the resistor and…

Q: i Calculate the inductance of the solenoid. i. Calculate the rate of change of the current dI/dt…

Q: Continued question An R = 220-Ω resistor, an L = 1.95-mH inductor, and a V = 10.5-V source are…

A: (e) The current reaches the particular time is, It=I01-1e The current across the RL circuit is,…

Q: 7. The 4.50 A current through a 7.10 mH inductor is switched off in 9.50 ms. What is the emf…

Q: Camera flashes charge a capacitor to high voltage by switching the current through an inductor on…

A: Current , I = 0.1 A Self-inductance , L = 3.00 mH = 3 x 10-3 h Emf , E = 500 V To find = Time

Q: Pesky DC current! Suppose you place a 90 V battery in series with a 0.000077 F capacitor. You keep…

Q: 3. Calculate: a. VG b. Voa c. Vor 1. 0.50 If o = 1000 rad/sec %3D Calculate: V = 120 volt a. The…

Concept explainers

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention. 

Question

For the circuit shown in Figure B2, when the switch opened at t=0 sec,
ヒ-ロ
120V =
3.3KN
10 mH
Figure B2
Calculate the following:
i.
Current through inductor.
ii.
Voltage across inductor and resistor.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Your RL circuit has a characteristic time constant of 20.0 ns, and a resistance of 5.00 M (a) What is the inductance of the circuit? (b) What resistance would give you a 1.00 ns time constant, perhaps needed for quick response in an oscilloscope?
When the switch in Figure P32.18 is closed, the current takes 3.00 ms to reach 98.0% of its final value. If R = 10.0 , what is the inductance?
Two coils are placed near each other as shown in Figure OQ31.9. The coil on the left is connected to a battery and a switch, and the coil on the right is connected to a resistor. What is the direction of the cur- rent in the resistor (i) at an instant immediately after the switch is thrown closed, (ii) after the switch has been closed for several seconds, and (iii) at an instant after the switch has then been thrown open? Choose each answer from the possibilities (a) left, (b) right, or (c) the current is zero.
One application of an RL circuit is the generation of lime-varying high voltage from a low-volt age source as shown in Figure P32.82. (a) What is the current in the circuit a long time after the switch has been in position a? (b) Now the switch is thrown quickly from a to b. Compute the initial voltage across each resistor and across the inductor. (c) How much time elapses before the voltage across the inductor drops to 12.0 Y?
A 20.0 kHz, 16.0 V source connected to an inductor produces a 2.00 A current. What is the inductance?
When the current through a large inductor is interrupted with a switch, an are appears across the open terminals of the switch. Explain.
After the switch is dosed in the LC circuit shown in Figure CQ32.8, the charge on the capacitor is sometimes zero, but at such instants the current in the circuit is not zero. How is this behavior possible? Figure CQ32.8 Conceptual Question 8 and Problems 52, 54, and. 15.
(a) What is the characteristic time constant of a 25.0 mH inductor that has a resistance of 4.00 ? (b) If it is connected to a 12.0 V battery, what is the current after 12.5 ms?
Unreasonable Results A 25.0 H inductor has 100 A of current turned off in 1.00 ms. (a) What voltage is induced to oppose this? (b) What is unreasonable about this result? (c) Which assumption or premise is responsible?
A large research solenoid has a self-inductance of 25.0 H. (a) What induced emf opposes shutting it off when 100 A of current through it is switched off in 80.0 ms? (b) How much energy is stored in the inductor at full current? (c) At what rate in waits must energy be dissipated to switch the current off in 80.0 ms? (d) In View of the answer to the last part, is it surprising that shutting it down this quickly is difficult?
Two rectangular loops of wire lie in the same plane as shown in Figure OQ31.11. If the current I in the outer loop is counterclockwise and increases with time, what is true of the current induced in the inner loop? More than one statement may be correct, (a) It is zero, (b) It is clockwise, (c) It is counterclockwise, (d) Its magnitude depends on the dimensions of the loops, (e) Its direction depends on the dimensions of the loops.
(a) Using the exact exponential treatment, find the time required for the current through a 2.00 H inductor in series with a 0.500 (resistor to be reduced to 0.100% of its original value. (b) Compare your answer to the approximate treatment using integral numbers of . (c) Discuss how signi?cant the difference is.