Answered: Color code value as 2 k Ω± 5% Color…

Science

Physics

Color code value as 2 k Ω± 5% Color coding of a read resistor do you do?

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter16: Electromagnetic Waves

Section: Chapter Questions

Problem 39P: The voltage across a parallel-plate capacitor with area A=800cm2 and separation d = 2 mm varies...

See similar textbooks

Related questions

Q: A 1km long MM step index fiber has n, = 1.48, A= 0.01 . Find a) Intermodal dispersion b) Bit rate…

A: Hi please find the solution

Q: A thin linear dipole antenna is λ/12 long and its loss resistance is 1.2 Ω. Find the radiation…

A: The expression for the radiation resistance is written as, Here, l and λ represent the length of…

Q: zero signal collector current

Q: What would be the depth of penetration for copper at 2 MHz frequency with σ = 5.8 x 10?

A: Please see the answer below.

Q: Q12. In center-tapped rectifier, there are more stresses on the diodes compared to half wave single…

A: The peak inverse voltage in center tapped rectifier is 2Vm The peak inverse voltage in half wave…

Q: Calculate the input bias current at each input of an op-amp having specified values of I1o IiB = 20…

Q: Question: With the value of E and the value of ITot, calculate Rtot

Q: Using the following diagram to describe the resistor band colors for the following resistor values…

A: a. 10KOhm 1 = Brown 0 = Black K = Orange +-5% = Gold Hence, 10 K Ohm = Brown Black…

Q: Gallium Arsenide diode laser emits 0.9 maw of power inside a CD player. The band gap of Gallium…

Q: A 1268 range voltmeter is having an accuracy of ± 1.23% of FSD. Calculate the following for the…

A: For Given values of range for M1 and M2 scale, we have to calculate following: - Accuracy - Maximum…

Q: What is used in PCM to represent the value of the modulating signal?

A: Pulse code modulation is a method used to convert analog signals into digital signals. The modified…

Q: Q / Ri=2-2k2 R3-1k Evslov Ru-3-3kr と2215V RzAoka VIT 个工 Iz O Determine the voltages Vz & V3 O…

Q: Single phase rectifier has a purely resistive load of 10n, energized by voltage source of 220V…

A: Resistive load, R = 10 ohms Voltage from source =220 V transformer winding = 2:1

Q: A steady current of 10.0 A is passed through a water voltameter for 300 s. Estimate the volume of…

Q: If the resistivity of iron is p=9.60*10-80-m and the density of conduction band elecrons is…

A: According to question we need to find drift velocity.

Q: A full wave rectifier uses a centre - tap transform whose turns ratio to half secondary is 10:1and…

Q: Discuss the working of LC electronic oscillator by explaning circuit.

A: This circuit require two component a capacitor and an inductor. Capacitor stores electrical energy…

Q: Complete the table with solutions. Ra=5.0 2 R,=7.0 2 Rc= 4.0 2 %3D Ra=4.0 23 Re = 4.0 2 14.0 V+ Rf =…

Q: According to the Bleaney equation, the resonance of a proton in close proximity to a lanthanide ion…

A: Answer: it is false Since the traditional Judd–Ofelt–Mason theory has failed to offer useful…

Q: If we use 5000 µF, we can get a very low ripple voltage. But this is so bad and this a disadvantage,…

A: It is given that the capacitor is used to reduce the ripple voltage. Ripple voltage and capacitance…

Q: If the sensitivity of a wire is expressed in the following relation Z =R zD³/4L Find its maximum…

A: Main value of Z Z = (105×3.14×0.62)/(4×75.3) Z = 0.394

Q: 1) The electrons are tightly bound on the last orbit in these materials. A. Inductors B.…

A: 1) (c) insulators Reason-The outermost electrons are tightly bound that there are no free…

Q: Q3: An-type semiconductor crystal with 12 mm long ,5mm wide and Imm thick has magnetic density of…

Q: Calculate the Hall voltage when B=0.5 Wb/m ^2 , Ix=2 mA , d=0.2 cm and ni=10^2m ^3

Q: Why is there an AC voltage source and a DC current source in an X-ray tube

A: solution as

Q: 7. The nominal resistance value of the a 4-band resistor is 470 kQ ± 5%. a. What is the resistance…

Q: A 16cm × 12cm rectangular conductive loop is placed in the xy plane. from above When viewed from the…

A: Given:

Q: The frequency of alpha band of EEG waveform is O 20-60 Hz O >60 Hz O 8 -14 Hz O 14-20 Hz O 0.5 – 4…

A: The frequency of alpha band of EEG waveform lies in range 8-14 hertz.

Q: A bipolar alkaline water electrolyzer stack module comprises 160 electrolytic cells that have an…

A: Given :- Number of electrolytic cells =160 effective cell area = 2 m2 current…

Q: In order to change the strength of the input signal, you should adjust.. none of the other choices…

A: Note:-“Since you have asked multiple questions, we will solve the first question for you. If you…

Q: Complete the 4 - Band color code for a resistor that has a value of 65kΩ ± 10%.

A: Color code for resistors: Value of resistance, R = 65kΩ ± 10%. = 65 × 103 ± 10%

Q: The frequency of this wave is ________

A: Given Vertical sensitivity: 0.2 V/div Horizontal sensitivity: 2 μs/div Frequency is given as f…

Q: The value of stability factor for a base resister with collector current 10.4mA and emitter current…

A: Given : Collector current = 10.4 mA; Emitter current = 10.6 mA

Q: Considering a channel with the power delay profile below, what kind of fading will a service having…

A: Given Power Delay Profile, we can classify a multipath channel into frequency selective or frequency…

Q: 3 V +8 V 1 kQ Si 2.2 k2 + + Si -8 V (a) (b)

Q: Given the equation, V – Voe-(2.6x10-3)t, at what time will | %3D oe the voltage drop by its original…

A: According to guidelines we need to solve only first question kindly repost other questions in the…

Q: Half wave rectifier consists of center-tapped transformer attached with two diodes O True O False

A: 1. FALSE Explanation: A half-wave rectifier consists of the following components: Alternating…

Q: Find the mathematical expression for the transient behavior of VL and IL of 220 Ohm t = 0 VL 4H 50v

A: Given, Resistance,R=220Ω Inductance,L=4 H Emf of battery,ε=50 V

Q: a) Draw the circuit diagram of a simple negative clamper with input and output wave forms for input…

A: a) Negative Clamper is Circuit given by:

Q: R = 1.12 × 10⁷ 1) Find λ = ? (From n = 5 to n = 2) 2) find the energy difference between n=5 to…

Q: HOW DO YOU IDENTIFY RESISTORS THROUGH COLOR CODES?

A: As the resistor is a two-terminal device and is an important component for electronic devices. it is…

Q: A certain superconducting magnet in the form of a solenoidof length 0.50 m can generate a magnetic…

A: The magnetic field in a solenoid is

Q: For a practical (Vdiode = 0.7 V), simple half wave rectifier (without a transformer), the Vav for Vp…

A: Average output voltage

Question

Color code value as 2 k Ω± 5% Color coding of a read resistor do you do?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Complete the 4 - Band color code for a resistor that has a value of 65kΩ ± 10%.
What are the colors of a 4- bands resistor of a value R= (10 +or- 0.5) ?
What is used in PCM to represent the value of the modulating signal?
A single phase full wave rectifier has two diodes and the forward resistance of each diode is 25 ohms. The transformer secondary voltage from center to each half of the secondary winding is 30 2 V sin wt and the load resistance is 2000 ohms. Compute for the following: A. Average value of load current or the dc load current. B. rms value of load current, C. Peak inverse voltage of each diode
How would you go about improving the determination of the electrical resistance of a given material in resistor color coding activity?
The Hall effect is to be used to find the density of charge carriers in an unknown material. A Hall voltage 40 uV for 3-A current is observed in a 3-T magnetic field for a rectangular sample with length 2 cm, width 1.5 cm, and height 0.4 cm. Determine the density of the charge carriers.
What is the free space path loss in dB over 20 meters at the 2.4 GHz band, and how does the dB change when you double the distance?
Gallium Arsenide diode laser emits 0.9 maw of power inside a CD player. The band gap of Gallium Arsenide is 1.42 eV. How many photons are emitted per second?
What would be the depth of penetration for copper at 2 MHz frequency with σ = 5.8 x 10?
A halfwave dipole is 1.50 m long. At what frequency is it operating? Answer inMHz.
A Pb wire wound in a tight solenoid of diameter of 4.0 mm is cooled to a temperature of 5.0 K. The wire is connected in series with a 50resistor and a variable source of emf. As the emf is increased, what value does it have when the superconductivity of the wire is destroyed?
The Hall effect is to be used to find the density of charge carriers in an unknown material. A Hall voltage 40 V for 3-A current is observed in a 3-T magnetic field far a rectangular sample with length 2 cm, width 1.5 cm, and height 0.4 cm, Determine the density of the charge carriers.