che specific heat capacity of th

Q: There is a difference in acidity of the hydrogens labeled red below. Select all the distinguishing f...

A:

Q: Classify each substituent as activating or deactivating. -OCH3 -OH -Cl -NO2 -CO2H

A: In the aromatic  electrophilic  substitution,the group  which increases the rate of reaction, are ca...

Q: the following solution a buffer? Each solution was prepared by mixing and diluting appropriate quant...

A: Concept is based on buffer preparation:

Q: Wine goes bad soon after opening because the ethanol (CH,CH,OH) dissolved in it reacts with oxygen g...

A: Moles of O2 = 0.050 mole  

Q: The equilibrium reaction equation is below: CO(g) + Cl2(g) = COC1»(g) In this gas-phase reaction, ca...

A:

Q: b)

A: An alkene is carbon double bond carbon with 2 hydrogen on each carbon. A substitution replaces H wit...

Q: 11. Based on this reaction in acidic solution, explain and show the steps for balancing a chemical e...

A: HBr(aq) + H2SO4(aq) -----> SO2(g) + Br2(g)

Q: An aqueous solution of calcium hydroxide is standardized by titration with a 0.103 M solution of hyd...

A:

Q: The chemical formula for barium oxide is BaO. A chemist determined by measurements that 0.035 moles ...

A: Due to technical error ,unable to provide you the solution. Please resubmit the question once agai

Q: A. Solubility of Solids in Liquids Put equally small amount (1/2 teaspoon) of the substances listed ...

A:

Q: 4.) Given the reaction: PCI3(g) + C2(g) = PCI5(g) Kc = 24.3 Suppose the system at that particular te...

A:

Q: calculate the required amount (in g) of ammonium sulfate to bring the solution from 40% to 60% satur...

A: Initial concentration = 40%

Q: What is the pH of a solution containing 1.316 mol L-1 of a weak acid with pKA = 7.47 and 0.521 mol L...

A:

Q: What quantity in moles of KBr are there in 31.5 mL of 0.150 M KBr?

A: Mole, can be defined as a standard  unit for measuring large quantities of very small entities such ...

Q: Titration Calculation Practice 5 1. Hydrofluoric acid has a K, of 6.6 x 104, Calculate the pH at the...

A:

Q: How can the matrix effects affect the determination of Calcium in seawater by using AAS

A: A question based on analytical process that is to be accomplished.

Q: Boiling point elevation (AT) for 0.1M solution of NaCl is a. Equal to that of 0.1 M sugar solution b...

A: ANSWER : 1) b  and 2) b  

Q: Which of the following will always result in AU > 0? O work done on the system, heat released by the...

A:

Q: In the smelting of iron ores, the reduction of iron oxides in a blast furnace is accompanied by the ...

A: GIVEN :- Reaction (1): 3 Fe₂O3(s) + CO(g) -----> 2Fe3O4 (s) + CO₂(g)   Reaction (ii): Fe3O4 (s) +...

Q: grams of PbBr, w

A:

Q: What is the major product when cyclohexanone is reacted with ammonia and trace acid? NNH, NCH, NH2 N...

A:

Q: what is the absolute uncertainty and relative uncertainty of your mass value of PbSO4 obtained by su...

A: Absolute Uncertainty - the outright vulnerability is the number which, when joined with a detailed w...

Q: How the pH epectrode recognize the sample being measured? Explain thoroughly.

A:

Q: 5. What is the IUPAC name? 2,2,4 - trimethylpent - 4 - ene O 2,2,4 - trimethylpent - 1 - ene 2,4,4 -...

A:

Q: What volume in mL of 0.3000 M NaI solution is required to produce 0.1700 moles of NaI?

A: Molarity is a concentration term for a solution. The molarity of a given solution is defined as the ...

Q: A chemist carefully measures the amount of heat needed to raise the temperature of a 500.0 mg sample...

A:

Q: The following figure represents the emission spectrum of a hydrogenlike ion (Z is not 1 but has one ...

A:

Q: What percentage of the mixture was CaSO4 if a 4.550g solid mixgure containing CaSO4 is dissolved in ...

A: The mass of the CaSO4 sample is =  4.550 g The mass of BaSO4 precipitate is = 0.6168 g The percent o...

Q: 9. What is oxidation? What is reduction? Explain the modern understanding of each of these terms and...

A: Oxidation: The reaction in which loss of electron takes place or Oxidation state of atom or ion incr...

Q: The chemical formula for barium oxide is Bao. A chemist determined by measurements that 0.035 moles ...

A:

Q: Fornic acid, HCO2, is the iritant that causes the body's reaction to ant stings. What is the concent...

A: Concentration of formic acid = 0.53 M  Ka = 1.8 × 10-9

Q: Consider the SuIfhydride ion, sH ion, SH- a Draw the mdlecular orbital diagram for this Pon. Use onl...

A:

Q: The chemical structure of ethylene glycol ((CH), (OH)2) is shown below. Highlight each atom that is ...

A: The methylene group is a group  where two hydrogen  are bonded to carbon atom and the carbon is bond...

Q: Answer all questions 01. a) In the two bioplastic films, determine which one has the highest tensile...

A: Due to technical error ,unable to provide you the solution. Please resubmit the question once again 

Q: H.

A:

Q: 4. Enumerate the differences between a serological and a volumetric pipette. 5. Enumerate the uses, ...

A: Pipettes are one of the most important instruments in the analytical measurements that help us in me...

Q: Which of the following physical processes is exothermic? a. evaporation of alcohol b. melting of i...

A: Concept  1) release of energy is known as exothermic process.  2) absorption of energy is called end...

Q: 3. Nitrogen monoxide (NO) is an intermediate product in the production of nitric acid from ammonia (...

A:

Q: Identify the following pericyclic reaction; explain the course, product distribution and stereochemi...

A: To identify the pericyclic reaction, explain the the course, product distribution and stereochemistr...

Q: Nitrogen monoxide (NO) is an intermediate product in the production of nitric acid from ammonia (NH3...

A:

Q: ive AG and which requires no added work for the reaction to pro

A: Spontaneous is the process which occur without any external source. For Spontaneous reaction,  the G...

Q: Calcium oxalate monohydrate [Ca(O2CCO2)·H2O, also written as CaC2O4·H2O] is a sparingly soluble salt...

A: Solubility of calcium oxlate in water = 7.36 × 10−4 g/100 mL.  Ksp   = ?  Molecular mass of CaC2O4 ....

Q: A mixture of gaseous reactants is put into a cylinder, where a chemical reaction turns them into gas...

A:

Q: 2p- n-bond H H. sp2 o-bond 1 How many covalent bonds do you see in the picture? O 1 2 How many type/...

A:

Q: Please explain the mechanism of the following reaction and explain why the epoxide is formed at that...

A:

Q: Given any of the factors temperature, catalyst, or concentration-explain in terms of collision theor...

A: Collision theory - - collision theory explains that to occur a chemical reaction the reactants must ...

Q: What is the sum of the coefficients of the following equation when it is balanced using smallest who...

A:

Q: Let's spend some time with this reaction of NO2, an important compound in atmospheric chemistry (it'...

A:

Q: The illustration to the left represents a mixture of nitrogen ( blue ) and oxygen ( red ) molecules....

A: The balanced chemical equation fot the reaction of Nitrogen gas and oxygen gas is,       N2   +   2 ...

Q: What is the total number of oxygen atoms on the right-hand side of this chemical equation? 2 Cr(CO),...

A:

Polymerization Kinetics

Polymerization is a chemical process in which one or more monomers combine to produce a very large chain-like molecule called a polymer. The functional groups present on the monomers and their steric effects are responsible for polymerization through a sequence of reactions that diverge in complexity. There exists a stable covalent chemical bond between monomers that sets apart polymerization from other processes. Polymerization is generally classified into step-growth and chain polymerization. Polymers are categorized into linear polymer and cross-linked polymers that are produced either by condensation or additional polymerization.