Complete the Differential Leveling Notes by providing data to the unknown quantities. STA BS HI FS ELEV BM1 1.256 127.133 TPI 1.116 1.886 ТР2 1.228 1.527 BM2 1.189 2.246 BM3 1.070 2.017 ТРЗ 1.831 2.656 BM4 2.765

Complete the Differential Leveling Notes by providing data to the unknown quantities. STA BS HI FS ELEV BM1 1.256 127.133 TPI 1.116 1.886 ТР2 1.228 1.527 BM2 1.189 2.246 BM3 1.070 2.017 ТРЗ 1.831 2.656 BM4 2.765

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: ATION 1. The following shows a tabulated data of differential leveling notes? STA BS FS 1 5.87 2…

Q: The screed readings were successively monitored using a leveling device and the device was moved…

A: instrument is moved after 2nd and 6th reading level of last point =36.51 m then level of other…

Q: 'he readings given in the table below were recorded in a levelling operation from points 1 to 10.…

A: It is required to find the Reduced level of various points and then loop closure.

Q: The screed readings were successively monitored using a leveling device and the device was moved…

A: elevation of last point 36.51 minstrument is shifted after 2nd and 6 th reading Height of the…

Q: SOVE FOR EQUILIBRIUM: Problem #3 lo00 300 # 3' 10' 4' Rz

A: This question is related to the Strength of Material or Mechanics. In this question we calculate…

Q: 1. Complete the leveling notes. Show Customary Check. STA BS HI FS ELEV 1.964 |(205.549+y) BM1 1.964…

A: Given: The value of y is 0.99. The differential leveling notes are given below, STA BS HI…

Q: Н.W 1- An angle is observed repeatedly using the same equipment and procedures. Calculate (a) the…

Q: STA. B.S. F.S. ELEV. 7.994 388.84 2 9.154 6.443 5.604 6.403 4 9.374 7.233 12.314 5.723 6 11.414…

Q: DIFFERENTIAL LeuEL IN PROBLEM # 4.72 8.19 2,16 :6.3) 3,04 6.72 3,15 BM Eleu TP #2 TP #3 TP FLeu lo00

Q: 2. Complete the Differential Leveling Notes by providing data to the unknown quantities. STA BM1 0+…

A: In this method, following approach is adopted to find the unknown elevations of different points.…

Q: Q. No 4). A rectangular channel of X ft width is supplying water at flowrate of Y ft'/s. If the…

A: Rectangular section: Given data: Q = Y ft3/sec Slope (S) =1/800 n = 0.015

Q: A dumpy level is setup at one end of a line 120m long for the purpose of determining the…

A: Procedure :1. Write down the instrument number which are you are presently using.2. Set up and level…

Q: From the given data of a differential leveling as shown in the tabulation: Sta B.S. (m) FS (m) Elev…

Q: Q.I A line of level is run from B.M.1 (elevation=102.00m) to B.M. 2(elevation=106.00m). The field…

A: Given Elevation of BM1 = 102 Elevation of BM2 = 106 Reading of BS, IS and FS To Determine Computed…

Q: DIFFERENTIAL LEVELING. Complete the differential level notes shown below and perform the customary…

Q: Q.2 Reciprocal leveling was conducted across a wide river to determine the difference in level of…

A: Given data Reduced level Staff readings at A Staff readings at B Distance between two.

Q: #7 Given. A lap traverse ABE DE with a course DE of Bearing $ 11°42′15″E; fillowing angles : A =…

A: Sum of angles of a five sided polygon =540° Sum of angles= 540°0'25'' Angular error = 25" Adjusted…

Q: 21== Q. No 4). A rectangular channel of X ft width is supplying water at flowrate of Y ft/s. If the…

A: Given that: Width of rectangular channel, B=12 ftDischarge in the channel, Q…

Q: In the two peg test of a dumpy level, the following observations are taken Instrument at AInstrument…

A: Given: The observations for two peg tests are, Instrument at A Instrument at B Rod…

Q: 1. DIFFERENTIAL LEVELING STATION BACK SIGHT HEIGHT OF INSTR. FORESIGHT ELEVATION BM 10 4.64 209.65 m…

Q: 5 (a) Explain: 'current metre rating curve'. How it is prepared ? Sketch a typical rating curve. (b)…

A: a) A rating curve throughout hydrology is indeed a chart showing discharge vs stage at such a…

Q: h' ORIGIN R2 Hd L1 given Design head =4.2 Height of dam = 37,0 Calculate b and L1 O A. b= 0.73 , L1…

A: Given:- Design head h'=4.2 mHeight of dam Hd=37.0 m

Q: II. Complete the leveling note and perform the arithmetic check based on the picture Result Reviewer…

A: ELEV OF BM20 = 131.239

Q: Helght of Torget Une of Slght Assume 90* Horlzontal Une Level Surface HJ. Level Surfoce G Mean Soo…

Q: Determine the elevation of station BM1 using c = 0.65 and k = 100. Backsight Foresight DE ELEV…

A: When the height of a point and also its vertical distance is generally has above or below the…

Q: 3. Complete the Differential Leveling Notes by providing data to the unknown quantities. STA BM33 0…

A: Only elevation of chainages is blank, so finding elevation by height of instrument method HI at BM…

Q: RL2=152.5 Q4). The following staff readings in meter were obtained when leveling along the center…

Q: Example-3: Following readings were taken with level. 1.155, 1.565, 2.695, 3.580, 2.085, 2.895,…

Q: L 0.6m 5m K-1 n-0.012 Q-18 m³/s Formulas: Rh 70- Q==AR 23S 112 n Determine the channel slope [A] use…

A: Asked: To compute the slope of the channel. Given: Manning's roughness coefficient (n) = 0.012…

Q: Computed Lat Computed Dep Correction Adjusted Lat Adjusted Dep Course Length, ft Bearing +N -S +E -W…

A: Course Length Bearing(WCB) Computed Lat Computed Dep Correction Adjusted Lat Adjusted Dep…

Q: Question 2.6 The following consecutive readings were taken with dumpy level and 4 m levelling staff…

Q: STA. B.S. F.S. 1 5.87 2 7.03 6.29 3 3.48 6.25 4 7.25 7.08 5 10.19 5.57 6 9.29 4.45 7 4.94 For…

A: Lets using Rise/Fall method B.S - F.S = Rise/Fall Positive difference mean rise Negative…

Q: DIFFERENTIAL LEVELING Problem: Complete the differential level notes shown in the table below. STA…

A: Complete the differential level notes

Q: PROBLEM 1 +From the given data of differential levelling shown. STA BS FS BM1 1.256 TP1 1.116 1.886…

A: Problem 1Above given table we have find HI in 2nd set up , elevation of TP5, difference between TP3…

Q: Usingvirtual work determine displacenent lat' Bi 3 ET 12,5 +2, 5 1o00 (IN) A

A: By the principal of virtual work, deflection at any point of the beam can be calculated as: Now,…

Q: Figure 03 "W, KN/m" 4.25m 5.15m b2= 0.55m b3= 0.75m "Wx1/2m, KN" h2= 0.75m h3= 0.75m 9.95m L4, m b1=…

Q: From the given data of a differential leveling as shown in the tabulation: STA. B.S. F.S. ELEV. 1…

Q: Consider the following running leveling circuit (Fig.1). D L=400m L=250 m A L=500m Figure 1:…

Q: 1. DIFFERENTI AL LEVELING. Complete the below and perform differential level notes shown the…

Q: From the given data of a leveling as sho Backsight Foresight Elevation Station (m) (m) (m) BM12 4.64…

A: solution from the given values find the elevation of every point elevation = height of the…

Q: Staff reading station A Instrument placed B 2.235 3.545 A B 1.605 2.564 Distance between A and B is…

Q: A level is set up at a point 140 m from A and 110 m from B; the observed staff readings at A and B…

Q: Staff readings on pegs x and y from X station are 1.755 m and 2.850 m, bläi 7 and from station Y on…

Q: Solve the following. 1. Complete the leveling notes. Show Customary Check. STA BS HI FS ELEV 205.675…

Q: 3. Given the following three wire leveling notes: Station Backsight Stadia Foresight Stadia…

Q: Table 1. Differential Leveling To determine relative elevations of points by Differential Leveling…

Q: Q.2 Reciprocal leveling was conducted across a wide river to determine the difference in level of…

A: Given data Station A readings Station B readings RL of station B

Q: b. A tacheometer was set up at B.M and the following observations were made with a leveling staff…

A: staff intercept (S1) = 1.156 - 1.050 = 0.106 ft staff intercept (S2) = 1.158 - 0.952 = 0.206 ft

Q: Determine: RA KN, RB KN, V Diagram (2 decimal places), Vmax (kN 2 dec), Area V (2 dec), M Diagram (2…

Q: P? Using appreximate hetked of analysis, find the internal forees at sec. a-a and sec.b-b and Sec.…

Question

Complete the Differential Leveling Notes by providing data to the unknown quantities.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Given:Upper reading = 1.64 mMiddle reading = 1.57 mLower reading = 1.51 mVertical Middle Angle = 10°32’00”Elev of point A = 333 mH of instrument = 1.2 mK = 100Stadia Constant = 0 Solve the ff.: A. Inclined, horizontal, and vertical distance B. Elevation of point B.
Q avg = 0.181 m^3/s
0 a 2178 kN O b. 3726 kN 1| select one: WG o weiox92
Answer using moment distribution method. Use second picture as guide W= 25P1 = 25P2 = 25
deg= 23.234 qo (kn/m) = 20.82
find I y ans should be Iy' = 217 in^4
Qe.7.
A tacheometer was set up at B.M and the following observations were made with a leveling staff held vertically at P and Q. Ins: Station Staff Station Vertical Angle Hair Readings Bearings Remarks B.M P +10° 00’ 1.050, 1.103, 1.156 40° R.L of B.M =1958.500 ft Q -15° 00’ 0.952, 1.055, 1.158 140° The constant of instrument (f/i) = 100, Height of instrument = 5.15 ft Compute: The horizontal distance between P and Q Reduced Levels of P and Q Grade between P and Q
An engineer's level with stadia constant of 0.30-m was set up on the line between A and B, the following crosshair readings were observed. If the stadia interval factor of the level is 100, determine the length of line AB.
Ans. key : 1) 19.45 KPa. 2) 48.63 KPa 3) 1.37 kN/m
a (deg) = 16.446q0 (kN/m) = 37.632
A line level was run from BM1 to BM2, 8 km apart. The average backsight and foresight distances were 100m. At every turning point, the rod settles by 3cm. Determine the total error in the recorded elevation of BM2. a. 1.17 m b. 1.25 m c. 1.40 m d. 1.57 m