Answered: Consider the phase-shifting circuit in…

Consider the phase-shifting circuit in Fig. 9.83. Let V, = 120 V operating at 60 Hz. Find: (a) V, when R is maximum (b) V, when R is minimum (c) the value of R that will produce a phase shift of 45 O

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 2PP: Assume that the voltage drop across the resistor, ER, is 78 V; the voltage drop across the...

See similar textbooks

Related questions

Q: Using the phasors obtain x(n) = cos( (πn)/2) + 1.1 sin((πn)/2).

Q: iT Q.9: For the circuit shown, if (it=5+3sin@t+1.5sin2@t) Amp. Write the: eT J22 1. Non-sinusoidal…

Q: A given RLC circuit (Resistor-Inductor-Capacitor) has the following components: R = 4.4 Ohms L =…

A: The reactance offered by capacitor in RLC circuit (XC) is given by: Where, The capacitance of…

Q: A given RLC circuit (Resistor-Inductor-Capacitor) has the following components: R = 4.1 Ohms L =…

A: The reactance offered by inductor in RLC circuit (XL) is given by: Where, The inductance of…

Q: A series RLC circuit having a resistance of 8 ohm, inductance of 50 mH and capacitance of 90 µF is…

A: We have been give an RLC circuit with, Resistance (R) = 8 Ω Inductor (L) = 50 mH = 50 * 10-3 H…

Q: Q1. Using Thevenin's theorem, perform the conversion showed in the image below. Perform transient…

Q: 9.42 Calculate v.(t) in the circuit of Fig. 9.49. 50 Ω 30 Q 50 μF 60 sin 200t V 0.1 H v,(1) all

Q: 2. Please find the time constant and capacitance value (C) of a simple RC circuit by using its…

A: To solve above question, one should understand the behavior of Inductor and capacitor in DC circuit.…

Q: Fox the Coupled Circuit shown, find mutual inductance "M" the value of and put the dots on the Coil…

A: Let us assume the coils are connected in cumulative series. Let L be the equivalent inductance of…

Q: 9.48 Find the Thévenin equivalent circuit with respect to the terminals a,b of the circuit shown in…

A: The given figure is shown below:

Q: For The system described by the equation y(t) = x(sin(t)), i Time- Са linear invariant variant Non…

A: System are given. Find the system is either causal or non causal. Linear or non linear Time…

Q: 10 2 ww The circuit in Fig. 8.12 has reached steady state at † = 0-. If the make- before-break…

A: Given : In the given circuit they have mentioned a second order system which is made up of capacitor…

Q: Irwin, Engineering Circuit Analysis, 11e ISV 8.58 Find the current i, in the following circuit. 12 V…

A: Use superposition theorem to find out the current, Consider 5 V source first, remove other sources,…

Q: The circuit in Fig. 8.12 has reached steady state at t 0. If the make- before-break switch moves to…

Q: For the circuit in Fig. below: a. Determine I, VR , and Vc in phasor form. 30 N 0.2 H 0.2 H 4 µF…

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: For the circuit in Fig. below: b. Draw the phasor diagram of the voltages E, VR, and Vc. ll 30 N 0.2…

Q: If the rise time of a second order damped system is 0.16 s and its natural frequency is 10.4 rad /…

A: In Second order damped system, Rise time tr=0.16 sec Natural frequency ωn=10.4 radsec Damping Ratio…

Q: A system with the following pole-zero plot is marginally stable. 3m(s) (2) 5. Refs) -2 -1 True False

A: Any control system is said to be marginally stable if there exist poles at the jw axis without any…

Q: 2. Given that i(t) = 13.33 et-8.33 e 0.5t A for t>0 in the circuit below, find the following: a.…

A: The solution is given below

Q: An industrial coil is modeled as a series combination of an inductance L and resistance R, as shown…

A: This question belongs to circuit theory . It is based on the concept of vector addition of voltage…

Q: Calculate the current in the capacitor shown if the voltage input is a.) v(t) = 10 cos(377t – 30°)…

Q: 6) For the system given below, the values of - k and a such that the system has damping ratio of…

A: Given:damping ratio ξ = 0.67undamped natural frequency wn = 3.65rad/s

Q: The characteristic equation of a dynamic system is q(s) = s(s+ 7) (s+ 7 + j 7)(s+ 7 -j 7) +K The…

A: We need to find out number of asymptotes on root locus for given characteristics equation

Q: An industrial coil is modeled as a series combination ... of an inductance L and resistance R, as…

Q: 9.45 Use source transformations to find the Thévenin equivalent circuit with respect to the…

A: For this problem we can easily find thevenins equivalent across ab terminals by using source…

Q: 4F 10V 3µF 3µF 4uF SuF

A: Given circuit,

Q: Find the Thevenin equivlent circuit

A: The impedance offered by the inductor is, Impedance offered by the capacitor is,

Q: 2. Please find the time constant and capacitance value (C) of a simple RC circuit by using its…

Q: For the circuit in Fig. below: b. Draw the phasor diagram of the voltages E, VR, and Vc. 30 Ω 0.2 H…

Q: 2. Please find the time constant and capacitance value (C) of a simple RC circuit by using its…

A: Graph is given as :

Q: 2) An LC circuit is made by attaching a 0.2221 H inductor is connected across a variable capacitor…

Q: An industrial coil is modeled as a series combination of an inductance L and resistance R, as shown…

Q: 4.) A series RLC circuit with R = 3000 ohms, L = 10 H, C = 200 microfarad has a constant voltage V =…

Q: A second order system has natural angular frequency of 2.Q rad/s and a damped frequency of 1.T…

A: In this question, we need to determine the damping factor , 100% rise time, and percentage…

Q: Given: Vs The circuit below is under steady DC conditions. 100 mF 2Ω 4Ω Vs V( 4Ω 2 H; Find the…

Q: 2. Please find the time constant and capacitance value (C) of a simple RC circuit by using its…

A: For a simple R-C circuit the capacitor current is written as ic=V0Re-tT=I0e-tTAmp.

Q: 2. Please find the time constant and capacitance value (C) of a simple RC circuit by using its…

A: In an electric circuit, the transients are due to energy storing elements. If the network contains…

Q: .52 If V, = 20/45° V in the circuit of Fig. 9.59, find I,. -j5 Q I, 10 Q 5Ω j5Ω all

Q: 9.42 Calculate v.(t) in the circuit of Fig. 9.49. 50 Ω 30 Ω ww ww 50 μF 100 sin 200r V (E 4(1) 0.1 H

Q: A single loop RLC electrical circuit can be modelled as a second order system in terms of current.…

A: The inductor and capacitor are the energy storing elements. They exchange energy among themselves in…

Q: 2. Please find the time constant and capacitance value (C) of a simple RC circuit by using its…

A: Capacitor is an electrical component used to store electrical energy in the form of charge. It…

Q: Give the following equivalent circuits for an RLC system: 4 H 10 sin(21 – 30°) V ( 102-30° j3 (a)…

Q: The voltage v(t) = 12 cos(60t+45°) is applied to a 0.1 H inductor. Find the steady state current…

A: In this question we need to find a steady state current through the inductor.

Q: b) For the circuit shown, assume that the capacitor volitage and inductor current are zero at t = 0.…

A: ELECTRICAL NETWORK: When addressing a circuit problem or constructing a balanced circuit, the word…

Q: Determine the steady-state voltage v(t) when it is subjected to a waveform shown below. is (A) 5 mH…

A: The function given is defined as, Its period is, The fundamental frequency is,

Q: For the circuit shown below, find the steady-state current associated with the capacitor. 0.SH Vs fe…

A: The source frequency is given as ω=10 rad/s. Converting the circuit parameters in phasor domain as…

Q: The current in an L-R-C series circuit has amplitude 0.120 Aand angular frequency 8.00 * 103 rad/s,…

A: It is given that:

Q: Consider the following RLC circuit, where vs(t) = 240 cos(wt) (V), operating at 60HZ. %3D Calculate…

Q: Given a circuit with a Time domain values: v(t) = 10 cos(1000t) R = 100 N L = 10 mH C = 10 µF %3D…

Q: 7. In figure shown below, i= 42 mA sin (377t – 40). The capacitance is 1 µF. Find the sinusoidal…

Question

please answer correctly and give solution

Consider the phase-shifting circuit in Fig. 9.83. Let
V, = 120 V operating at 60 Hz. Find:
(a) V, when R is maximum
(b) V, when R is minimum
(c) the value of R that will produce a phase shift of 45°
O<R< 100 2
l0 Ω
ww-
200 mH

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

b) Find the rms current flowing in an AC capacitive circuit when a 4μF capacitor is connected across a 880V, 60Hz supply.
The equivalent phasor domain representation of the equation of the current i = 60 Sin (100πt - 30°) mA is
The current in an L-R-C series circuit has amplitude 0.120 Aand angular frequency 8.00 * 103 rad/s, and it has its maximum positivevalue at t = 0. The resistance is 95.0 Ω, the inductance is 6.50 mH,and the capacitance is 0.440 mF. For the resistor, inductor, and capacitor,find (a) the voltage amplitudes and (b) the instantaneous voltages att = 0.305 ms.
The admittance (Y) of a circuit is the sum of the phasor current to the phasor voltage. True False QUICKLY
A series RLC AC circuit has R = 425 Ω, L =1.25 H, C = 3.50 µF, ω=377 s-1, and ΔVmax= 150 V. (a) Determine the inductive reactance, the capacitive reactance, and the impedance of the circuit. Find both the maximum voltage and the instantaneous voltage across each element.
1. Transform these sinusoids in to phasors 2.If voltage v= 10cos(100t + 30°) is applied to a 3uF capacitor, calculate the current through the capacitor.
The circuit is operating in thesinusoidal steady state. Find io(t) if vs(t)=25 sin 4000t V
An inductor having an impedance of 6 + j8 is connected across a 200v supply. The real power supplied to it is watts. choices: 4000 3200 2400 1200
A single phase CSI (with ideal switches) has the following days: I=30 A, f=500 Hz, Load capacitance=20 uF Find the circuit turn off time.
d) Determine the phasors VL, VR and Vc.
S:41) A circuit consists of a current source, Is = 43 sin(5386t - 40.29 °) mA in parallel with a 72 kΩ resistor and a 2895 pF capacitor. Determine the magnitude of the effective value of current that flows through the resistor.
70. Ideal inductors and capacitors are 90 degrees out of phase with each other. True False 71. Ideal inductors and resistors are 180 degrees out of phase with each other. True False 72. Impedance of a circuit can be represented or expressed in complex form. True False