Choosing a discrete value that is near but not exactly at the analog signal level leads to Select one: a. PCM error b. Quantization error c. PAM error d. Sampling error Next page

Q: . Determine the truth table of the digital circuit shown in the figure below explain its operation.…

A:

Q: Q5: a) Design a F.A with a decoder b) Design Hexadecimal to Binary Encoder.

A:

Q: Q2/ show how an asynchronous counter can be implemented having modulus eleven with a stright binary…

A: A counter is a sequential circuit whose state represents the number of clock pulses fed to the…

Q: Explain the working principle of the incremental optical encoder *Mention its use/application and…

A: Electrical devices are used for measuring electrical parameters. Current, voltage, and power are…

Q: Briefly explain the advantages and disadvantages of multiplexer

A: Given  Note :    It is the kind notice that according to the guidelines of the company if the parts…

Q: B) Design an Octal-to-Binary (8-to-3) Encoder, and then draw a block diagram for Octal-to- Binary…

A:

Q: Why does base bias produce such an unstable Q point?

A: According to the question we have to discuss, why does base bias produce such an unstable Q point?

Q: 1. What is the difference between synchronous binary counter and asynchronous binary counter?

A: Note:Dear student here you have posted multiple question in sigle request.We will solve first…

Q: 2- Design with drawing an octal-to-binary Encoder ?

A:

Q: 17.1 What are the keys to a successful mixed-signal PCB layout?

A: Types of PCB  Single layer PCB Multi Layer PCB High frequency PCB Double layer PCB HDI layer PCB…

Q: Q3) A baseband signal varies between -2 and 12 Volts is to be transformed to binary digital form,…

A: Bit rate Rb=n fs      56 kb=n14 KHz    n=4 bits(a) No of quantisation levels = 2n=24=16 levels

Q: b) Design Hexadecimal to Binary Encoder.

A: Hexadecimal to Binary Encoder

Q: How are binary values represented in amplitude shift keying, and what is the limitation of this…

A: The explanation is as follows.

Q: Explain why we need both Analogy as well as Digital signals? Also elaborate the process of…

A: The continuous range of the values is used by the analog signals, which show the information…

Q: Why is the Nyquist sampling theorem important in analogue to digital conversion? It defines the…

A:

Q: Briefly describe Register Transfer Structure in RTL.

A: Register is an inconceivably expedient PC memory, used to store information/bearing in-execution.  A…

Q: Q5/ The information in an analog waveform with maximum frequency fm = 3 KHz is to be transmitted…

A:

Q: The circuit that converts continuous signal into 'n' bit binary number  is called as ___________.…

A: Given To determine which circuit converts continuous signal into n bit binary number

Q: Q.4. Draw and show the BPSK modulation waveform for the given binary data sequence "1,1,0,0", and…

A: Binary Phase Shift Keying (BPSK): The phase of the carrier wave is modulated by the binary symbols…

Q: Design with drawing an octal-to-binary Encoder ?

A:

Q: be the Sampling PCM system is 60000HZ and the maximum number that represents cach sample is 15?

A: Given parameters are: The maximum Bandwidth of a PCM system is BWmax=60000Hz The number of…

Q: Example Assuming that a 3-bit ADC channel accepts analog input ranging from 0 to 5volts, determine…

A:

Q: 1-The dc source supplying an inverter with a bipolar PWM output is 96 V. The load is an RL series…

A: Bartleby has policy to solve only first question. Reupload the second question.

Q: In a PCM system, channels of 3 KHz bandwidth are used. If the uniform quantizer has 128 number of…

A: Channel capacity is defined is the maximum amount of data rate at which information can be reliably…

Q: Explain why we need both Analogue as well as Digital Signals? Also, elaborate the process of…

A: Generally we have two types of signals analogue and digital signals.Both the signals are used to…

Q: b) Briefly describe the function of an encoder. You may use a 4 to 2 decoder to explain the…

A:

Q: A frequency counter is gated on for 10 ms and counts 540 pulses from a periodic input signal . What…

A: Frequency counter is an electronic device used to measure frequency of a signal. Counter in the…

Q: Draw the bus cycle of 8086 mp?

A: The bus cycle of 8086 mp

Q: 1-The dc source supplying an inverter with a bipolar PWM output is 96 V. The load is an RL series…

A: a V1 is the fundamental frequency output     Vdl is  the input dc voltage     V1=2 Vrms=2 54=76.367V…

Q: (b) Briefly explain the key principle behind the Successive Approximation Convertor in how it goes…

A: Principle and working of SAR type ADC 1) SAR is one of the most widely used types of ADC. Here bits…

Q: 9. For the circuit shown in Figure Bl19a, Ve- 20V Rc = 3ko RB = 10k 2 VCE VBB-3V Figure B19a i)…

A:

Q: What do you mean by fractional sampling rate conversion? Explain with an example of converting 48…

A: Sample rate converter is the change stream of discrete sample from another different sample rate. In…

Q: 2. With neat diagram explain the construction and working principle of Encoder

A: Fig: Diagram of encoder

Q: Q7: An analog signal is quantized and transmitted by using PCM system. If each sample at the…

A: Let 2mp ne the peak to peak value of the signal. The peak error is  0.0052mp=0.01mp The peak to peak…

Q: Write an HDL behavioral description of a BCD-to-excess-3 converter.

A: In the BCD to excess 3 code converter the binary value of 3 is added with the BCD value to get the…

Q: Please describe as simply as possible in detail, what a multiplexer circuit is, how it works. Please…

A:

Q: 1. Draw AM modulator Block Diagram 2. Draw all the signals 3. Write the equation for Modulating…

A:

Q: What is difference between * ?Decoder and Encoder

A: Encoder: The encoder circuit is introduced at the communicating end.An Encoder is a gadget that…

Q: If an 8-bit SAR ADC is used to digitize 8V full scale signal, what will be the digital o/p for an…

A: For SAR type ADC we have Resolution=Full scale voltage2n-1 Here n=8, full scale voltage=8V…

Q: a. Determine Re, RB , and RE b. Draw the load line and determine Q point. c. Sketch the output…

A: Thee given circuit is : ICQ=0.25ICsat ICQ=0.25.8mA ICQ=4mA (a)…

Q: A) setup a scheme for accomplishing this multiplexing requirement B) what must be the speed of the…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: Identify the process of dividing a voltage range into discrete increments, each of which is…

A: The main object of Analog to Digital conversion is to convert the analog signal into a digital…

Q: Vcc-5v Vo Determine the truth table of the digital circuit shown in the figure below and explain its…

A:

Q: What is difference between ?Decoder and Encoder

A: Encoder: An Encoder is a gadget that changes over the dynamic information signal into a coded…

Q: For a binary pcm, if the number of bits per sample is 8, then estimate the signal to quantization…

A: Given information: For the pulse code modulated system, the number of bits transmitted per sample is…

Q: Design BCD to Seven Segment Decoder. Draw circuit diagram using Basic Gate only.

A: - Designing of BCD to seven section show decoder circuit basically includes four stages in a…

Q: Define and explain the difference between analogue and digital signals elaborating on the advantages…

A: Brief description: In the above given question they want to know the definition and difference…

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.