Calculate the indicated currents and voltages. R₂ 8 ΚΩ R₁ Μ 4 ΚΩ R3 12 ΚΩ RA 24 ΚΩ R5 Μ 12 ΚΩ + EΞ 12V Is the R6 Μ 12 ΚΩ V₁ + 9 ΚΩ Ro Μ 6 ΚΩ 3 ΚΩ Rs

Q: A 50 MVA, 11 kV three-phase alternator was subjected to different types of faults. The fault…

A: A 50 MVA , 11 KV 3 - phase alternator was subjected to different types of faults the faults current…

Q: USEFUL FORMULA 44 AVE

A: FIND: Forward resistance of given graph

Q: A continuous signal x(t) is 2 seconds long. The first second of the signal contains music while the…

A: SOLUTION GIVEN-->                 x(t) is 2 sec long.…

Q: 1004 60Hz 2 ½ loke RL = |k M louF calculate Va VAK = 0 VGK=0 IH = 0

A:

Q: The resistance of a conductor 1 mm² in cross-section and 20 m long is 0.346 2. Determine the…

A:

Q: The circuit shown in figure is in series resonance at frequency fc Hz. The value of Vc in volts is…

A:

Q: To design a counter which count in the following sequence 0,1,3,5,7 by * using T-F.F, the input of…

A: The required counter can be designed by using the State transition table and the simplified Boolean…

Q: In the circuit the voltage v₂ is 12 V V1 Select one: 692 www a. 8 v b. -8 v c. -1.6 V d. 1.6 v i 8 V…

A: Given circuit,

Q: (d) Let {Xo, X₁,..., Xn-1} be a finite realization of a time series with fast fourier transform…

A: Given: Time domain sequence, x(n) as {x0, x1, x2, ...........xN-1}  having FFT X(wk) as {X(w0),…

Q: tell whether the signal is: x (t) = e²t cos(t) poriadia . . energy signal or power signal

A: Given: xt=e2tcost

Q: Q5: An output pulse of 3 ms duration is to be generated by a 74LS122 one-shot. Using a capacitor of…

A: Given data Pulse width = 3 msec Capacitor =50000 pF we have to find external resistance value = Rext…

Q: Consider the circuit shown in Figure4. B-120 i. Find Re such that VCEQ 2.2 V ii. Determine the…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: For a particular depletion mode NMOS device, Vt = -2V, kn W/L = 200 µA/V2 and λ = 0.02V-1. For VDS =…

A: Given that Depletion mode NMOS device Vt=-2 VKnWL=200μA λ=0.02 V-1VDS=2V Calculate the drain…

Q: For the below frequency distribution table calculate all the below reequipments. Frequency 46 -10…

A:

Q: In a series R–L circuit the p.d. across the resistance R is 12V and the p.d. across the inductance L…

A:

Q: In a 3-phase, 4-wire, 400/230 V system, a lamp of 200 watts is connected to one phase and neutral…

A: We have a 3-phase 3-wire system in which 2 lamps are connected between 2 phase and neutral . We have…

Q: Please explain this question properly A capacitor has a reactance of 40 when operated on a 50 Hz…

A:

Q: Given the electric flux density, D= 0.3 r2 arnC/m2 in free space: a) find E at point P(r=2, θ=25, Φ=…

A:

Q: 47 In the circuit of fig. find current ; through 10 resistor using Thevenins theorem 2.2 ww JA 322…

A:

Q: Which bulb operates on lowest power?   A) Night bulb B) Torch bulb C) Neon bulb D) GLS bulb

A: Bulb:- Bulbs provide light from the electricity by passing a current through the thin wire which is…

Q: 12. In FIGURE 7.2.9, two vertices are shown of a rectangular paral- lelepiped having sides parallel…

A:

Q: A person's toe displacement is measured by video analysis during running. The raw coordinates are…

A:

Q: For the output frequency of 120 Hz, the period of the half-wave signal is :approximately 1- 4 ms…

A:

Q: Distinguish between ‘Analog and Digital signals’.

A: Analog signals A continuous signal called an analog signal substitute one time-varying quantity for…

Q: In a Y-connected ac generator, each phase voltage has a magnitude of 135 VRMS, then the magnitude of…

A: Given: A Y-connected ac generator has, Phase voltage, Vph=135 V.

Q: FM, TV, and mobile phone antennas are elevated to achieve an unobstructed line of sight. Why ?

A: The method of communication differs according to the applications of a signal and also the frequency…

Q: EX : find below Sol: the nd the F. I. of the perizal Cn=- = 1 + sin(n++) * It T₁ = 2, I=1 _n=o ⇒ C₁…

A:

Q: Calculate the current taken by a 23µF capacitor when connected to a 240V, 50 Hz supply

A: Given that Capacitance = 23µF Voltage = 240V Frequency = 50 Hz We have to find calculate the current…

Q: The differential equation for the current i(t) in the circuit of the figure is i(t) ΖΩ 2 H mm sint 1…

A: Given- R= 2 Ω,L=2 H, C=1 F. To Find- It is needed to find the differential equation for the current…

Q: SOP stands for sum of products and that are canonical SOP and resultant SOP. POS stands for Product…

A:

Q: When the peak output voltage is 5 V, the PIV for each diode in a center tapped full-wave practical…

A: Given the peak output voltage is  V0=5 V To find: The PIV for each diode.

Q: A three-phase motor is connected to a three-phase source with a line voltage of 440V. If the motor…

A: Given data, Total power P=55 KW=55000 W Line voltage VL=440 V Power factor cosϕ=0.73

Q: B)- For the following microwave circuit, find the S-matrix assuming that all ports are matched. ML 2

A: In above given microwave circuit, two circulators are given. Clockwise (LH) circulator and counter…

Q: 1. Choose the right option for the following. ... villy 1. If a DC voltage is applied to a DC motor,…

A:

Q: The circuit shown in figure is in series resonance at frequency fc Hz. The value of Vc in volts is…

A:

Q: Let R₁ = 42 02, R₂ = 16 02, Z₁j26, and Zc = -j37 in the circuit shown in Figure 9.28. If Vo =…

A:

Q: The circuit shown below uses 3 Zener diodes, then Vout will be equal to Vin = +50v + I RI ДА…

A:

Q: Q5. Find the voltage between A and B in a voltage divider network shown in Fig. 100 V 1 ΚΩ 5 ΚΩ 4 ΚΩ…

A: Given data, Circuit diagram is given as,

Q: polar

A:

Q: 16. Determine a scalar c so that the given vectors are orthogonal. (b) a = (c, ½, c), b = (−3, 4, c)

A:

Q: A 100μF capacitor will have 100 reactance at f= Select one: O a. O Hz b. 100 Hz c. 1000 Hz d. 15.9…

A: Given, Capacitance of capacitor, C=100 μF. Capacitive reactance, XC=100 Ω.

Q: Vs R1 = 2 ohms Find Vs R1 www + V1 - R2= 33 ohms + V21 1 www R2 V2 = 50V

A: Given circuit, Where, R1=2 Ω.R2=33 Ω.V2=50 V.

Q: Question 5 Not yet answered Marked out of 1.00 P Flag question Calculate the means and standard…

A:

Q: Calculate the junction capacitance of a silicon pn junction at T = 300 K with doping concentrations…

A:

Q: Q5: An output pulse of 3 ms duration is to be generated by a 741S122 one-shot. Using a capacitor of…

A:

Q: 2. Why do we need to have an Exciter in a complete set-up of an Alternator system operations?…

A:

Q: Example 4.5. A generating station has an installed capacity of 50,000 kW and delivers 220 × 10 units…

A: We have generating station which has,   Installed capacity = 50,000 KW Units delivers/Annum = 220 *…

Q: Ⓒ which of the following signals are periodic I Find the period of the periodic ones: (a) x[n] = 2…

A: To find the period signals and it's period

Q: The silicon transistor in the figure below is biased using the collector feedback bias method, so RB…

A:

Q: When the rms output voltage of a bridge full-wave ideal diode rectifier is 5 V, the peak inverse…

A:

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.