capacitor has a reactance of 40 when operated on a 50 Hz supply. Determine the value of its capacitance. In a series R–L circuit the p.d. across the resistance R is 12V and the p.d. across the inductance L is 5V. Find the supply voltage and the phase angle between current and voltage

Q: Q8/A switch network has 3- inputs (A, C, D) and 3- output (F,G,W), the input is binary number and…

A: Given here the inputs are binary data and output is gray codes and asked to find outputs interms of…

Q: A three-phase 'abc' sequence Y-connected source supplies 14 kVA with a power factor of 0.75 lagging…

A:

Q: Find v₁ and vg in the circuit when v, equals 325 mV. (Hint: Start at the right end of the circuit…

A: Given circuit,

Q: 24 The initial value of f(t) is If F(s) s+4 s²+3s+2 The initial value of f(t) is......... 1 2 0 0.5…

A: Given: The transfer function, Fs=s+4s2+3s+2.

Q: Q6/F1-A'B'+B'C+ABC+A'C' F2=A'+B'C+A'C F3=B'+ABC F4=A'B+AB'C+A'BC' Chose the correct answer O F1=F3 O…

A:

Q: Q1/Find( (90)10/(36)8)* (F1)16+(1100111)2=( )Gray O 1000101100 O 1010100111 O None of them O…

A:

Q: A FM wave is represented by the following equation, V=9sin (5 x 10¹t +3sin1300t) Find: a) b) C)…

A: Given, A FM wave is represented by, V=9sin5×104t+3sin1300t  ....  (1).

Q: In a dielectric (σ = 10−4 S/m, μr = 1, εr = 4.5), the conduction current density is given as Jc =…

A: According to the data given σ = 10−4 S/m  μr = 1  εr = 4.5 Also, Jc = 0.4 cos(2π x 108 t) A/m2 Now,…

Q: A generating station is laid out as shown in Fig. 17.21. The ratings and per- centage reactances of…

A: We have an layout of generating station as shown in figure now it has three main parts, first one is…

Q: Q4/ The decimal 793.251)= ( number number ( O 1431.204 O 1431.200 O No one of them O 1341.200 O…

A:

Q: For the following system, if the input X[k]= 8(k + 1) + 2.4k and output Y[k]= 2(k)u[k], the impulse…

A:

Q: Write the mesh equations of this network in s-domain. Bring your soulution to the step of inverting…

A:

Q: Example 11.24. Varley loop test is performed to locate an earth fault on a 20 km long cable. The…

A: A varley loop test is performed to loccate an earth fault on  a 30 km long cable. We have been asked…

Q: 3. Three identical impedances ZA = 30/30° are connected in A to a balanced three-phase 208 V source…

A: Given:  Load impedance Z∆=30∠30° ΩLine-line source voltage VL-L= 208 VLine impedance ZL=0.3+j0.4 Ω…

Q: A A-connected source of is connected to a Y-connected load by means of a balanced three-phase…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: Task III: You were asked to evaluate the efficiency of a 5.5 kW motor that operates on a constant…

A: According to the question. The motor operates at a constant load. Output voltage, V0 = 380 Output…

Q: A three-phase motor is connected to a three-phase source with a line voltage of 440V. If the motor…

A: Given data, Line voltage VL=440 V. Total power, P=55 KW. Power factor, cosϕ=0.73.

Q: Q8/A switch network has 3- inputs (A, C, D) and 3- output (F,G,W), the input is binary number and…

A:

Q: 2. For the given first order system compute a) The time constant T and the system gain k b) The…

A:

Q: Q5/Find the addition result for the following operation (66)8+ (1100)EX-3+(83)10- (F2.1)16 using 2's…

A: Given- F= F= 668+1100EX-3+8310-F2.116 To find- Using two's complement find given operation addition=…

Q: A three-phase motor is connected to a three-phase source with a line voltage of 440V. If the motor…

A: Given data, Total power P=55 KW=55000 W Line voltage VL=440 V Power factor cosϕ=0.73

Q: 5. RC Circuit I (Step Response): Determine and draw V2(t) (ENGINEERING DRAWING!) v, (+) lok M $ озит…

A:

Q: The value of Ic and VCE At the Q point for following circuit if oc=200 VBB 15V RB ww 47 ΚΩ Rc • 330…

A: Given, The circuit is, And βDC=200.

Q: Q1/Find( (90)10/(36)8)* (F1)16+(1100111)2=( )Gray O 1000101100 O110100111 O None of them O…

A:

Q: 1. Shift registers can operate in both serial and parallel modes. List all four possible…

A:

Q: Why do we need to have an Exciter in a complete set-up of an Alternator system operations? Explain…

A: An exciter is mandatory in the alternator system as alternator is not able to generate the required…

Q: In free space,                                   H = 10 sin(108 t + βx)ay A/m.Find E and β.

A: Given data: The magnetic field intensity H=10sin108t+βxay A/m

Q: 3. Conditions: A feeder with 250A of noncontinuous load and 60A of continuous load to be installed…

A: Given information, The feeder has 250 A of noncontinuous load and 60 A of continuous load. The…

Q: 6 similar amplifiers are cascaded, with lower cut-off frequency 100Hz. Bandwidth is B1=10 kHz. What…

A:

Q: 12.00 VDD 12V ov 2.000V R1 www 100k Vi* 2V- 31. 2 082 + UA741081 VSS 69.26uV alif $12.00V 12V S RF…

A:

Q: Quiz A.9 Consider a buck voltage regulator with duty cycle D=65% and Vi=7V The output voltage is:…

A:

Q: 4 Find the F.T. of the following Signals using differentiation prop. <<-2 2 +t 4 (sin² (w) - 2 Sinc…

A:

Q: Q-3 Consider the circuit below and answer the following questions: V₂ V₁ R₁ I₁ R3 + 3.2. Calculate…

A: According to Thevenin's Theorem, every linear circuit can be made simpler by using a single voltage…

Q: Given:μ = 1200 The core has square cross section and all dimension are in cm. 10 A 1² N₁ 500 turns…

A:

Q: + % t=0 R₁ www R₂ C₂ The value of v(t) for t> 0 is + v(t) The circuit in the given figure is the…

A: For t&gt;0,C1=0.5μFC2=5μFR1=5MΩR2=2.6MΩV0=60ut v.

Q: Q6/F1-A'B'+B'C+ABC+A'C' F2=A'+B'C+A'C F3=B'+ABC F4=A'B+AB'C+A'BC' Chose the correct answer O F1=F3 O…

A:

Q: Q- A 30 KVA, 2500/230 transformers has leakage impedance of 8%. Find the voltage to be applied on hV…

A:

Q: e) Determine the value of percent overshoot (%OS).

A: It is given that:

Q: R5 Ω - - Ε 0 + 18 V + ΖΩ Με R3 RS6Ω Vi R₁ α + RA ΣΩΚ = [2] -6V 1

A: I am giving answer of first question as per guidelines.

Q: Using nodal analysis, find U₁ and U₂ in the circuit of Fig. 10.3. 30 sin 2t A Figure 10.3 292 0.2 F…

A:

Q: Find the currents in each branch and the value of voltage source V for the networ below. 1-50 A 20⁰…

A:

Q: The Thevenin impedance seen from load terminals is 80+j 55 2. For maximum power transfer, the load…

A: Given, Thevenin's impedance seen from load terminal, Zth=80+j55 Ω.

Q: Transmitter: a carrier frequency of 108 kHz and a modulating frequency of 3.4 kHz is plied to an…

A:

Q: Q9/G(A,B,C,D,E,F)=(2,3,5,7,22 ,23,32,33,34,35,37,39,52,53,54 ,55)+ dΣ(8,9,10,11,16,17,18,19,60,6…

A:

Q: Check whether the following fields are genuine EM fields (i.e., they satisfy Maxwell's equa- tions).…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: Which mode of wave propagation is suitable for television broadcast and satellite communication, and…

A: Categorization of Modes of wave propagation on the basis of signal type: Transverse Electric and…

Q: Consider a unity feedback control system whose open- loop transfer function is 1 s² +0.8s + 1 G₁ (S)…

A:

Q: There are 160 slots in a 3-phase, 8-pole, 50 Hz., star connected alternator. There are 4 conductors…

A:

Q: Find the current go through resister R3 05 A 3 0 ن ان 0 10 3 0 10 3

A: The required parameter can be calculated by using the current division rule after reducing the R1…

Q: Why are high frequency carrier waves used for transmission?

A: The wave with the modified frequency and amplitude received by the transmitter to carry signals from…

HVDC

HVDC stands for high voltage direct current in the electric power transmission system. The high voltage direct current system uses direct current (DC) for the transmission of electrical power through transmission lines in contrast with the alternating current that is the AC system. The HVDC is used to transmit bulk power point-to-point through long distances transmission lines. Power is rapidly transferred because the efficiency of transmission lines is greatly increased over long distances due to HVDC lines.