Calculate the thermal conductivity (in W/m-K) of a material having a heat loss of 1028 watts, inside diameter of 59.4cm and thickness of 118.4mm passing through a 14.5m long pipe at 55˚C. Assume ambient temperature of 4˚C.
Q: As seen in the attached figure, a 5-mm-diameter spherical ball (k = 15 W/m·K, Cp=480 J/kg·K) at 50°C…
A: Given : The diameter of spherical ball = 5 mm The thickness of the insulation = 1 mm The heat…
Q: Consider a person standing in a breezy field at 10°C. Determine the total rate of heat transfer from…
A: In heat transfer analysis, the rate of change of state is evaluated by calculating the rate of heat…
Q: Hot gas temperature: Cold gas temperature: 1200°C 50°C Convection heat transfer coefficient on the…
A: Given that, Temperature of hot gas, Th=1200 °C,Temperature of cold gas, Tc=50 °C,Convection heat…
Q: A mild steel square tank with a wall thickness of 8mm contains water at 80°C. The thermal…
A:
Q: HEAT TRANSFER A mild steel steam pipe with an outer diameter of 11.43 cm and inner diameter of…
A:
Q: Hot square plate (1 m ×1 m) is to be cooled by attaching aluminum circular pin fins (D=0.25 cm, L= 3…
A: Given:- Plate=(1×1)m2D=0.25 cmL=3 cmd=0.6 cmTb=100°CT∞=30°Ch=35 W/m. °C. To find:-Total rate of heat…
Q: A person is found dead at 5 PM in a room whose temperature is 20 °C. The temperature of the body is…
A: Given data: The room temperature is T∞=20°C The temperature of the body is T=25°C The normal…
Q: Q18: Heat is generated uniformly at a rate of 2.6 x10 w/m³ in a spherical ball (k = 45 W/m - "C) of…
A: Given Data: The rate of heat generation is q˙=2.6×106 W/m3. The thermal conductivity of the…
Q: Write a short note on the following: What are the best possible solutions to increase the heat…
A: Required: a) The best possible solution to increase the heat transfer rate. b) Material with k=121…
Q: A rectangular fin with k=43 W/m.C, thickness t=2 cm, length L=14 cm and width W=1 m. The base of the…
A:
Q: Water flows in a pipe of 0.0475 m inside diameter at a velocity of 1.5 m/s. Calculate the heat…
A: 1 Step : Properties at mean temperature (60+40)/2 =50 deg C are listed down. 2nd Step: Reynolds…
Q: Derive the expression for overall heat transfer coefficient through a two layers composite sphere…
A:
Q: two 5 cm diameter, 15 cm long aluminum bars (k=176W/m(degrees Celsius)) with ground surfaces are…
A:
Q: Q18: Heat is generated uniformly at a rate of 2.6 x10 W/m3 in a spherical ball (k = 45 W/m C) of…
A:
Q: One end of a 0.3 m long steel rod is connected to a wall at 204°C. The other end is connected to a…
A:
Q: A glass window of width W = 1 m and height H = 2 m is 5 mm thick and has a thermal conductivity of…
A: (i) Given data: Area of heat transfer for the glass window, A=1×2=2 m2. Thickness of the glass, t=5…
Q: A horizontal steel pipe having a diameter of 5 cm is maintained at a temperature of 50•C in a large…
A: Given data:-diameter of pipe, d=5cm=0.05mTemperature of pipe surface, Ts=50°C=323KWall temperature,…
Q: Calculate the heat losses per unit length in a horizontal tube with an outside diameter of 15 cm, if…
A: Outside diameter of tube, d=15 cm=0.15 mSurface temperature of tube, Ts=400 KSurrounding air…
Q: Q3/A 10-cm length of platinum wire 0.5 mm in diameter is placed horizontally in a container of air…
A: To find: The surface temperature. Given: The length of platinum wire is l=10 cm. The wire diameter…
Q: 1. Heat transfer from a 2m diameter sphere to a 21°C air stream over a time interval of one (1) hour…
A: Given data:
Q: A glass plate at 40°C is heated by passing hot air over it with a convection heat transfer…
A: Temperature difference should not exceed by 5 C, i.e ( T1 - T2 ) = 5 C Thickness (L)= 1mm Area of…
Q: Determine the convection heat transfer resistance on the inside of the pipe per unit length, in…
A: R, convection i=1/hi*Ai =(1/450*π*0.150*1). L=1(unit length) =4.716*10^-3 =4.716mK/W
Q: Water flows at 67 C inside a 2.5 cm inside diameter tube such that hi = 3500 W/m² .C. The tube has a…
A:
Q: A 5-mm-diameter spherical ball at 50 oC is covered by a 1-mm-thick plastic insulation (k=0.13…
A:
Q: 1. Judging from its unit W/m.K can we define thermal conductivity of a material as the rate of…
A: 1. We can not define thermal conductivity as the rate of heat transfer through the material per unit…
Q: Q3/ A 10-cm length of platinum wire 0.5 mm in diameter is placed horizontally in a container of air…
A:
Q: A room is well insulated apart from a single-glazed window measuring 1 m2 and 4 mm thick. The…
A: To find: The convective heat transfer coefficient for outside hout. Given : The Area is A=1 m2.…
Q: Derive the relation between the coefficient of linear thermal expansion and coefficient of area…
A:
Q: A food product with 73% moisture content in a 10 cm diameter can wants to be frozen. The density of…
A: Given data, x = Moisture contains in the food product = 0.73 a = Diameter of the food product = 0.1…
Q: A 5 mm copper rod of conductivity 398 W/(mK) and length 20 cm is exposed to air. The air temperature…
A: Given: Diameter of copper rod→D=5 mm=0.005 m Conductivity of copper rod→k=398 W/mK Length of the…
Q: A person is found dead at 5PM in a room whose temperature is 20°C. The temperature of the body is…
A: Given, Diameter,d=30cm=0.30mradius, r=0.15mLength, L=1.70mHeat transfer coefficient,…
Q: Calculate the heat transfer rate from a single-pane glass window with aninside surface temperature…
A: The law which describes the rate of heat transfer in conduction is known as Fourier's Law. According…
Q: A 5.0 -cm-diameter aluminum cylinder is maintained at a temperature of 50-C in a large room where…
A: total heat transfer = heat transfer by convection + heat transfer from radiation
Q: 2.33 One end of a 0.3-m-long steel rod is connected to a wall at 204°C. The other end is connected…
A: Data given- T1 = 204°C T2 = 93°C h = 17 W/m2 K Tair = 38°C L = 0.3 m D= 5 cm = 0.05 m
Q: 16.- Consider a person standing in a breezy room at 22°C. Determine the total rate of heat transfer…
A:
Q: A double pane window consists of 3 mm thick layer of glass separated by a 12 mm wide stagnant air…
A: From the given information:
Q: Hot engine oil is being transported in a horizontal pipe (k = 15 W/m∙K, Di = 5 cm) with a wall…
A: Assumptions Thermal conductivity of pipe and insulation will not vary with temnperature. steady…
Q: Question 1:A glass window of width W = 1 m and height H = 2 m is 5 mm thick and has a thermal…
A: Given, The dimensions of the glass, W=1 mH=2 mt=5 mm=0.005 m The thermal conductivity of the glass,…
Q: Q2/ A hot surface at 100 C is to be cooled by attaching 27778 copper fins (k-237 w/m.K), 3 cm long…
A:
Q: A person is found dead at 5 PM in a room whose temperature is 20°C. The temperature of the body is…
A:
Q: Q4: A spherical tank, Im in diameter, is maintained at a temperature of 120 °C and exposed to a…
A:
Q: Water flows at 50°C inside a 2.5-cm-inside-diameter tube such that hi = 3500 W/m² .°C. The tube has…
A:
Q: A 5.0-cm-diameter cylinder is heated to a temperature of 200 oC, and air at 30 oC forced across it…
A: Given data: d=5 cmh=180 W/m2KT1=200°C=473 KT2=30°C=283 Kε=0.7T∞=10°C=283 K Need to determine the…
Calculate the thermal conductivity (in W/m-K) of a material having a heat loss of 1028 watts, inside diameter of 59.4cm and thickness of 118.4mm passing through a 14.5m long pipe at 55˚C. Assume ambient temperature of 4˚C.
Step by step
Solved in 2 steps
- An electrical transmission line of 1.2-cm diameter carries a current of 200 amps and has a resistance of 310-4 ohm per meter of length. If the air around this line is at v, determine the surface temperature on a windy day, assuming a wind blows across the line at 33 km/h.3.16 A large, 2.54-cm.-thick copper plate is placed between two air streams. The heat transfer coefficient on one side is and on the other side is . If the temperature of both streams is suddenly changed from 38°C to 93°C, determine how long it takes for the copper plate to reach a temperature of 82°C.2.38 The addition of aluminum fins has been suggested to increase the rate of heat dissipation from one side of an electronic device 1 m wide and 1 m tall. The fins are to be rectangular in cross section, 2.5 cm long and 0.25 cm thick, as shown in the figure. There are to be 100 fins per meter. The convection heat transfer coefficient, both for the wall and the fins, is estimated to be K. With this information determine the percent increase in the rate of heat transfer of the finned wall compared to the bare wall.
- 1.4 To measure thermal conductivity, two similar 1-cm-thick specimens are placed in the apparatus shown in the accompanying sketch. Electric current is supplied to the guard heater, and a wattmeter shows that the power dissipation is 10 W. Thermocouples attached to the warmer and to the cooler surfaces show temperatures of 322 and 300 K, respectively. Calculate the thermal conductivity of the material at the mean temperature in W/m K. Problem 1.4The heat transfer coefficient for a gas flowing over a thin float plate 3-m long and 0.3-m wide varies with distance from the leading edge according to hc(x)=10x1/4Wm2K If the plate temperature is 170C and the gas temperature is 30C, calculate (a) the average heat transfer coefficient, (b) the rate of heat transfer between the plate and the gas, and (c) the local heat flux 2 m from the leading edge. Problem 1.181.1 On a cold winter day, the outer surface of a 0.2-m-thick concrete wall of a warehouse is exposed to temperature of –5°C, while the inner surface is kept at 20°C. The thermal conductivity of the concrete is 1.2 W/m K. Determine the heat loss through the wall, which is 10-m long and 3-m high. Problem 1.1
- Using Table 1.4 as a guide, prepare a similar table showing the orders of magnitude of the thermal resistances of a unit area for convection between a surface and various fluids.One end of a 0.3-m-long steel rod is connected to a wall at 204C. The other end is connected to a wall that is maintained at 93C. Air is blown across the rod so that a heat transfer coefficient of 17W/m2 K is maintained over the entire surface. If the diameter of the rod is 5 cm and the temperature of the air is 38C, what is the net rate of heat loss to the air?1.10 A heat flux meter at the outer (cold) wall of a concrete building indicates that the heat loss through a wall of 10-cm thickness is . If a thermocouple at the inner surface of the wall indicates a temperature of 22°C while another at the outer surface shows 6°C, calculate the thermal conductivity of the concrete and compare your result with the value in Appendix 2, Table 11.
- Calculate the heat losses per unit length in a horizontal tube with an outside diameter of 15 cm, if its surface is kept at 400 K AND the surrounding air has a temperature of 300 K and a pressure of 1 bar.The properties of air at a pressure of 1 bar and a film temperature of 350 K are: In this case, v = 20.76 x 10-6 m2/s , α = 0.2983 x 10-4 m2/s, k = 0.03003 W/mK, Pr = 0.697, β = 2.86 x 10-3 K-1A fluid has a temperature of 100C and thermal film coefficient of 50 W/m^2-K. Solve for the heat transferred per sq m of contact if the surface it is in contact with has a surface temperature of 20C.The temperature of a tank in the form of liquid nitrogen is -10 ° C. Tank diameter is 16 cm. The amount of heat lost by convection and radiation from the tank to the environment is 65.5 W / m. Calculate the temperature of the environment where the tank is located .h = 4.35 W / m2K, e= 1.