co-spot of carbonyl & alcohol compounds A 0 Your alcohol product, B (obtained from the NaBH4 reduction reaction of the carbonyl starting material, A) is purified by column chromatography. You obtain the following TLC of the column chromatography fractions. 000 1 TLC Chromatography Fractions 2 0- NaBH4 MeOH H₂O 0 3₂ 0 0 0 1 4 5 B 6 0-1 q OH 7 1.8 cm 2.8 cm 3.2 cm

co-spot of carbonyl & alcohol compounds A 0 Your alcohol product, B (obtained from the NaBH4 reduction reaction of the carbonyl starting material, A) is purified by column chromatography. You obtain the following TLC of the column chromatography fractions. 000 1 TLC Chromatography Fractions 2 0- NaBH4 MeOH H₂O 0 3₂ 0 0 0 1 4 5 B 6 0-1 q OH 7 1.8 cm 2.8 cm 3.2 cm

Principles of Instrumental Analysis

7th Edition

ISBN:9781305577213

Author:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Publisher:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Chapter28: High-performance Liquid Chromatography

Section: Chapter Questions

Problem 28.19QAP

See similar textbooks

Similar questions

In comparing direct headspace injections with SPMEheadspace injections, later eluting peaks (by GC) arelarger in SPME. Explain why.
How complexation of diclofenac sodium with hydroxy propyl beta-cyclodextrin by high pressure liquid chromatographic (HPLC) method can enhance the solubility of diclofenac sodium.
The ethyl acetate concentration in an alcoholic solution was determined by diluting a 10.00-mL sample to 100.00 mL. A 20.00-mL portion of the diluted solution was refluxed with 40.00 mL of 0.04672 M KOH:CH3COOC2H5 + OH- → CH3COO- + C2H5OHAfter cooling, the excess OH2 was back-titrated with 3.41 mL of 0.05042 M H2SO4. Calculate theamount of ethyl acetate (88.11 g/mol) in the original sample in grams
Earth, a CHEM 40.1 student, extracted a mixture of pigments from the roots of Rubiatinctorum, commonly known as rose madder. Earth spotted the root extract on twohydrophobic silica gel plates. He then placed each plate in separate developing chambers,one containing solvent system WHITE and the other housing solvent system MIX. Earthallowed the chromatograms to develop for around five minutes. Afterwards, he removedthe plates from the containers and placed them inside an iodine chamber. Thechromatograms resulting from the TLC experiment after visualization are illustrated asfollows. The distances travelled by each spot and by the solvents were measured andrecorded in the displayed table.
Thin‑layer chromatography (TLC) can be used as a preliminary identification method for many amphetamine‑type stimulants (ATS). Using a 0.25 mm thick silica gel stationary phase and a 98.5:1.5 methanol:concentrated ammonia mobile phase, a spot was observed to have traveled 3.52 cm when the solvent front traveled 8.81 cm. What is the retardation factor (?F)for the compound that composes this spot?
Next, 2.00 mL of 9.63 mM S was added to 10.00 mL of a solution of unknown concentration of X, and the mixture was diluted to 25.0mL. Chromatographic analysis of this solution produced peak areas of 4822 for X and 4099 for S. What was the concentration of 5 (in mM) of the 25.0mL solution?
Upon screening with TLC (made of silica gel) chromatography using hexane/chloroform (3:1) as eluting solution, 3 spotswere detected corresponding to a (A) polyphenol, a (B) tannin and an (C) alkaloid. If the TLC chromatogram in the picture was duplicated but using a column, draw the set-up and label approximate spots.
A series of nonpolar aromatic compounds were separated by isocratic HPLC on a nonpolar stationary phase containing octadecyl groups [−(CH2)17CH3] covalently attached to silica particles. The mobile phase was 60/40 methanol/water. How would the retention times be affected if 90/10 methanol/water were used instead and why? What type of chromatography?
A 5.00-mL sample of blood was treated with trichloroacetic acid to precipitate proteins. After centrifugation, the resulting solution was brought to pH 3 and extracted with two 5-mL portions of methyl isobutyl ketone containing the lead-complexing agent APCD. The extract was aspirated directly into an air/acetylene flame and yielded an absorbance of 0.569 at 283.3 nm. Five-milliliter aliquots of standard solutions containing 0.400 and 0.600 ppm of lead were treated in the same way and yielded absorbances of 0.396 and 0.599. Please calculate the concentration of lead in the sample in ppm.
What mode of chromatographic separation (RPLC, NPLC, HILIC, SEC, IEX) is best used for the Separation of conopeptides from marine snails? What stationary phase and mobile phase (together with elution technique), and other chromatographic conditions needed?
A 5.00-mL sample of blood was treated with trichloroacetic acid to precipitate proteins. After centrifugation, the resulting solution was brought to pH 3 and extracted with two 5-mL portions of methyl isobutyl ketone containing the lead-complexing agent APCD. The extract was aspirated directly into an air/acetylene flame and yielded an absorbance of 0.527 at 283.3 nm. Five-milliliter aliquots of standard solutions containing 0.400 and 0.600 ppm of lead were treated in the same way and yielded absorbances of 0.396 and 0.599. Find the concentration of lead in the sample in ppm assuming that Beer’s law is followed.
A 50.0 mL juice extract is colorimetrically assayed using Nelson’s test. One milliliter (1.00 mL) of the solution and the standard glucose solution (concentration: 1mg/mL) were treated with freshly prepared Nelson’s reagent and arsenomolybdate reagent and then diluted to 10.0 mL separately in properly labeled test tubes. Absorbance at 480 nm for the standard is 1.702 and for the sample, 0.926. Calculate the concentration of the reducing sugar in the 50.0 mL sample in mg/mL. Apply Beer-Lambert’s law: A=bc.