ClampStandFigure 14 Leave the knife-edge of the first clamp at the center of mass of the stick and on the fulcrum.Place the second clamp with a hanging mass of 100 g at the 5.0 cm mark (Figure 2). Find thelocation of the third clamp on the stick with a hanging mass of 150 g that will balance thestick.=390mП.1020304050Figure 269100 g150 g Data Analysis:1. For procedure (4), calculate the position of the third clamp using the second condition forequilibrium and compare with the experimental result by finding the percent difference.The% difference =expttheox100%avg

Answered: Image /qna-images/answer/b232ae67-0e39-45f5-943f-379772a0e634.jpg

Answered: Clamp Stand Figure 1 4 Leave the…

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter8: Rotational Motion

Section: Chapter Questions

Problem 100A

See similar textbooks

Similar questions

The forearm shown below is positioned at an angle with respect to the upper arm , and a 5.0- kg mass is held in the hand. The total mass of the forearm and hand is 3.0 kg, and their center of mass is 15.0 cm from the elbow. (a) What is the magnitude of the force that the biceps muscle exerts on the forearm for =60 ? (b) What is the magnitude of the force on the elbow joint for the same angle? (c) How do these forces depend on the angle ?
A board of mass mand length l is attached to a wall and a rope that makes an angle of theta, as shown. A block of mass M hangs from the right end of the board. 1. Using variables, write Newton’s 2nd law in the x-direction.Hint: You can leave the hinge force as Fhinge x. 2. Using variables, write Newton’s 2nd law in the x-direction.Hint: You can leave the hinge force as Fhinge y.
A little league player balances a bat 65.0 cm from one end. She then hangs her 0.540-kg batting helmet on that end of the bat and the balance point moves 24.5 cm toward the helmet. Determine the mass of the bat. kg
077184RK Fy: Fsin 30 fx .1- Four forçes act on bolt A as shown. Determine the resultant of the force on Le bolt. F=150 N FR 30 OLUTION: Resolve each force into rectangular P=100 N components. Determine the components of the resultant by adding the corresponding x a force components. Calculate the magnitude and direction of the resultant. 1- 0= tanil fy -Im *- comp y-comp mag
Q7. For the Biomechanics experiment, use the diagram shown below, if Weight= 1.96 N, rw= 49.5 cm, rf= 9.5cm Find:- A. force by the sensor. B. the torque in counterclockwise C. the torque clockwise. Elbow Hinge TF "Fulcrum" Biceps turnbuckle under tension O Tw O Elbow (Fulcrum) O Biceps muscle under tension, 7 Weight
A board of mass mand length l is attached to a wall and a rope that makes an angle of theta, as shown. A block of mass M hangs from the right end of the board. a. Draw and label all the forcesacting on the board, keeping track of where each force is applied, in the diagram below.Hint: The hinge exerts a force Fhinge on the beam. b. Using variables, write a sum of torques equation with the hinge selected as the pivot location.
A meter stick is found to balance at the 49.7-cm mark whenplaced on a fulcrum. When a 50.0-gram mass is attached atthe 10.0-cm mark, the fulcrum must be moved to the 39.2-cmmark for balance. What is the mass of the meter stick?
Bobina and Bob are on the seesaw down at the elementary school playground and decide to see if they can move to the correct location to make the seesaw balance. Boina weighs 400. N and sits 2.00 m from the fulcrum. Where should bob sit to balance the seesaw? Bob weighs 450. N.
A heavy boy and a light girl are balanced on a massless seesaw. If they both move forward so that they are one-half their original distance from the pivot point, what will happen to the seesaw? a. The side the boy is sitting on will tilt downward b. Nothing, the seesaw will still be balanced It is impossible to say without knowing the masses and the С. distnces
The (180 N) force is applied to the end of the body OAB. If 0-50 determined the equivalent force couple system of the shaft axis O. B 120 mm 8 F = 180 N I L OF=-169.1 i-61.6j N, M=41.9 N.m CCW OF=169.1 i+61.6j N, M=41.9 N.m CW OF=201.1 i-61.6k N, M-41.9 N.m CCW 30° A 150 mm
A square metal plate 0.180 m on each side is pivoted about an axis through point O at its center and perpendicular to the plate (Figure 1). Figure 0.180 m 0.180 m 450 Fi 1 of 11 Part A Calculate the net torque about this axis due to the three forces shown in the figure if the magnitudes of the forces are F-250 N. P-170 N, and Fy-15.5 N. The plate and all forces are in the plane of the page. Take positive torques to be counterclockwise Express your answer in newton-meters. TH Submit WVGI ΑΣΦΑ Provide Feedback 5 Bequest Answer Pearson Constacts N-m Next >
A little league player balances a bat 67.0 cm from one end. She then hangs her 0.540-kg batting helmet on that end of the bat and the balance point moves 24.0 cm toward the helmet. Determine the mass of the bat.

SEE MORE QUESTIONS

Recommended textbooks for you

Glencoe Physics: Principles and Problems, Student…

Physics

ISBN:

9780078807213

Author:

Paul W. Zitzewitz

Publisher:

Glencoe/McGraw-Hill

University Physics Volume 1

Physics

ISBN:

9781938168277

Author:

William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:

OpenStax - Rice University

Physics for Scientists and Engineers, Technology …

Physics

ISBN:

9781305116399

Author:

Raymond A. Serway, John W. Jewett

Publisher:

Cengage Learning

Glencoe Physics: Principles and Problems, Student…

Physics

ISBN:

9780078807213

Author:

Paul W. Zitzewitz

Publisher:

Glencoe/McGraw-Hill

University Physics Volume 1

Physics

ISBN:

9781938168277

Author:

William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:

OpenStax - Rice University

Physics for Scientists and Engineers, Technology …

Physics

ISBN:

9781305116399

Author:

Raymond A. Serway, John W. Jewett

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS