Calculate the velocity values ​​in the D and E sections of the system in the figure. AE/AD= 3, Z1=1.6 m and Z2=0.2 m. The mercury deviation in the manometer is Z3=0.4 m. (Friction effects will be neglected, γmercury=13.6 t/m3 , γwa

Q: A venturi tube is used to determine the airspeed at the throat/test section. During the test, a…

A:

Q: Bernoulli's equation of an ideal fluid can be derived based on any one of the correct assumption in…

A: It is required to determine Correct assumption of Bernoulli equation

Q: The device shown in the figure is known as a venturi. In this specific venturi, the differential…

A: Given: The differential pressure between locations 1 and 2 is, P1-P2=5 psi. The diameter ratio is,…

Q: 3.1) Sketch the Hydraulic Grade Line (HGL) and the Energy Grade Line (EGL) considering all losses…

A: Given Datad1=0.12mL1=12md2=0.32mL2=13mf=0.017H1=10mQ=0.02m3/sk1A=0.7vw=10-6m2/sρ=1000kg/m3

Q: The reduced elbow shown in the figure is part of a distribution system for a fluid whose density is…

A:

Q: In a tapered horizontal pipeline, the seawater's speed is 3.75 m/s and the gauge pressure is 21 kPa…

A: The pressure of first point is given as, P1=21 kPa The velocity of first point is given as, v1= 3.75…

Q: Q3/ (30) Water is to be moved from a large, closed tank in which the air pressure is 20 psi into a…

A:

Q: QUESTION 2 Water flows through the horizontal branching pipe shown in Figure 3. Water discharges…

A:

Q: The figure shows a siphon which is used to draw water from a large open tank. If the absolute…

A:

Q: Water flows steadily through the system shown below. The 4-in. section leads to a throat, followed…

A: Consider the diagram shown below for the given system as shown below. From the continuity equation,

Q: 2gh (YNg-Yw20) YH20 A2

A:

Q: The power supplied to the fluid (QγHB/550) by the pump in the Figure is 10 hp. If H = 60 ft and the…

A: Given: The power of the pump is 10 hp.  H = 60 ft  D = 150 mm

Q: The shear stresses in the fluid flow are caused by O Pressure O Temperature O Friction O Volume

A: Option C). friction Shear stress is due to friction between two adjacent layers of the fluid when…

Q: Q4- When the flow is completely turbulent, increasing value of Re no. have no effect on the value of…

A: the effect of Reynold no on the friction factor.

Q: Question : Water flows through a circular nozzle, exits into the air as a jet, and strikes a plate,…

A: Answer: h = 0.314 m

Q: A pipeline of constant 0.6 m diameter with its centerline in the U2 horizontal plane turns through…

A: Given data: The diameter of the pipe is d=0.6 m The bend angle of the pipe is θ=75° The water flow…

Q: (b) An oil with dynamic viscosity of 0.8 Pa. s and specific gravity of 0.9 is flowing through a…

A: It isn't not difficult to track down a great deal of data on the distinctions among dynamic and…

Q: Please answer the attached file

A: Given data The specific gravity of oil is SGoil=0.87. The kinetic viscosity of the oil is…

Q: 3. Problem: What head H must be created at the beginning of the oil line in order to ensure the…

A:

Q: What is the kind of stress applied on the illustration which has caused the fluid to create a…

A: From above figure we get to know about the flow development between two plates. This kind of flow is…

Q: In order to measure the air speed in a pipe of radius R, you construct a device which tapers the…

A:

Q: An incompressible fluid of density ? and viscosity ? flows through a curved duct that turns the flow…

A:

Q: A drug is being injected into blood at a constant infusion rate of Q = 0.4mL/s from a syringe of…

A:

Q: The flow is opened to the atmosphere at point 2 and 3. Find the magnitude and the direction of the…

A:

Q: 4. A pipeline carrying oil of specific gravity 0.87, changes in diameter from 200 mm diameter at a…

A:

Q: els in the reservoirs are constant in the three reservoir systems given below, where local losses…

A:

Q: Q1: An oil (u = 0.083 N.sec/m2) flows between two inclined fixed and parallel plates %3D 6mm and 1…

A:

Q: Problem 5: Water flows through the horizontal branching pipe (pipe 2 3) shown in Figure. If a…

A: Given Data Velocity at section 1 is: v1=6 m/s Velocity at section 2 is: v2=9 m/s Area at section 1…

Q: A viscous liquid with a density p = 1.8 slug/ft³ and a kinematic viscosity v = 10+ ft²/s flows…

A:

Q: (3) The cart shown below is restrained from moving by a cable connected to a fixed wall. The tank…

A:

Q: Water flowing at 1.0 ft/s in a pipe passes into a constriction where area is one-tenth the normal…

A: Given data: Initial velocity of water, v1 = 1.0 ft/s. Water density, ρw = 62.4 lbs/ft3. Given that…

Q: manometer is inserted into the flow. in the area section A1 indicating a height difference ℎ = 0.01…

A:

Q: Fluid flows through the venture tube shown below. Pressure at section 2 is equal to 101 kPa. If…

A: Given, that the pressure at the section 1 is 251 kPa and the pressure at the section 2 is 101 kPa.…

Q: Flowing water in pipe 1 and pipe 2 is flowing to pipe 3 which is 7m long and discharges the water to…

A:

Q: The device shown in the fugure below is known as a venturi. In theis specific venturi the…

A: Given:P1-P2=5psiD2D1=0.35D2=8in=812fthere,P1 and P2=Pressure at section 1 and 2 of venturiD1 and…

Q: (1] A Newtonian fluid with a viscosity u and density p, is flowing at a laminar condition on an…

A: Given the equation is, Now, apply the boundary conditions, At y = 0, u = 0 And y = b, u = 0 Now,…

Q: Q1) When the force (P) applied to the plate shown in Fig.1 ,the velocity profile for a fluid is…

A:

Q: In a syringe of the figure shown, the drug had density of 900 kg/km' and absolute viscosity of 0.002…

A:

Q: Q1) When the force (P) applied to the plate shown in Fig.1 ,the velocity profile for a fluid is…

A: Given data: u = 12y0.25 μ=0.8×10-3N.s/m2 y = 16 mm Need to determine the shear stress at y = 16 mm.

Q: ngth of the divergent portion of venturimeter in comparison to the conv

A: The answer is False.

Q: Q1) The closed tank is full of liquid of specific gravity equals to 1.4. The tank is accelerated…

A:

Q: A pipe line AB of diameter 300 mm and of length 400 m carries water at the rate of 50 liters/s. The…

A: As per given question A pipe line AB of diameter 300 mm and of length 400 m carries water at the…

Q: The velocity profile of a liquid flows through the z direction of the vertical tube (figure right)…

A:

Q: For the system of pipes shown, the flow of water in pipe (3) is 25 L/s. Find: The flow in pipes (1)…

A:

Q: A horizontal nozzle discharges water into the atmosphere as shown in the figure. the relative…

A:

Q: The block of weight W = 50 N is pulled by a weight W0 = 60 N along the surface of a table by means…

A:

Q: contoured nozzle. In the test section, where the flow is straight and nearly uniform, a static…

A: Given that  to  = 25° C  Po  = 100 kPa  Vo  = 0  Gas constant = 287 kJ / kg K  Density of water =…

Q: Water flows through the 50 cm diameter pipe to which the static pressure gauge and mercury manometer…

A: Ans-8. 18cm

Q: V₁ X = 31 Figure Q3 The figure Q3 shows a 180° elbow. Oil enters this elbow at a speed of X m/s and…

A: Given:  entering speed of the oil: →V1=31 m/s Inlet area→A1=25 m2 Exit area→A2=10 m2 From the…

Q: Water at 10°C flows through the system shown in the figure below at 0.34 m/s. Energy loss in the…

A: