I0kg XND CONNECTED to AN AXLERETARDED, FF THE NATURALSHAFT IS ROTATED sFREQUENCY is O671 HZ, CALCULATE THE STIFFNESSOF THE ÄXLE SHAFT, K in N/m.

Given mass m= 10 kg Frequency f = 0.71 Hz

Answered: CONNECTED to AN AXLE RETARDED, FF THE…

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter10: Fixed-axis Rotation

Section: Chapter Questions

Problem 8CQ: A massless tether with a masses tied to both ends rotates about a fixed axis through the center. Can...

See similar textbooks

Similar questions

ANSWER ASAP. WILL GIVE AN UPVOTE
The velocity of the 8-kg cylinder is 0.3 m∕s at a certaininstant. The mass of the grooved drum is 12 kg, its centroidal radiusof gyration is k = 210 mm, and the radius of its groove isri = 200 mm. The frictional moment at O is a constant3 N∙m. Find the frictional force if final speed is given to be 2.5.
A uniform sphere of mass m and radius R rolls without slipping down a plane at an angle θ from thehorizontal. Show that the acceleration along the slope of the center of mass is aCM = (5/7)g sin θ and that the force of static friction needed is fs = (2/7)mg sin θ. What minimum coefcient of friction µs is needed to satisfythe conditions of the problem?
A uniform slender rod of length L = 36 in. and weight W = 4 lb hangs freely from a hinge at A. If a force P of magnitude 1.5 lb is applied at B horizontally to the left (h = L), determine (a) the angular acceleration of the rod, (b) the components of the reaction at A.
A strut of lengthL = 3.00 m and mass m =16.0 kg is held by a cableat an angle of θ = 30.0°with respect to the horizontalas shown in FigureP8.30. (a) Sketch a forcediagram, indicating allthe forces and their placementon the strut. (b) Why is the hinge a good place to usefor calculating torques? (c) Write the condition for rotationalequilibrium symbolically, calculating the torques around thehinge. (d) Use the torque equation to calculate the tension in the cable. (e) Write the x- and y-components of Newton’ssecond law for equilibrium. (f) Use the force equation tofind the x- and y -components of the force on the hinge.(g) Assuming the strut position is to remain the same, wouldit be advantageous to attach the cable higher up on the wall?Explain the benefit in terms of the force on the hinge andcable tension.
Let r=OP=4i. Which is greater (in magnitude): the torque about O when a force F=4i-3k is applied at P or the torque about O when a force F=3i-4j is applied at P?
If the m = 323.4 kg, μs= 0.369, and μk= 0.208, what is the largest angle of theta without allowing the box to move? Use g=9.8m/s
An shaft spins at 20rad/s and uniformly speeds up to 100rad/s over 5.0s. What was its (a)angular acceleration with proper units, and (b)angular displacement?
whaT magnitude of (constant) force appliedhorizontally at the axle of thewheel is necessary to raise the wheelover a step obstacle of heighth = 3.00 cm? The wheel’s radius is r =6.00 cm, and its mass is m= 0.800 kg.
A 90-horsepower outboard motor at full throttle will rotate its 15in long propellers at 5000rpm. What is the linear speed in mph of the tip of one of the propellers?
Which force causes the highest moment (clockwise and counterclockwise) about Point C?
If the required clamping force at the board A is to be 2.50 kN, determinethe torque M that must be applied to the screw to tighten it down. Thesquare-threaded screw has a mean radius of 10.0 mm and a lead of 2.50 mm, and the coefficient of static friction is μS = 0.500

SEE MORE QUESTIONS

Recommended textbooks for you

University Physics Volume 1

Physics

ISBN:

9781938168277

Author:

William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:

OpenStax - Rice University

Classical Dynamics of Particles and Systems

Physics

ISBN:

9780534408961

Author:

Stephen T. Thornton, Jerry B. Marion

Publisher:

Cengage Learning

University Physics Volume 1

Physics

ISBN:

9781938168277

Author:

William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:

OpenStax - Rice University

Classical Dynamics of Particles and Systems

Physics

ISBN:

9780534408961

Author:

Stephen T. Thornton, Jerry B. Marion

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS

CONNECTED to AN AXLE RETARDED, FF THE NATURAL XND SHAFT IS ROTETED s FREQUENCY is 0671 HZ, CALCULATE THE STIFFNESS OF THE XXLE SHAFT, kj in N/m.