Consider the wires that carry electric current and are arranged as shown below. In this case the length of segment a = 12 cm, b = 16 cm. Where the current flowing along the wire i = 4.5t2 - 10 t (where i is in amperes, t is in seconds). -b- b a. Determine the magnitude of the emf in the square loop (square wire) at t = 3 seconds. b. Determine the direction of induction in the square loop

Consider the wires that carry electric current and are arranged as shown below. In this case the length of segment a = 12 cm, b = 16 cm. Where the current flowing along the wire i = 4.5t2 - 10 t (where i is in amperes, t is in seconds). -b- b a. Determine the magnitude of the emf in the square loop (square wire) at t = 3 seconds. b. Determine the direction of induction in the square loop

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter12: Sources Of Magnetic Fields

Section: Chapter Questions

Problem 32P: Two long, parallel wires are hung by cords of length 5.0 cm, as shown in the accompanying figure....

See similar textbooks

Similar questions

The rod shown below moves to the right on essentially zero-resistance rails at a speed v=3.0m/s . If B = 0.75 T eveywhere in the region, what is the current through the 5.0 resistor? Does the current circulate clockwise or counterclockwise?
The magnetic flux through the loop shown in the accompanying figure varies with time according to m=2.00e3tsin(120t) , where m is in milliwebers. What are the direction and magnitude of the current through the 5.00 resistor at (a) t= 0; (b) t=2.17102 s and (c)t=3.00 s?
In the circuit sho in the accompanying figure, the rtd slides along the conducting rails at a constant VelOCity v. The velocity is in the same plane as the rails and directed at an angle 6 to them. A uniform magnetic field Bis directed out of the page. What is the emf induced in the r?
(Indicates a review question, which means it requires only a basic understanding of the material to answer. Questions without this designation typically require integrating or extending the concepts presented thus far.) What happens to a ferromagnetic material when it is placed in a magnetic field?
Two long, parallel wires are hung by cords of length 5.0 cm, as shown in the accompanying figure. Each wire has a mass per unit length of 30 g/m, and they carry the same current in opposite directions. What is the current if the cords hang at 6.0° with respect to the vertical?
Check your Understanding Themagneticfield shown below Is confined to the cylindrical region shown and is changing withtime. Identity those paths for which =EdI0 .
Suppose you have two wires placed horizontally. lets say the first carries a current l1=90A. The second is placed 25cm below the first one. if the lower wire has a mass of 0.15 grams per meter of length, how much current,if possible, this second wire has to carry if we don't want it ti fail by gravity?
How can we calculate the motional emf of a conductor moving in a magneticfield?
In the last lesson, Lorenz's Law was applied to a current I traveling along a length of wire L, described by the formula, F-ILBsin(theta) In this lesson, Lorenz's Law is applied to a point charge q moving at velocity v, described by the formula, F-quBsin(theta) See how the IL is replaced by qv? Their units are the same: IL has units of amps meter and qv has units of C meter/s (amps is C/s). When applying the three-finger right-hand rule (RHR), the index "pointer" finger used for the direction of current is also used for the direction of the charge's velocity. In each scenario below, use the RHR to determine the direction of force: a) A positive charge's velocity v is directed up in a magnetic field B directed to the left, like this v /\ < B [Select] b) A positive charge's velocity v is directed down in a magnetic field B directed out of the page, like this v \/ o B [Select]
A straight metallic wire that is perpendicular to magnetic field B is moved with velocity v perpendicular to B andthe wire (how convenient). The wire is connected to a lamp bulb with resistance R. Make a sketch with all vectorsinvolved, draw the direction of the induced current I. [3] The current that flows through the circuit can be calculatedaccording to Ohm’s law V=IR. The power burnt in the bulb is P=VI. Relate is to the velocity v. Where does theenergy come from?
The plate on the back of a personal computer says that it draws 6.09 A from a 120-V, 60-Hz line. For this compufer, what is the current amplitude?
Imagine a conductor on rails that completes the circuit below. There is also a magnetic field with strength 3 T pointing into the screen. If the resistance of the resistor is 1000 Ohms, and the bar is 2 meters long and sliding to the right with a constant speed of 5 meters/second, what is the power dissipated by the resistor?