Calculate the voltage gain and output voltage,V0, for the following Op Amp circuit for figure 3.1 and 3.2. Please step-by-step I want to understand.

Q: The winding of a 3-phase, 6 pole, 60 cycle alternator has 2/3 pitch. What is the chording angle

A: Chording angle is defined as the angle by which pitch are shorted. A full pitch coil having zero…

Q: The circuit at right represents: D1 D2 a) flyback converter b) forward converter Uo c) half-bridge…

A: Given  A multiple choice question two identify the circuit diagram. Please find the below attachment…

Q: 1- A single phase transformer with a ratio of 6600/400 V takes to no-load current of 0-7 A at 0-24…

A: Since you have asked multiple questions in a single request, we will be answering only the 1st…

Q: _10. Determine the magnitude of the electric field intensity of an infinitely long, straight line…

A: Electric field due to a uniform line charge is determined by gauss law. It is inversely proportional…

Q: A circuit consists of a 12 V battery connected across a single resistor. If the current in the…

A:

Q: Consider the 2-bit carry-lookahead adder shown in the figure below. Which of the input and output…

A: In this question we need to choose a correct option

Q: Q2: What are the applications that can benefit from wireless networks and mobile communications?

A: These questions  are related to the applications  that are benefited from wireless networks and…

Q: Hw/find the transfer function when GI= 1 G = S+2 Gu= 5+2 %3D ノ S+1 HI= 1 S+1 H2 = S , H3 = 3 131 %3D…

A:

Q: Solve (Resistance): 3 resistors 3000 +5%, 500Q ±10% and 1.5kQ +0.5% connected in SERIES. Draw the…

A:

Q: Determine the reading on the meter when VCC = 10 V, RC = 5 kN, and IC = 1mA. Vcc Re O a. -5V O b.…

A: 44) Diode circuits, called limiters or clippers, are used to clip off portions of signal voltages…

Q: The outputs of combinatorial logic circuits are simply reliant on the inputs

A: In this question we will write about combinational logic circuits output....

Q: An 8-Pole 3-phase, Y-connected alternator running at 1200 rpm, has 12 slots per pole per phase, with…

A:

Q: 3 Decimal Places in the Final Answer: Find the ABCD constants of a pi-circuit having a 600-0…

A:

Q: 4. The non-attached end of a horizontal rope is oscillated vertically with a frequency of 8Hz. The…

A: Given,The frequency of the oscillations is,f=8 HzThe tension in the rope is,T= 78NThe linear density…

Q: Solve (Resistance): 3 resistors 3000 ±5%, 500N ±10% and 1.5kQ ±0.5% connected in PARALLEL. Draw the…

A: Given that three resistors are connected in parallel connection.R1=300Ω±5%R2=500Ω±10%R3=1.5Ω±0.5%The…

Q: Two single-stage capacitively coupled amplifiers like the one in the figure below are connected as a…

A: The circuit is as shown below,

Q: s+8 0.35z and C(z) Q3: For the system of Figure 1, given G(s): Find the closed-loop transfer…

A: 3) To find the close loop transfer function and characteristic equation of the system

Q: Determine the overall gain, Vo/V; of the circuit shown below. What value of V; will result in V, =…

A:

Q: ? Exhibits no energy gap between the valence and conduction Superconductors Insulators Conductors…

A: Energy gap between valency band and conduction band is around 5eV is for insulators   Energy gap…

Q: Calculate the CMRR in dB of opamp circuit with Vd=1.8 V, Vc=0.2 V, Ad=193 and Ac=2.

A: The op-amp circuit can be solved easily as shown below.

Q: 8. 7 1k2 D5 5V V2 오 Vo 10.0V 1kHz 0° R3 1k2 VGnd (+2

A: We need to find out the output voltage for given circuit

Q: Q4: A synchronous motor is receiving 35% of the power that it is capable of receiving from an…

A: When there a change in a loaf on synchronous Motor which is connected to infinite bus, it's power…

Q: An emitter-follower is also known as a Oa. common-base amplifier. O b. common-collector amplifier. O…

A:

Q: 4. Calculate a. Current in each resistor b. Voltage in each resistor c. Power in each resistor R1 R2…

A:

Q: Given a system represented by the following differential equation : * + 7*+20x + 50x = 5t a. Derive…

A:

Q: sap please with proper explanation

A:

Q: 1000MW thermal plant has an overall efficiency of 34%. If the coal used has a heating value of…

A: In this question we will find coal consumption of given plant per hour with given data..

Q: Both the Biot-Savart and Coulomb's laws exhibit an inverse-square relationship between field and…

A: magnetic field due to moving charge calculated using Biot savart law is B = (μo/4π) × idl(sinθ)/r^2…

Q: design an optimal controller to control the level of the spherical tank by using conventional…

A: Controller:  In control system, Controller is a device that receives input signals and compares this…

Q: When the rms output voltage of a bridge full-wave rectifier is 20 V, the peak inverse voltage across…

A:

Q: Q3/ Answer with true or false and correct the error if it is found in the following sentences: 1)…

A: These are the few basic questions related to the understanding of measuring instruments like…

Q: H.W: calculate the power dissipated in 60 resistor by using nodal method 8k 20k 5k 6k 5k 9V 9V

A: The kcl and kvl problem can be solved as below

Q: Compare between servo motor and universal motor

A:

Q: 4. Implement: JK and T flip-flops using D flip-flop D and T flip-flops using JK flip-flop

A:

Q: 1. Solve a. RT total resistance b. IT total current c. PT total power d. Current in each resistor e.…

A: In this question we need to find a current and power in each resistor.

Q: R= 3302 R= 470 2 R, = 820 2 R = 680 2 R= 560 2 R = 1202 E;= 48 V R1 R2 R3 R4 R5 R6 TOTAL VOLTAGE…

A:

Q: 6. For the logic circuit below complete the truth table. A D. 1 1 1 7. The output of a two input OR…

A:

Q: Q6: What are the main differences between the terms "Mobile" and "Wireless"?

A: We oftenly use Mobiles and wireless words interchangeably however there is a very slight difference…

Q: Q3// Answer the following questions: 1- What type of load should be connected to a transformer for…

A: These are the few questions related to the basic understanding of transformer and it's working.

Q: H.W: for the circuit shown in figure find: (a) the charge in each capacitor. (b) The total charge.…

A: In this question,  We need to determine the charge in each capacitor, total charge, equivalent…

Q: Find the solution for the potential in a dielectric region for which er=3, the potential ? is 30 V…

A: Using the Laplace equation for free space,  ∇2V=0 The relationship between the potential and the…

Q: If V, is 9V, find the following values Vp, Vn, Vo- 50 ka 20 ka 10 kn 40 kQ.

A:

Q: A 4MVA, 13.3kV, 60Hz, 3-phase, wye-connected alternator has an effective resistance of 5.2 ohm per…

A:

Q: Q3: Use the Source conversions nodal method to calculate the currents through each resister 3ohms…

A:

Q: Two wattmeter connected to a three phase 500v motor indicated the total input to be 10kw. The p.f.…

A: In this question we need to find a reading of two wattmeters.

Q: Lab report: Series VS Parallel Circuits Which circuit? Look at the 2 circuits below. I a. In which…

A: NOTE :- As per our company policy, only FIRST 3 sub-parts of a Question can be answered  at a time,…

Q: Q2/ Draw the following data formats for the bit stream [1 10011 0] (i) (ii) (iii) (iv) Polar NRZ…

A:

Q: 4. A 5-cm radius conducting sphere has a surface charge density of 2 x106 C/m? o its surface. Its…

A: In this question we will find electric potential due to surface charge density of sphere...

Q: +Vcc Vin V, Vo Vref Vy -Vcc Ry Rxl Fig. A2c: Inverting Schmitt-trigger circuit.

A:

Q: Find the relationship between the output and the input in the amplifier circuit depicted in Figure…

A: In this question,   We need to determine the output voltage Vo ?  We are solving this problem using…

Multistage Amplifier

The multistage amplifier is generally a voltage or power amplifier. The multistage amplifier has a number of single stage amplifier that are cascaded together. Since a single stage amplifier output is not useful, they are being replaced with multistage amplifiers or multistage transistor amplifiers. The multistage amplifier are used where the gain required is high or the input signal is very small such that only a single stage amplifier cannot amplify it.