A 5.00-mL sample of blood was treated with trichloroacetic acid to precipitate proteins. After centrifugation, the resulting solution was brought to pH 3 and extracted with two 5-mL portions of methyl isobutyl ketone containing the lead-complexing agent APCD. The extract was aspirated directly into an air/acetylene flame and yielded an absorbance of 0.527 at 283.3 nm. Five-milliliter aliquots of standard solutions containing 0.400 and 0.600 ppm of lead were treated in the same way and yielded absorbances of 0.396 and 0.599. Find the concentration of lead in the sample in ppm assuming that Beer’s law is followed.

Q: The copper in an aqueous sample was determined by atomic absorption flame spectrometry. First, 10.0…

A: Here we have to plot the graph based on standard addition. Given the copper concentration of the…

Q: 1 2 3 TEST TUBE 4 5 Blank Unknown solution Volume 0.52 M Fe₂(SO4)3 1.00 mL 2.00 mL 3.00 mL 4.00 mL…

A:

Q: The following calibration data were obtained by an atomic absorption spectrophotometric (AAS) method…

A: Calculation for the above questions given below.

Q: in HPLC, what does it mean to equilibrate the system. Let us assume that the system is currently…

A: In HPLC, equilibrate the system is performed every before injection of the sample If the system is…

Q: The predominate form of caffeine at pH 9.4 is neutrally charged. If nitromethane, a compound often…

A: Caffeine is a member of alkaloid family. It is a group of compounds obtained from plants and whose…

Q: Internal standard. A mixture containing 12.8 mM analyte (X) and 44.4 mM standard (S) gave…

A:

Q: Prepare standard solutions for the spectrophotometric measurement of iron in an unknown solution.…

A: Serial dilution refers to stepwise dilution by keeping the dilution factor constant. Dilution factor…

Q: Nitrite is commonly determined by a colorimetric procedure using a reaction called the Griess…

A:

Q: The water-soluble vitamins niacinamide (a neutral compound), riboflavin (a neutral compound), niacin…

A: Micellar Electrokinetic Capillary Chromatography is a hybrid of electrophoresis and chromatography.…

Q: Chloroform is an internal standard in the determination of the pesticide DDT in a polarographic…

A:

Q: A juice concentrate was colorimetrically assayed using Nelson's test. One milliliter (1.00 mL) of…

A: To find the reducing sugar concentration (mg/mL) in the juice concentrate ?

Q: The aim of this experimen solution on the distribution coefficient of a drug, in this case benzoic…

A:

Q: An analyte is found to elute from a reversed-phase column with a retention factor of 12.5 when a 20%…

A: Given data  :- At 20% ethanol and 80% water concentration retention factor = 12.5

Q: A total of 5 mL of blood samples were treated with trichloroacetic acid to precipitate proteins.…

A: Solution:  In this problem we have to calculate the concentration of Pb in ppm

Q: The absorbance of an iron (III) thiocyanate, Fe(SCN)3 (MM= 230.09 g/mol), solution containing…

A: The concentration of the solution is,

Q: 2. A coal sample analysis on mass basis was reported as C = 76.3%, H2 = 4.2%, O2 = 4.5%, and…

A: Given that - C = 76.3%  , H2 = 4.2%  , O2 = 4.5%                 Moisture = 71%  , Mineral matter =…

Q: A flavor chemist attempted to isolate and identify the major flavor component of a recently…

A: IR : 3500 to 3000 cm-1 is alcohol stretch is not present. Therefore the compound is  do not have…

Q: Nitrite is commonly determined by a colorimetric procedure using a reaction called the Griess…

A: A question based on analytical process, which is to be accomplished.

Q: The following volumes of a solution containing 1.10 ppm Zn2+ were pipetted into separatory funnels…

A:

Q: The following data were obtained by gas-liquid chromatography using a 40.0 cm packed column: Air i.…

A: Since you have asked multiple questions, we will answer the first one for you. To get the remaining…

Q: The concentration of a glucose solution was determined via a DNS assay, and it was determined that a…

A: Given:: Concentration c= 150.0 mM = 0.1500 M Absorbance, A=0.156 path length l=0.95 cm Molar…

Q: A juice concentrate was colorimetrically assayed using Nelson’s test. One milliliter (1.00 mL) of…

A: The reducing sugar behave as a reducing agent in a reaction. The Nelson's test is used to measure…

Q: A) What pH should the solvent system be to perform TLC on a sample suspected of containing…

A: A) Because the putative molecule is slightly acidic, we must utilize a solvent solution that is very…

Q: An eggshell is treated with NaOH to remove the membrane, dried and found to weigh 5.131 g. The shell…

A:

Q: What does the %RSD, listed in the spectral data, as well as the correlation coefficient of your…

A: %RSD - RSD is abbreviation for relative standard deviation. This represents the deviation of a set…

Q: Spectrophotometric Determination of a Metal A 100.00 mL of exactly 250.0 mg/L Cu2+ stock solution…

A: To answer why NH3 is added to each standard solution before diluting with distilled water.

Q: The concentration of phenol in an aqueous solution is 10 ug/mL. The absorbance is found to be 0.209…

A:

Q: Give the rationale behind major steps in the analysis such as blending, filtration, heating of the…

A: Mixing of chemical substances is an interaction through which various chemicals are consolidated…

Q: A flavor chemist attempted to isolate and identify the major flavor component of a recently…

A: IR : 3100 cm-1 sp2 C-H stretch, 2950 cm-1 sp3 C-H stretch, 1735 cm-1 carbonyl stretch of ester, 800…

Q: A flavor chemist attempted to isolate and identify the major flavor component of a recently…

A: Given information: Compound 1 has a smaller Rf value (0.2) than compound 2 with Rf value 0.6.

Q: 60 ml of standard hardness containing 1 mg of pure CaCO3 per ml consumed 22 ml of EDTA. 40 ml  of…

A: A numerical problem based on EDTA complexometric titration, which is to be accomplished.

Q: The following volumes of a solution containing 1.10 ppm of Zn were pipetted into separatory funnels…

A: The given procedure adopted for estimating the concentration of zinc solution in the unknown sample…

Q: A 5.00-mL sample of blood was treated with trichloroacetic acid to precipitate proteins. After…

A: Given : 1.Absorbance of standard solution(A1)         = 0.396  (first point) 2.Absorbance of…

Q: 13. Electrospray time-of-flight mass spectrometry was used to analyze the eluate from a…

A:

Q: Absorbances of a series of phosphate standard solutions measured using UV- Vis spectrophotometer…

A: A question based on concentration, which is to be accomplished.

Q: One common way to determine phosphorous in urine is to treat the sample after removing the protein…

A: The table is given below:

Q: A series of nonpolar aromatic compounds were separated by isocratic HPLC on a nonpolar stationary…

A:

Q: A sample of Melbourne drinking water was injected into an ion chromatograph. The anions were…

A: Given: Void time = 1.25 min ts for chlorides = 3.12 min ts for sulfate = 6.62 min

Q: Forty grams of powdered banana pulp was mixed with 80.00 mL of cold Tris-HCl extracting buffer to…

A: 1. The original concentration of standard solution is 2 mg/mL.

Q: A flavor chemist attempted to isolate and identify the major flavor component of a recently…

A: Given information: The isolated compound was dissolved in ethyl acetate and first extracted with 0.1…

Q: The following calibration data were obtained by an atomic absorption spectrophotometric (AAS) method…

A: To solve this problem, we first need to plot a graph for analytical signals versus concentration.

Q: A total of 5 mL of blood samples were treated with trichloroacetic acid to precipitate proteins.…

A: Absorbance of blood sample = 0.502 Absorbance of 0.4 ppm standard = 0.396 Absorbance of 0.6 ppm…

Q: 3.) The following Beer's Law calibration plot was collected at 391.9 nm using the five mixtures…

A: We can use the given trend line equation for Absorbance versus chromate ion concentration graph and…

Q: A 24 year old graduate student was brought to the ED in a comatose state after being found…

A:

Q: A 10.00 mL of natural water sample containing Ni2+ was pipetted into a volumetric flask and diluted…

A: The molar absorption coefficient for the Ni2+ solution is determined as follows. Ni2+2=4.00 mL×5.99…

Q: You prepared a stock solution by dissolving a compound with the molar mass of 110.65 in a 100 mL…

A: Given : Molar mass of compound = 110.65 g/mol Final volume of solution = 250 mL = 0.250 L…

Q: A total of 5 mL of blood samples were treated with trichloroacetic acid to precipitate proteins.…

A: Solution: In this question we have to calculate the Pb concentration in ppm.

Q: . A third spectrophotometric method for the quantitative analysis of Pb in blood yields an Ssamp Of…

A: Concentration of Pb2+ in original sample can be calculated using standard addition method. In which…

Q: A GC separation was conducted on a sample containing a 14) pesticide analyte, Pymetozine. This…

A: First we need to find out the RF value by using given infomation - AAN = 2791, CAN = 15.0ppm AIS =…

Q: Injection of ethane, propane, butane, pentane, and hexane on a squalene column under isothermal…

A:

Mass Spectrometry

This process is an instrumental method in which a sample is changed to fast moving positive ions by electron bombardment. The charged particles vary due to their different mass to charge ratio and are estimated with the help of this difference. It is also called mass spectroscopy.