Answered: Calculate the peak output voltage of a…

Calculate the peak output voltage of a simple generatorwhose square armature windings are 6.60 cm on a side;the armature contains 125 loops and rotates in a field of0.200 T at a rate of 120 rev/s ?

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter13: Electromagnetic Induction

Section: Chapter Questions

Problem 63AP: Shown in the following figure is a long, straight wire and a single-turn rectangular loop, both of...

See similar textbooks

Related questions

Q: Calculate the maximum emf induced ( in units of mV) in the coil by this field.

A: Given That, No. of turns, N=100 Magnetic field=2*10-5 T Area…

Q: Discuss the factors determining the induced emf in a closed loop of wire.

Q: Suppose that a rectangular toroid has 1500 windings and a self-inductance of 0.04 H. If the height…

A: Given : Number of turns, N= 1500 Self Inductance, L =0.04 H Height , h = 0.08 m Energy stored , U=…

Q: Make a prediction: Increasing the number of coil windings around the iron bar will make the strength…

A: If we wind a wire around a iron bar then this behaves as solenoid with a medium.

Q: A coil of resistance 15Ω and inductance 0.6H is connected to a 120V D.C. line. At what rate will…

A: (a) The expression for the current flowing through the inductor in RL circuit is written as, Here,…

Q: The varying magnetic flux of ϕ = 10et + 50 Wb is placed perpendicular to the plane of 50 turns coil.…

A: Write the given values with the suitable variables. ϕ=10et+50 WbN=50t=0.001 s Here, ϕ, N, and t are…

Q: Find the induced emf in the coil as a function of time if f=10 Hz.

Q: The electric-power industry would like to find efficient ways to storeelectrical energy generated…

A: Energy stored in the inductor, U=1 kWh=1.00×103×3600=3.6×106 J Current, I=200 A

Q: Find the magnetic energy stored by a 4.94 mH inductor when the current through it is 1.3 A.

A: Given data: Inductance (L) = 4.94 mH = 4.94×10-3 H Current (I) = 1.3 A Required: The magnetic…

Q: How does the flux, time, and greater turns of a coil affect the induced emf?

A: Introduction :- Here we need to tell how the different factors affects the induced emf. This…

Q: The magnetic flux through the loop increases according to the relation shown below. What is the…

Q: Ulysses wants to be able to generate a voltage of Vpeak = 12 V using a hand-crank AC generator. In…

A: Vpeak = 12 V; NP = 10 ; NS = 400 ; R = 4.0 cm ; Na = 75 turns; B = 60 m ;

Q: A 35-turn 12.5-cm-diameter coil is placed between the polepieces of an electromagnet. When the…

A: Number of turn, N = 35 diameter, d = 12.5 cm emf, e =120 V

Q: (I) Neon signs require 12 kV for their operation. To operatefrom a 240-V line, what must be the…

A: The ratio of secondary to primary turns of the transformer can be obtained as…

Q: A circular coiVhas a radius of 10 cm and 50 turns are rotated about its vertical diameter in a…

A: i) at position 40° Emf = NBAW Cos40° 228.4 = 50×0.6×(π×0.12)×W×Cos40° 228.4 = 0.722W W = 316.34…

Q: The maximum induced emf in a generator rotating at 210 rpmis 35 V. How fast must the rotor of the…

A: To determine the unknown rotational speed of the maximum emf . εmax,1=NBAω1 εmax,2=NBAω2 Solve the…

Q: 6.6 Assume a nonlinear magnetization curve for a current transformer. Show that a percentage…

A: The percentage differential relay is defined as the relay that operates on the phase difference of…

Q: A rectangular coil 25 cm by 45 cm has 150 turns. This coil produces a maximum emf of 75 V when it…

A: Formula of maximum induced emf is as follows; εmax=NABω…

Q: half O A tectangular conducting loop has its left in a magnetic field directed into the page. S…

A: when we increase the magnetic field in the page so Loop pused itself on the right side because it…

Q: A coil has an inductance of 0.81 mH and a resis connected to a 21 V battery. After how many tim…

A: GivenL=0.81 mHR=0.65 ohmV=21 V

Q: A 24-V battery is connected in series with a resistor and aninductor, with R = 8.0 Ω and L = 4.0 H,…

A: Formula to calculate current at any time in a circuit is,

Q: A loop of wire in the shape of a rectangle rotates with a frequency of 245 rotation per minute in an…

A: The maximum emf induced is e = N B A w where, N is the number of turns, B is the magnetic field, A…

Q: The flux (t3-2t) in each winding of a coil with 100 turns is mWb. t=2. Which of the following is the…

Q: Calculate the self-inductance (in mH) of a 50.0 cm long, 10.0 cm diameter solenoid having 1000…

Q: As shown in the figure, the current passing through a coil with radius r and number of turns n is…

A: Current changing with respect to time is given by; i=i0e-tt0

Q: A 10 H inductor carries a current of 20 A ch ice at 0°C could be melted by the energy stored in…

A: Latent heat is the energy absorbed or released by a substance during a change in its physical state…

Q: if the area of the coil is 6920 cm2 and magenetic field applied is increasing uniformly from 0.3 T…

Q: 1/7he Coessicient of mutuel incluctance betheen twothansformmer Windings is ay Hi 1ş the equefion of…

Q: A shunt generator supplies a 27kW load at 205V through cables of resistance, R = 112mn. If the field…

Q: find the induced emf in the coil once coil is rotated about 0.3 secs

Q: Find Bz at the center of each coil and compare it to the value at the midpoint (point P) between the…

Q: Can there be an induced emf in a circuit at an instant when the magnetic flux through the circuit is…

A: Magnetic flux

Q: it. Find the current induced in the loop. Q3: A long solenoid, of radius 5cm, is driven by an…

Q: nagnet in the previous question is now plunged into a coil that has tu v, the induced current in the…

A: Thus emf induced is proportional to rate of change of magnetic flux.

Q: A air-filed solenoid 18.3 cm diameter and length 23 cm, has 120 turns. If the current increases from…

Q: The flux linkage through a certain coil of 0.75 ohm resistance would be 26 mWb if there were a…

A: a) The inductance of the coil is given by,

Q: Verify pls if the values in the simulation. Show solutions in determining the branch currents using…

Q: How many turns should a coil of an inductor is needed in a low pass filter with a cut-off frequency…

A: The resistance in the circuit R=8 Ω The cut-off frequency f =500 Hz The equation for cut off…

Q: Find the magnetic energy stored by a 5.22 mH inductor when the current through it is 11.1 A.

Q: The armature coil of a d.c. motor has a resistance of 0.2 N and is connected to a 120 V supply. Find…

A: Find the armature current. I=V-ER Here, V is the applied voltage, E is the emf, and R is the…

Q: A generator is designed to produce a maximum emf of 190 Vwhile rotating with an angular speed of…

A: Maximum emf, eo = 190 V frequency, f = 3800 rpm = 63.3 Hz Area, A = 0.016 m2 Magnetic field, B =…

Q: A air-filed solenoid 18.3 cm diameter and length 23 cm, has 120 turns. If the current increases from…

A: Diameter , d = 18.3 cm = 0.183 m Length , L = 23 cm = 0.23 m Number of turns , N = 120 turns…

Q: Does the induced emf always act to decrease the magnetic flux through a circuit?

A: According to Lenz's law - "An induced electric current flows in a direction such that the current…

Q: At what angle θ is the torque on a current loop 10.0% of maximum?

A: The expression for the maximum exerted torque is, τmax=NIAB sin90° The expression for the torque…

Concept explainers

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention. 

Question

Calculate the peak output voltage of a simple generator
whose square armature windings are 6.60 cm on a side;
the armature contains 125 loops and rotates in a field of
0.200 T at a rate of 120 rev/s ?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Check Your Understanding. A current I(t)=(5.0A)sin((200rad/s)t) flows through the solenoid of part (b) of Example 14.1. What is the maximum emf induced in the surrounding coil?
A steady current flows through a circuit with a large induct3ve time constant. When a switch in the circuit is opened, a large spark across the terminals of the switch. Explain.
Why are the primary and secondary coils of a transformer wrapped around the same closed loop of iron?
The armature and field coils of a series-wound motor have a total resistance of 3.0 . When connected to a 120-V source and running at normal speed, the motor draws 4.0 A. (a) How large is tire back emf? (b) What current will the motor draw just after it is turned on? Can you suggest a way to avoid this large initial current?
Suppose you wish to produce 1.2-T magnetic field in a toroid with an iron core for which =4.0103 . The toroid has a mean radius of 15 cm and is wound with 500 turns. What current is required?
An inductor is connected across the terminals of a battery. Does the current stance of the battery? Does the time required for the current to reach its final value depend on this resistance?
Show that the self-inductance per unit length of an infinite, straight, thin wire is infinite.
A small, rectangular single loop of wire with dimensions 1, and a is placed, as shown in the plan of a much larger, rectangular single loop of wire. The two short sides of the larger loop axe so far from the smaller loop that their magnetic fields over the smaller fields over the smaller loop can be ignored. What is the mutual inductance of the two loops?
Can there be an induced emf in a circuit at an instant when the magnetic flux through the circuit is zero?
A 5000-pF capacitor is charged to 100 V and then quickly connected to an 80-mH inductor. Determine (a) the maximum energy stored in the magnetic field of the inductor, (b) the peak value of the current, and (c) the frequency of oscillation of the circuit.
When the current through a large inductor is interrupted with a switch, an are appears across the open terminals of the switch. Explain.
If emf of the battery of Figure 14.12(b) is reduced by a factor of 2, by how much does the steady-state energy stored in the magnetic field of the inductor change?