Choose the right answer 1. The mean Nusselt number for fully developed laminar flow in a circular tube under a constant heat flux a. depends on Reynolds number b. depends on Prandtl number c. is constant 2. The value of Prandtl number for air is about а. О.1 b. 0.3 с. 0.7 3. In natural convection heat transfer, the Nusselt number is a function of a. Re and Pr b. Re and Gr c. Grand Pr 4. A fluid is flowing along a plate having a high uniform wall temperature. The heat transfer along the length a. decreases b. remain constant c. increases

Choose the right answer 1. The mean Nusselt number for fully developed laminar flow in a circular tube under a constant heat flux a. depends on Reynolds number b. depends on Prandtl number c. is constant 2. The value of Prandtl number for air is about а. О.1 b. 0.3 с. 0.7 3. In natural convection heat transfer, the Nusselt number is a function of a. Re and Pr b. Re and Gr c. Grand Pr 4. A fluid is flowing along a plate having a high uniform wall temperature. The heat transfer along the length a. decreases b. remain constant c. increases

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter9: Heat Transfer With Phase Change

Section: Chapter Questions

Problem 9.20P

See similar textbooks

Similar questions

6.1 Determine the heat transfer coefficient at the stagnation point and the average value of the heat transfer coefficient for a single 5-cm-OD, 60-cm-long tube in cross-flow. The temperature of the tube surface is , the velocity of the fluid flowing perpendicular to the tube axis is 6 m/s, and the temperature of the fluid is . Consider the following fluids: (a) air, (b) hydrogen, and (c) water.
7.43 Liquid sodium is to be heated from 500 K to 600 K by passing it at a flow rate of 5.0 kg/s through a 5-cmID tube whose surface is maintained at 620 K. What length of tube is required?
5.7 The average Reynolds number for air passing in turbulent flow over a 2-m-long, flat plate is . Under these conditions, the average Nusselt number was found to be equal to 4150. Determine the average heat transfer coefficient for an oil having thermal properties similar to those in Appendix 2, Table 18, at at the same Reynolds number and flowing over the same plate.
Air (1 atm) enters into a 5-cm-diameter circular tube at 20°C with an average velocity of 5 m/s. The tube wall is maintained at a constant surface temperature of 160°C, and the outlet mean temperature is 80°C. Estimate the length of the tube.
What is the ratio of total convective heat transfer rate to laminar convective heat transfer rate for the flow over 2 m length flat plate if 10 m/s air velocity is observed? For air: ν = 20x10-6 m2/s
Estimate the mass-transfer coefficient for moist air flowing normal to a 25 mm diameter tube (Nu = 0.615 Re0.47). The air velocity is 0.5 m/s. Assume standard air.
Air at 1 atmosphere and a temperature of 60f enters 1/2-in. id tube with a velocity of 80 fps. The wall is maintained at a constant temperature of 210 by condensing steam. Fin the convective heat-transfer coefficient for this situation if the tube is 5ft long
Air at atmospheric pressure and 25oC is heated in a tube with an ID of 25 mm. The tube wall is maintained at a temperature of 200oC. What length of tube is required to achieve an outlet air temperature of 120oC if the air flow is 10 Nm3/hr?
1) Atmospheric air at 25oC and with a speed of 50 m/s is pumped by a fan over a flat plate. a)What is the minimum plate length in order to achieve a Reynolds number of 108 ? b)At what distance from the leading edge would transition occur if critical Re #= 5x105 ? 2) Local Nusselt number is given as Nux=0.04Rex0.9 Pr 1/3. Obtain an expression for, a) average heat transfer coefficient, x b) local heat transfer coefficient, hx c) What is the ratio of the average to local coefficient, x / hx 3) Air is in parallel flow over a flat heater surface which is to be maintained at 140oC. Airflow induces a drag force of 0.25 N on the heater. What is the electrical power needed to maintain the prescribed surface temperature? 4) Air at 1 atm with a velocity of 4 m/s and a temperature of 50oC flows over a flat plate that is at a uniform temperature of 100oC. The plate has a length of 0.20 m and a width of 0.1 m. a) What is the average heat…
Engine oil flows through a 25-mm-diameter tube at a rate of 0.5 kg/s. The oil enters the tube at a temperature of 25°C, while the tube surface temperature is maintained at 100°C. (a) Determine the oil outlet temperature for a 5-m and for a 100-m long tube. For each case, compare the log mean temperature difference to the arithmetic mean temperature difference.