Consider the arrangement shown in the figure below. Assume that R = 6.00 Q, l=1.20 m, and a uniform 2.50T magnetic field is directed into the page. At what speed (in units of m/s) should the bar be moved to produce a current of 3.4 A in the resistor? B app

Consider the arrangement shown in the figure below. Assume that R = 6.00 Q, l=1.20 m, and a uniform 2.50T magnetic field is directed into the page. At what speed (in units of m/s) should the bar be moved to produce a current of 3.4 A in the resistor? B app

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter13: Electromagnetic Induction

Section: Chapter Questions

Problem 84CP: The accompanying figure shows a metal disk of inner radius r1 and other radius r2 rotating at an...

See similar textbooks

Related questions

Q: A wire loop with a resistance, R = 0.160 Ohms is pulled to the right out of a region with a uniform…

A: The expression for the required force is,

Q: A current-carrying coil in a magnetic field experiences a torque with a magnitude that is 78.0% of…

Q: A wire loop with a resistance, R = 0.174 Ohms is pulled to the right out of a region with a uniform…

A: Given Resistance R=0.174 Ω B=0.468T L=0.189m v=17m/s

Q: The square loop as in the figure is made of wires with total resistance R =9.8 N. The loop is placed…

A: Given,

Q: A circular loop of wire of resistance R = 0.500 2 and radius r = 9.00 cm is in a uniform magnetic…

A: Resistance , R = 0.5 Ω radius , r = 9 cm = 9 x 10-2 m Current , I = 3.4 mA To find = rate of change…

Q: will the wire loop rotate, and if so, in which direction?

A: Step two contains complete explanation with detail. Although this question has some value but those…

Q: The conducting rod shown in the accompanying figure moves along parallel metal rails that are 25-cm…

A: a. the emf produced in a rod moving in uniform magnetic field is

Q: Consider the arrangement shown in the figure below. Assume that R = 6.00 Q, 1-1.20 m, and a uniform…

A: Given:- The resistance R= 6.0 ohm The current I = 5.5 A The length L= 1.2 m The magnetic field B…

Q: Assume that I = 6.0 A and d = 2.1 cm . What is the strength of the magnetic field at the center of…

A: In this case the total magnetic field is the sum of the field due to loop and due to the straight…

Q: An aeroplane is flying due North at a speed of 227 m/s. The distance between the tips of the two…

Q: In the figure below, a metal bar sitting on two parallel conducting rails, connected to each other…

A: Given:constant external force, Fapp = F = 1.45 Nresistance, R = 8.00 Ωspeed of the bar, v = 2.25…

Q: Consider the arrangement shown in the figure below. Assume that R = 6.00 Q, I=1.20 m, and a uniform…

A: When a conductor of length l moves through a magnetic field with a speed v so that magnetic field B…

Q: The figure below shows a square loop circuit, 10 cm on each side, containing a R = 5.6 Q resistor, a…

A: Given data: Length of the square loop, a=10 cm = 0.1 m Resistance, R=5.6 Ω Emf, ε=7.3 V Capacitance,…

Q: em 3 Consider the arrangement shown in the figure below. The resistor is 3.00 Q, the length of th ng…

A: Here we use the concept of change of magnetic flux due to this emf induced this known as motional…

Q: The figure below shows a top view of a bar that can slide on two frictionless rails. The resistor is…

A: If the strength of the magnetic field is also increased then the wire moves through a stronger…

Q: In the figure below, a metal rod is forced to move with constant velocity along two parallel metal…

A: Dear student, this question contains more than three sub-parts. We will answer first three…

Q: Consider the arrangement shown in the figure below. Assume R = 7.00 n and t = 1.40 m, and a uniform…

A: Resistance = 7 ohm Length (L) = 1.4 m Magnetic field (B) = 2 T Current (I) = 0.5 A

Q: Consider the system pictured in the figure below. A ℓ = 18-cm length of conductor of mass 23 g, free…

A: Given: The length of the horizontal wire, L=18 cm=0.18 m The mass of the wire, m=28 gm=23×10-3 kg…

Q: The figure below shows a top view of a bar that can slide on two frictionless rails. The resistor is…

A: Let B be the magnetic field directed into the page, and v be the speed of the bar. Write the emf (ε)…

Q: In the figure below, a metal bar sitting on two parallel conducting rails, connected to each other…

Q: In the drawing below a wire is looped as shown -- note that the wire crosses over top of itself with…

A: Given values. resistance R=4.7Ω Side of large loop L = 19 cm Side of small loop l=192cm magnetic…

Q: The rectangular loop below is pivoted about the y – axis and carries a current of 15 ? in the…

Q: In the figure below, a metal rod is forced to move with constant velocity along two parallel metal…

A: Given : Magnetic field (B) = 0.370 T Length (L) = 28 cm = 0.28 m Speed (v) = 70 cm/s = 0.70 m/s…

Q: Consider four loops with similar currents flowing in the figure's directions, for the next two…

Q: The figure below shows a top view of a bar that can slide on two frictionless rails. The resistor is…

A: Given value--- resistance R = 5.60 ohm. magnetic field = 2.50 T . length = 1.20 m. velocity = 2.10…

Q: A conducting rod of length l moves on two horizontal, frictionless rails as shown. If a constant…

A: Current through resistor can be determined as Using energy conservation, we can equate (1) and (2)…

Q: Consider the arrangement shown in the figure below. Assume that R = 6.00 Q, 1=1.20 m, and a uniform…

Q: One end of a conducting loop of wire is pulled through a magnetic field of 0.438 T as shown above.…

A: Solution: Given that B = 0.438 T L = 22.3 cm v = 6.1 m/s R = 1.59 Ω

Q: onducting bar of length { moves to the right on two frictionless rails as shown in the figure below.…

Q: Consider the arrangement shown in the figure below. Assume that R = 6.00 N, l=1.20 m, and a uniform…

A: Given data The resistance is given as R = 6 Ω. The distance between the distance l = 1.2 m. The…

Q: A single loop (N=l) of wire of radius r = 0.0300 m lies with its face parallel to the page. It is in…

A: As per our guidelines we will solve only first three subparts for you. To get remaining subparts…

Q: rom the starting position shown, a loop of copper wire is pulled to the left out of a uniform…

A: 1. The original magnetic field is outwards to the plane of paper. 2. As the loop is pulled out of…

Q: A current i = 2.0 A flows in a long straight wire and in a circular loop as indicated in the figure…

Q: The figure below shows a top view of a bar that can slide on two frictionless rails. The resistor is…

A: The force required to move the bar is calculated by using the formula FB=ILBsinθ , where θ=90° is…

Q: Consider the arrangemcnt shown in the Figurc. Assume that R = 6.002, 1=1.20m, and a uniform 2.50T…

A: Given in question - Resistance (R) = 6.00Ω Length (L) = 1.20m…

Q: A conducting bar of length l moves to the right on twofrictionless rails, as shown in Figure P20.30.…

A: part A:

Q: A square loop with side length L carries a current 1, counterclockwise. The loop is placed in…

Q: Consider the arrangement shown in the figure below. Assume that R = 6.00 0, 1-1.20 m, and a uniform…

Q: A conducting metal rod of length 5[cm] moves with speed 3[m/s] while immersed in a uniform magnetic…

A: Given Length of rod l = 5 cm = 0.05 m Velocity v = 3 m/s Magnetic field B = 0.7 T

Q: The figure below shows a top view of a bar that can slide on two frictionless rails. The resistor is…

A: SOlurion: Given that R = 5.6 ohm B = 2.5 T L = 1.2 m

Q: O O, O O O O O O O 4. In the figure to the right, the rod moves with a speed of 1.8 m/s, is 24 cm…

A: Data the velocity of the rod, V=1.8m/s length of the rod, L=24cm=24×10-2m magnetic field ,B=0.35T…

Question

Consider the arrangement shown in the figure below. Assume that R = 6.00 0, 1=1.20 m, and a uniform 2.50T magnetic field is directed into
the page. At what speed (in units of m/s) should the bar be moved to produce a current of 3.4 A in the resistor?
Bin
R
app

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1: Given

VIEW

Step 2: Formula Used and Calculations

VIEW

Answer: -

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

The accompanying figure shows a metal disk of inner radius r1 and other radius r2 rotating at an angular velocity while in a uniform magnetic field directed parallel to the rotational axis. The brush leads of voltmeter are connected to the dark's inner and outer surfaces as shown. What is the reading of the voltmeter ?
12.7 Check Your Understanding What is the ratio of the magnetic field produced from using a finite formula over the infinite approximation for an angle of (a) 85°? (b) 89°? The solenoid has 1000 mins in 50 cm with a current of 1.0 A flowing through the coils
Is the work required to accelerate a rod from rest to a speed v in a magnetic field greater than the final kinetic energy of the rod? Why?
Two flat, circular coils, each with a radius R and wound with JV turns, ace mounted along the same axis so that they are parallel a distance d apart. What is the magnetic field at the midpoint of the common axis if a current I flows in the same direction through each coil?
How is the percentage change in the strength of the magnetic field across the face of the toroid related to the percentage change in the radial distance from the axis of the toroid?
Check Your Understanding Shown below is a rod of length l that is rotated counterclockwise around the axis through O by the torque due to mg . Assuming that the rod is in a uniform magnetic field B , what is the emf induced between the ends of the rod when its angular velocity is ? Which end of the rod is at a higher potential?
A current of 1.5 A flows through the windings of a large, thin toroid with 200 turns per meter. If the toroid is filled with iron for which =3.0103 , what is the magnetic field within it?
Is Ampere’s law valid for all closed paths? Why isn’t it normally useful for calculating a magnetic field?
Check your Understanding Themagneticfield shown below Is confined to the cylindrical region shown and is changing withtime. Identity those paths for which =EdI0 .
Two long wires, one of which has a semicircular tend of radius R, are positioned as shown in the accompanying figure. If both wires carry a current I, how far apart must then parallel sections be so that the net magnetic field at P is zero? Does the current in the straight wire flow up or down?
A charge of 4.0C .s distributed uniformly around a thin ring of insulating material. The ring has a radius of 0.20 m and rotates at 2.0104 rev/min around die axis that passes through its center and is perpendicular to the plane of the ring. What is the magnetic field at the center of the ring?
What is the magnetic field at P due to the current I in the wire shown?