Answered: Calculate the total force exerted on…

Name: Calculate the total force exerted on the outside of a circular submari
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: Calculate the total force exerted on the outside of a circular submarine window of diameter 30-em at a depth of 1200 meters.

Engineering

Mechanical Engineering

Calculate the total force exerted on the outside of a circular submarine window of diameter 30-em at a depth of 1200 meters.

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter8: Centroids And Distributed Loads

Section: Chapter Questions

Problem 8.113P: Calculate the resultant force caused by the water acting on the parabolic arch dam. The water levels...

See similar textbooks

Related questions

Q: 3.4m O 1.5m Oil Surface S.G 0.85 Board properties Cross section Area - 0.005m^2 Weighs 30N/m 1.…

Q: Compute the potential energy stored in raising object to height of 6.55 m having mass 10 kg

Q: 1. A vertical triangular surface of height d and horizontal base width b is submerged in a liquid…

Q: Use Image below Question: Gate AB is 2 m long and 1.8 m into the paper. Neglecting atmospheric…

Q: A water tank in the shape of an inverted right circular cone has an altitude of 15 feet and a base…

Q: A vertical gate 6 m x 6 m holds water on one side with the free surface at its top. The moment about…

A: Height of the gate is, h=6 m. Breadth of the gate is, b=6 m. Area of cross section of the vertical…

Q: . Assuming standard condition, what is the altitude in ft where the density is 0.001845 slug/ft3?

Q: A barge is 15 ft wide and 40 ft long and fl oats with a draftof 4 ft. It is piled so high with…

A: Given data as per question Width of barge = 15 ft Length of barge= 40 ft Draft = 4ft let M is…

Q: Two smooth spheres P, Q each of radius 25 cm and weighing 500 N, rest in a horizontal channel having…

Q: subjected to pressure of liquid of specific gravity 1.40 on one side. The free surface of the liquid…

Q: Figure 3 shows the plan view (top view) of a pair of gates which are hinged at the water channel…

Q: Calculate the pressure exerted on a floor by a one pointed table leg (170 kg on all four leg) of…

A: The weight of the load on each leg can be determined as,

Q: Parallel forces are example for Non- Concurrent Force System

A: Non-Concurrent Force System When the forces of a system do not meet at a common point of…

Q: Consider the gate below to be a quarter circle of radius 80cm. Find the force P (in Newtons) needed…

A: Given: The radius of gate, r = 80 cm = 0.8 m The width of gate, b = 1 m The depth of gate from water…

Q: Example: A hemisphere projection of diameter 0.6 m exists on one of the vertical sides of a tank. If…

A: GIVEN DATA A HEMISPHERICAL GATE GIVEN WE HAVE TO FIND HORIZONTAL AND VERTICAL COMPONENT OF FORCES…

Q: A hydraulic press has a ram of 30 cm diameter and a plunger of 4.5 cm diameter. Find the weight…

A: Data given- Ram diameter = 30 cm Plunger diameter = 4.5 cm Fp = 800 N

Q: Calculate the reaction force on the gate from the smooth support at A (FAz) in [N]

Q: In Fig. , curved section AB is 5 m wide into the paperand is a 60 ° circular arc of radius 2 m.…

Q: Problem 6 A 6 meter high, 5 meter wide rectangular plate blocks the end of a 5 meter deep freshwater…

A: (a) To find: The resultant force exerted on the gate from the water. Given: The height of plate is…

Q: A 500kg bucket is lifted by a crane at a certain position shown below. What is the magnitude of the…

A: Given data: Mass of bucket, m = 500 kg. Calculate the weight of the bucket, W=mg=500 kg×9.81…

Q: A cylindrical tank of radius 5 ft and height 9 ft is two-thirds filled with a liquid of weight…

A: Given Radius, R = 5 ft Height, h = 9 ft Density = 62.4 lbs/ft3 Find Work required, W

Q: 7. The face of a dam adjacent to the water is vertical, and its shape is in the form of an isosceles…

Q: The lift force on the wing of an aircraft is approximately rep- resented as shown. Calculate the…

A: Next time onward, try to submit the picture in a right way.

Q: Calculate the force acting on a 30-cm-diameter porthole of a ship if the center of the porthole is…

A: Given data: Diameter of porthole, d = 30 cm. The distance of the center of the porthole from the…

Q: Calculate the force acting on a 30-cm diameter porthole of a ship if the center of the porthole is…

A: Note:As per our guidelines we are supposed to answer only one question. Kindly repost other…

Q: A solid cylinder of diameter 5.0m has a height of 5.0 m. Find the metacentric height of the cylinder…

Q: Example: A hemisphere projection of diameter 0.6 m exists on one of the vertical sides of a tank. If…

Q: 13. Fig 3.66 shows a gate having a quadrant shape of radius of 3 m. Find the resultant force due to…

A: Given:R=3 m

Q: Find the height H in Fig. for which the hydrostaticforce on the rectangular panel is the same as the…

A: Calculate the force on the rectangular panel as follows: Frectangle = γApanel hCG Here, γ is the…

Q: If the specific fuel consumption of a 300-hp tractor engine during plowing is 350 g of diesel/kW-hr,…

A: Given data Specific Fuel Consumption = 350 g/ KW-hr = 0.35 kg/kW-hr Power of tractor engine = 300…

Q: A float sensor for the determination of the level of water in a vessel has a cylindrical float of…

Q: Gate AB in Fig. of pressure. is 1.0 m long and 0.9 m wide. Calculate force F on the gate and the…

Q: A dam 30.5m long retains 8 m of fresh water and is inclined at an angle of 60 degrees. Calculate the…

A: Write the expression to obtain the length.

Q: A pudding truck carries pudding with a density of 67.55 lb/ft! in a horizontal cylindrical tank with…

Q: Example: A hemisphere projection of diameter 0.6 m exists on one of the vertical sides of a tank. If…

Q: Seawater (density 1025 kg/m3) rests to a depth 50 m behind a vertical dam of width 80 m. Calculate…

A: Given Density = 1025 kg/m3 Depth, h = 50 m Width, b = 80 m Find Resultant force…

Q: Find the magnitude of the pressure force acting on the gate shown in the figure and then calculate…

A: Height of latch from the hinge = 4 ft Height of water column above the hinge = 3.6 ft

Q: A block of iron of density 2200 kg/m3 is fully immersed in water as shown in figure 2. Given the…

Q: 2. Gate AB is a quarter circle 10 ft wide into the paper and hinged at point B. Find the force F…

Q: Compute the hydrostatic force acting on surface ABC exerted by water. Given wall width as 2 m. 1.5 m…

Q: Find the magnitude and location of the force acting on the a vertically mounted flat triangular gate…

Q: What is the resultant force on one side of a 25 cm diameter vertical circular plate standing at the…

A: Given Data : Diameter of circular plate d = 25 cm Height of pool h = 3 m The area of circular…

Q: An object with a volume of 150 cm' is weighed on an equal-arm balance. The standard mass required…

A: dear student please rate me postive :) Stay safe stay happy ! Answer -

Q: 02: A square (2.75m x 2.75m) lies in a vertical plane. Calculate the distance between the center of…

Q: Find the height h for mechanical balance by taking the density of water as psu-998kg/m3 and the…

Q: Two spheres, each 1.20 m in diameter, weighs 4kN and 12kN respectively. They are connected with a…

A: Diameter of sphere, d = 1.2 m Weight of first sphere, W1 = 4kN Weight of second sphere, W2= 12 kN

Q: Calculate the mass of a body that weight 600lb of the surface of the earth

A: Given Data The weight of the body is: W=600 lb When the weight of any object or the body is…

Q: 2. water qurte 2.5m A 1.5mradius The corner of a floating body has a quarter cylinder AB having a…

Topic Video

Question

Calculate the total force exerted on the outside of a circular submarine window of diameter 30-em at a depth of 1200 meters.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Calculate the resultant force caused by the water acting on the parabolic arch dam. The water levels are 16 ft on the upstream side and zero on the downstream side. For water, use =62.4lb/ft3.
The thin-walled cylindrical can with a spherical dimple weighs 0.2 lb. Determine the force P required to push the can into water to a depth of 8 in. Use =0.036lb/in.3 for water.
A man weighs 170 lb on the surface of the earth. Compute his weight in an airplane flying at an elevation of 28 000 ft.
The parametric equations of the plane curve known as a cycloid are x=a(sin) and y=a(1cos). Use integration to find the coordinates of the centroid of the cycloid obtained by varying from 0 to 2 rad.
The hemispherical glass bowl is filled with water. Find the location y of the center of gravity of the filled bowl. Approximate the bowl as a thin shell of radius R=6.15in. Use 1=162lb/ft3 for glass and 2=62.4lb/ft3 for water.
Find the elevation h (km) where the weight of an object is one-tenth its weight on the surface of the earth.
Find the internal force systems acting on sections 1 and 2.
A water tank of cross-sectional area 2.5 m2 and height 120 in contains 1500 (US) gallons of water. If the density of water is 1000 kg/m3, calculate the force on the base of the tank.
A pudding truck carries pudding with a density of 67.55 lb/ft! in a horizontal cylindrical tank with a diameter of 6 ft. Find the force exerted by the milk on one end of the tank when the tank is half full.
A circular plate of radius 2ft is lowered to a liquid (w=1000 lb/ft^3) so that its center is 4 ft below the surface. Find the force on the lower half of the plate.
Calculate the pressure exerted by water on the hull of a submarine that is cruising at a depth of 500 ft below ocean level. Assume the density of the ocean water is ρ = 1025 kg⁄m3 .
Figure 7ashows a semi-conical buttress. Calculate the components of the total force acting on the surface of this semi-conical buttress.