Answered: Compute the capillarity of mercury with…

Compute the capillarity of mercury with a specific gravity of 13.6 in a 2-mm diameter tube. Assume a cohesion of 0.467 N/m and contact angle = 140°. Indicate whether it is

Fundamentals of Geotechnical Engineering (MindTap Course List)

5th Edition

ISBN:9781305635180

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter8: Stresses In A Soil Mass

Section: Chapter Questions

Problem 8.14P

See similar textbooks

Related questions

Q: We have 16 m width of clay layer with two sides of drainage.Clay layer consolidation of floor…

Q: Kindly answer this as soon as possible. Urgent Draw a pressure distribution diagram for the data…

Q: A straight pipe with a diameter of 100 mm and a length of 1000 m carries water at a flow rate of…

A: As per guidelines we need to answer only first 3 subparts

Q: A horizontal 45° bend 750 mm Ø upstream and 300 mm Ø downstream has water flowing thru it at the…

Q: What will be the pressure head of a point in mm of Hg if pressure hecad of that point is equal to 63…

Q: Q-3 Estimate the ratio of the horizontal to the vertical permeability of these four strata. H1 = 3'…

A: As per the guidelines, I am answering the first question: Consider the following figure:

Q: Calculate the value of pressure ∆p onside the rain water droplet , if we know the radius R=0.2mm and…

A: GIVEN- r=0.2mm δ=0.074N/m=7.4×10-5N/mm2∆P=?

Q: Two tensiometers were installed in a soil profile. One is placed at 30 cm and the other at 50 cm…

Q: 3 ft 5 ft n 800 psf 10 ft Y, = 121 pcf $, = 33°, c,' = 0 Layer 1 Y2 = 120 pcf 2 = 28°, c, = 0 10 ft…

Q: discussion of theory of constant and falling head permeability test

A: Permeability test is used to determine the permeability of soil. In these method water is allowed…

Q: A 25 cm diameter pipe carries air (p=1.22kg/m³) (v = 1.5x10-5m²/sec) at an average velocity of 8.0…

Q: Determine the pressure drop that occurs over a 6-m length of the pipe.

A: Given:

Q: 1.) The bottom of a river is 38 ft. below the water surface, Underneath the bottom of the river is a…

A: Given : Pressure at bottom of silt, P = 62 lb/in2 = 8928 lb/ft2

Q: PROBLEM 3: Water flows at a steady rate in this vertical pipe. The pressure at A is 10 kPa, and at B…

Q: Water is flowing at a depth of 1.3 m and velocity of 0.95 m/s when controlled by a sluice gate at a…

A: Sluice Gate : A sluice gate is provided to control the sluice through a valve. Sluice is an…

Q: etermine the depth of center of pressure on a plane rectangular surface of 1 m wide and 3 m deep…

A: Centre of pressure is given by:CP=y+INAyAy=centroid=32=1.5mINA=1×3312=2.25m4

Q: rectangular channel carries a discharge of 18.10m3/s when flowing 1.5m depth. If the width of the…

Q: Q2/ For the soil profile, find the: 1- Total pressure (o.). 2-Pore water pressure ou (u). 3-…

Q: Two points exist under the water’s surface within a reservoir. Point A is at a depth of 155.2’,…

A: Applying Bernoulli's equation between two points: PAγ+vA22g+zA=PBγ+vB22g+zBwhere,γ=62.4 lbft3g=32.2…

Q: Water flows uniformly in a rectan depth of 3m. The channel slope is and the boundary shear stress

A: Given:- width=10m depth=3m slope=0.0025 n=0.013 To find:- velocity flow rate boundary shear stress

Q: Determine the wetting angle for a liquid with specific gravity of 13 from the positive y direction…

Q: Estimate the ratio of the horizontal to the vertical permeability of these four strata. 2.45 m k₁ =…

Q: If there is a layer of sand (lower layer) under artesian pressure (causes upward flow), calculate…

A: Given data:γsat,clay=120 lb/ft3γw=62.43 lb/ft3H=?

Q: A reinforced concrete water tank of size 25 ft x 25 ft and resting on the ground surface carries a…

Q: A scoop carries 610 kg of load with center of mass at G. Neglecting the mass of the members,…

A: Weight of the scoop W =610 Kg at G (downward) all joints are pin joint so this structure will…

Q: Calculate the horizontal displacement of point B. EI is constant for all members (p=50kN , W=90KN/m…

A: The formula for ,deflection from unit load method =∑∫1nMm dsEInwhere, M is the bending moment due to…

Q: calculate the hydrostatic effect of the shaped 3M x 6m cover and the location of the thrust center…

Q: 9.4 An exploratory drill hole was made in a stiff saturated clay (see Figure 9.9). The sand layer…

A: Objective: To determine the depth of excavation before heaving occurs. Given, Artesian pressure…

Q: A concrete dam retaining water is shown in Fig. 4-6a. If the specific weight of the concrete is 23.5…

Q: Find intensity of vertical pressure at a point 3 m directly below 25 kN point load acting on a…

Q: PROBLEM 5: Estimate the ratio of the horizontal to the vertical permeability of these four strata.…

A: Here, use the concept of center of pressure.

Q: Q2/ For the soil profile, find the: 1- Total pressure (o.). 2-Pore water pressure ou (u). 3-…

Q: Water at 300C flow in a Venturi meter with the velocity 3 m/s. The tube diameter at station 1 is D1…

A: velocity at station 1V1=3 m/stube diameter of station 2D2=30 cmpressure at station 1P1=30 Kpa…

Q: A hydraulic jump is formed in a trapezoidal channel of 2.0-m bed width, 1: 1 side slope, and…

A: Given: The width is 2 m. The side slope is 1:1. The discharge is 6 m3/sec. The initial depth of jump…

Q: For the flow net shown below, calculate: a. Flow Rate per unit length. b. Uplift force per unit…

A: Given: Total head H=10-2=8 mUnit weight γ=19 KN/m3 Permeability k=1×10-5 m/secNo. of flow channels…

Q: A concentrated point load of 200 KN acts at the ground surface. Find the intensity of vertical…

A: (a)Find the intensity of vertical pressure at a depth of 10 meters below the ground surface and…

Q: The bottom of a river is 37 ft. below the water surface, Underneath the bottom of the river is a…

Q: Regarding geotextiles used in separation, what is the required burst pressure of a geotextile…

A: Given, Maximum size of the stone, Da= 75 mm Tire inflation pressure, Pt=1000 kPa Cumulative…

Q: It was assumed that the embankment backfill was the same soil from the active earth coefficient…

A: Rankine's Theory Plastic equilibrium cohesion soil Pa=Kaσv, Pp=Kpσv C-ϕ soil

Q: A thick-walled pipeline with internal and external diameters of 600 mm and 1000 mm, respectively, is…

A: We have to find the value of maximum allowable pressure P according to the tresca criteria and von…

Q: The observed pressure drop for 40 °F water flowing at 16 ft/min in a 4.5-in-diameter pipe is 9.68 x…

A: The given data is as follows: Temperature of water=40°FFlow rate=16 ft3/minDiameter=4.5 in.Pressure…

Q: Q1/ Determine the total head, pressure head, elevation head at points 1, 2, 3, 4, 5, 6 and velocity…

A: We know Total head = pressure head+ datum head Note According to the company rules i am able to…

Q: Define Active and Passive Lateral Pressures.

Q: You are given the flow net for the gravity dam shown in Figure below. Two piezometers (i.e.…

A: GIVEN DATA:- FOR GIVEN GRAVITY DAM TOTAL HEAD LOSS OR SEEPAGE HEAD=60-6=54FT NUMBER OF FLOW…

Q: a) Seepage beneath the dam (ft/min) b) Pressure head at points A and B b) Pore water pressure at…

A: (ft/min) seepage beneath the dam b) Points A and B of the pressure head d) Uplift force at the dam's…

Question

Compute the capillarity of mercury with a specific gravity of 13.6 in a 2-mm diameter tube. Assume a cohesion of 0.467 N/m and contact angle = 140°. Indicate whether it is a rise/ fall.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

a block (unit weight = 19.5 kn/m3) 0.55m square and 479mm deep floats on a stratified liquid composed of a 200mm layer of water above a layer of mercury (s.g. = 13.6). determine the position of the bottom of the block relative to the mercury surface in mm.
Problem # 9. A manometer exploration vehicle submerges to a depth of 1000 ft. If the atmospheric pressure at the surface is 1 atm, the water density is 62.4??/??3and ?=32.2??/?2. Determine the pressure on the vehicle in atm.
A 2‐ft diameter well penetrates vertically through a confined aquifer 50 ft thick. When the well is pumped at 500 gpm, the drawdown in a well 50 ft away is 10 ft and in another well 100 ft away is 3 ft.(a) What is the approximate head in the pumped well for steady‐state conditions, and what is the approximate drawdown in the well?(b) Compute the transmissivity. Take the initial piezometric level as 100 ft above the datum.
The dam shown has a base of which 2m below the ground surface. The pressure distribution diagram at the base of the dam can be obtained from the equipotential lines as follows: k=4.5 m/day. if H=6m determine the seepage through the foundation.
A 12m high circular tank with 45m radius contains oil weighing 9.4kN/m3. This tank stands over a 3m saturated sand layer (γsat = 18.88 kN/m3) underlain by a 14m thick clay layer (γsat = 17.30 kN/m3 , e = 1.27 and Cc = 0.40). Neglect weight of the tank. Assume no precompression has occurred. What is the difference between the settlement below the center and below the end of the tank?
1. Calculate the variation of σ, u, and σ’ with depth. Given: H1 = 12 ft, H2 = 8 ft, H3 = 5 ft, S = 50% in capillary rise zone. 2. Plot the variations of σ, u, and σ’ with depth.
A manometer with diameters L and d is used to measure the pressure difference P1 − P2. Both ends experienceatmospheric pressure. Completely derive the correct expression for the pressure difference:
In a constant head permeameter with cross section area of 10cm2 when the flow was taking place under a hydraulic gradient of 0.5. the amount of water collected in 60seconds is 600cc.find the permeability of soil.
A 151m long concrete dam in embedded 5m into the ground stores freshwater 25m deep upstream. There is a meter depth of water downstream. The permeable soil stratum beneath the dam has a permeability of 6.5x10^-2 cm/s. Solve for the following:• Seepage flow (m^3/hr)• Uplift force beneath the dam (kN)Final answers should be in 3 decimal places.
Refer to Figure 7.24. The following data were collected during the field permeability measurement of a confined aquifer using a pumping test. Determine the hydraulic conductivity of the permeable layer. Use Eq. (7.49). Thickness of the aquifer, H = 4.5 m Piezometric level and radial distance of the first observation well: h1 = 2.9 m; r1 = 17.8 m Piezometric level and radial distance of the second observation well: h2 = 1.8 m; r2 = 8.1 m Rate of discharge from pumping, q = 0.5 m3/min
Determine the wetting angle for a liquid with specific gravity of 13 from the positive y direction expected in a 0.08-in diameter tube if the surface tension is 0.0352 lb/ft and the capillary depression is 0.01908 ft.
For a falling-head permeability test, the following are given:length of specimen = 380 mmarea of specimen = 6.5 cm2k = 0.175 cm/minWhat should be the area of the standpipe for the head to dropfrom 650 cm to 300 cm in 8 min?