Answered: A circular plate of radius 2ft is…

A circular plate of radius 2ft is lowered to a liquid (w=1000 lb/ft^3) so that its center is 4 ft below the surface. Find the force on the lower half of the plate.

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter8: Centroids And Distributed Loads

Section: Chapter Questions

Problem 8.90P: The hemispherical glass bowl is filled with water. Find the location y of the center of gravity of...

See similar textbooks

Related questions

Q: (4) Explain how could you determine the resultant force on a curved surface inmnersed in a liquid?…

Q: A circular plate of 9m radius is submerged vertically in a tank of water so that its top is 4m to…

A: Given data: The radius of the circular plate is r=9 m, The mass density of the water is ρ=1000…

Q: Consider the gate shown The gate has a width of 1 m. ρw = 1.0 Mg/m^3. Suppose that a = 2.5 m, b =…

Q: A triangular lamina is immersed vertically in water in such a way that its 6m wide horizontal base…

Q: A block of wood is 30 cm log and has a square vertical section 15 cm on the edge. For it to float in…

Q: Gate AB in the image is a quarter circle 10 ft wide along the z axis and hinged at B. Find the force…

Q: B3. A circular plate of diameter 2 m is vertically placed in water in such a way that the centre of…

Q: A force sensor is immersed in a iquid with a density of 61 lb/ to a depth of 42 in and then placed…

Q: The gate is 160 cm wide, is hinged at point B, and rests against a smooth wall at point A. what is…

Q: Find a) the total force on gate AB in KN and b) the position of the center of pressure in m with…

A: First of all we need to transform the closed chamber into an open vessel, both having the same…

Q: A sphere (SG = 2.2) is at the bottom of a tank filled with 1.5m of water. The diameter of the sphere…

Q: At ground level the atmospheric pressure is 101.3 kpa at 15 celcius. Calculate the pressure at a…

Q: The gate is 160 cm wide, is hinged at point B, and rests against a smooth wall at point A. what is…

Q: This Utah-shaped plate is submerged in oil, (s=0.94) and lies in a vertical plane. Find the…

A: Consider the below figure: Find the distance of centroid from the free surface: y-coordinate of the…

Q: The ABC cover in the figure is R = 270 cm in diameter and in the form of a semi-circle and its…

A: Given Data, R = Radius of the cover ABC = 270 cm = 2.7 m w= Width of the cover into the paper = 140…

Q: Calculate the force acting on a 30-cm-diameter porthole of a ship if the center of the porthole is…

A: Given data: Diameter of porthole, d = 30 cm. The distance of the center of the porthole from the…

Q: Calculate the force acting on a 30-cm diameter porthole of a ship if the center of the porthole is…

A: Note:As per our guidelines we are supposed to answer only one question. Kindly repost other…

Q: Calculate the fluid force on one side of a 5 ft by 5 ftsquare plate if the plate is at the bottom of…

A: Given data:- Side of square, a=5ft.=1.524m ∴ Area of square, A=a2=2.32m2 depth of water=8ft.=2.4384m…

Q: A rectangular slab of ice floats on water with a large portion submerged beneath the water surface.…

A: Given Data: The volume of the slab is, V=20 m3. The top surface area is, A=14 m2. The density of…

Q: Find the hydrostatic force in kN acting in a triangular plate of base 2 m and height 3 m which is…

Q: A wall is made from a quarter circle and flat plate with h = 4 m, R = 1.5 m, and w 3 m. The water is…

A: we will use projected area for horizontal force for vertical force we will use weight of fluid that…

Q: 2. In Fig., the cover gate AB closes a square opening 80 cm in size. The gate is held closed by a…

A: Given, m = 200 kg L = 0.8 m

Q: A hollow circular plate of 2 m external diameter and 1 m internal daimeter is immersed vertically…

A: GIVEN DATA A HOLLOW CIRCULAR PLATE GIVEN IMMERSED IN WATER WE HAVE TO FIND FORCE ACTING ON IT

Q: The gate is 160 cm wide, is hinged at point B, and rests against a smooth wall at point A. what is…

Q: B3. A circular plate of diameter 2.75 m is vertically placed in water in such a way that the centre…

Q: An open cylinder of 20 cm diameter and 100 cm long contain water up to a height of 80 cm. It is…

A: Given data: d=20 cmL=100 cmH=80 cm Need to determine the speed of rotation in rpm when axial depth…

Q: An open tank containing water has a bulge with R = 5ft in its vertical side that is semicircular in…

A: Given data, R= 5 ft S=11 ft ρω=62.4 lb/ft3 l=4 ft…

Q: B3. A circular plate of diameter 2.5 m is vertically placed in water in such a way that the centre…

Q: A cylindrical tank 1m in diameter and 2m high contains water at a depth of 1.6m. If it is rotated…

Q: Q.2: In the figure shows a curved surface LM, which is in the form of a quadrant of a circle of…

A: Solution: The horizontal component of the hydrostatic force From the figure position of x¯ from the…

Q: The gate is 160 cm wide, is hinged at point B, and rests against a smooth wall at point A. what is…

Q: find a) the total force on gate AB in KN and b) the position of the center of pressure in m with…

Q: In hydrostatic pressure force experiment. A rectangular plate with dimensions W= 9.0 m wide and 45…

Q: A triangular lamina is immersed vertically in water in such a way that its 6 m wide horizontal base…

A: Here, b=6 m, h=4.5 m ∴ Distance of centriod from free surface, x¯=8-13h=8-13×4.5=6.5 m

Q: A block of 5.97 m x 3.22 x 8.1 m floats in a fluid with relative density 0.704 as shown in the…

A: Given that, Dimension of the block= 5.97 m×3.22×8.1 my=4.975 m,Relative density, S=0.704,

Q: A 6ft. by 8ft. rectangular plate is submerged vertically in a liquid weighing 50lb/ft?. Find the…

Q: A cube of steel 0.3 m on each side floats in mercury. Using specific gravities of steel and mercury…

Q: Two tank with the same fluid at their base are separated by piston whose weight is (50 N) and (30…

Q: (c) A Gate AB in Fig. 1(c) is 1.2 m long and 1.0 m width. Neglecting atmospheric pressure, determine…

A: Length of gate AB = 1.2 m Width = 1 m SG of oil = 0.82

Q: The flat square of side length 2 m is submerged vertically in water, 2 m below the surface as…

A: GIVEN DATA - FLAT SQUARE PLATE GIVEN 2m*2m WEIGHT DENSITY OF WATER =9810N/m3 WE HAVE TO FIND FORCE…

Q: The tank of water shown below is 15 cm body motion at 9 m/s² in x-direction (right) and 2 m/s in…

A: The above liquid is subjected to acceleration in x direction and z direction, thus it is subjected…

Q: 3. A fine (thin) ring with a radius 50 mm is being pulled from the surface of water. If the ring has…

Q: A vertical parabolic plate whose height is 2 meters is submerged in a certain liquid (s.g. = 1.50)…

Q: 2. water qurte 2.5m A 1.5mradius The corner of a floating body has a quarter cylinder AB having a…

Q: The round holes drilled in the sides and decks to illuminate the interior of the ships are called…

Q: Find the position of centre of buoyancy for a wooden block of width 5 m and depth 1 m, when it…

A: Given data: The width of the wooden block is b = 5 m. The depth of the wooden block is d = 1 m. The…

Concept explainers

Center of Gravity and Centroid

The term center of gravity indicates the position or location of a point about which the whole weight of a body or system is supposed to be concentrated, which means the whole weight of the body or system works through this point. It is closely related to mass distribution. For all positions of the body, the center of gravity would be a single point.

Question

A circular plate of radius 2ft is lowered to a liquid (w=1000 lb/ft^3) so that its center is 4 ft below the surface. Find the force on the lower half of the plate.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1 Given data

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A force sensor is immersed in a iquid with a density of 61 lb/ to a depth of 42 in and then placed in a second liquid with a density of 732 N/. What is the change in force on the sender if the diameter of the sensor is 8 cm and the change in depth is 5.9 cm?
Two capillary tubes with 2.4 mm and 1.5 mm inside diameters were inserted into a liquid of density 0.85 g cm³. Calculate the surface tension of the liquid if the difference between the capillary rises in the tubes is 1.5 cm. Assume contact angle is 0.
Surface AB is a circular arc with a radius of 2 m and a width of 1 m into the paper. The distance EB is 4 m. The fluid above surface AB is water, and atmospheric pressure prevails on the free surface of the water and on the bottom side of surface AB. Find the magnitude and line of action of the hydrostatic force acting on surface AB.
The round holes drilled in the sides and decks to illuminate the interior of the ships are called "portholes". If the center of a 30 cm diameter porthole of a ship is 10 m below the water level, how many N is the hydrostatic force acting on this porthole? Take the density of the water as 1000 kg / m3, the gravitational acceleration as 10 m / s2 and the value as 3.
at height of 10 km (33000 ft) above sea level atmospheric pressure is about 210 mm of mercury. what is the resultant normal force on 600 cm^2 window of an airplane flying at this height? assume the pressure inside the plane is 760 mm of mercury. the density of mercury is 13600 kg/m^3
Consider the gate shown The gate has a width of 1 m. ρw = 1.0 Mg/m^3. Suppose that a = 2.5 m, b = 1.5 m, c = 1.35 m. Determine the magnitude of the resultant force acting on the gate ABC due to hydrostatic pressure.
A trough, 10meters long is filled with a liquid of density 840 kg/m3. Its cross section is in the shape of a parabola with base width of 4m at the top and a height of 5m. If the trough is filled with water to a depth of 4 meters, find the force due to liquid pressure acting on one end of the trough. (Note: Place the liquid surface along the x-axis.)
Calculate the force acting on a 30-cm diameter porthole of a ship if the center of the porthole is 14 m below water level.
An open cylinder of 20 cm diameter and 100 cm long contain water up to a height of 80 cm. It is rotated about its vertical axis. Find the speed of rotation in rpm when axial depth is zero
A circular plate of diameter 3.25 m is vertically placed in water in such a way that the centre of the plate is 7.7 m below the free surface of water. Find the total pressure & center pressure on the plate. Draw the diagram neatly. 1) Total Pressure on the circular plate (in N) 2) Centre of Pressure on the circular plate (in m)
an oil tank is in the shape of a right circular cylinder with a radius of r meters and its axis is horizontal. if the tank is half full of oil having mass density 750 kg per cubic meter, find r if the total force on one end of the tank due to liquid pressure is 8000 N
Calculate the depth of the center of pressure for vertical rectangular plate having a height h = 10ft and base b = 5ft, and submerged in a liquid with its base at the liquid surface. If the upper base of the vertical rectangular plate given in the example problem is submerged by 12ft below the water surface, determine the location of the hydrostatic force and center of pressure. Answer should be (53,040 lbf and 17.4902ft)