Construct a 5-to-32-line decoder with enable by using 3-to-8 and 2-to-4-line decoders with enables
Q: For V1=10, and R1=220 the series diode configuration of the figure shown below, determine Vp, R. and…
A:
Q: Find the average value of signal shown below a)-0.66 +3 X(t) b) 0 π/2 7 37/2 2π c) 0.25 d) none
A:
Q: A germanium diode draws 32 mA with the forward bias 0.27 V. If T-300 K calculate the reverse…
A: If =32 mA Vf = 270 mV T = 300 K
Q: _25/0° V (+1) 10 Ω www j4Ω Μ 5Ω 1₂ 1/0°Α ell j8 Ω -j6Ω
A:
Q: Refer to the autotransformer circuit in Fig. 13.44. Calculate: (a) I₁, I₂, and I, if Z₂ = 8 + j6 f,…
A: It is given that: ZL=8+j6 Ω
Q: which means the following points: 1- the interrupting capacity of the protection devices must be…
A: Solution: Determine : =>here we explain as per give above three point are related to power…
Q: Q.2 Design a 50W microstrip directional coupler to operate at 2.4GHz center frequency. The coupling…
A: According to the question, we need to design a 50W microstrip directional coupler to operate at…
Q: a) Sketch the following signals, and state whether they are odd or even (or neither), and continuous…
A:
Q: 1.) What is the current through 10052 The Resistor?
A: It is given that:
Q: Find power dissipated across R1 in mW V₁=8,8Volts, and R₁ =5,4k V1 Si Ge R1
A: V1=8.8 V, R1=5.4 kΩ. Given circuit diagram is,
Q: Op Amp 1 Use the circuit in Figure 1 for this problem. Assume OpAmp is ideal. Place your final…
A: Here, We need to calculate the gain and output voltage for this given input voltages .
Q: $ C₁ R₁ R₂ ww Vcc Re RE HH C₂ FIG. 4.28 Voltage-divider bias configuration. No 1cq Alc Q-point…
A: Asked to determine Base current operating point IBQ Collector current operating point ICQ Collector…
Q: (e) Given B = -51 + 10j + 2k and C = 8î+ 3k Calculate the dot product of two vectors, B.C (1)
A: We need to find out the dot product of given vector.
Q: A 200V, dc shunt motor has shunt field resistance of 200 ohm and an armature resistance of 0.25 ohm.…
A:
Q: Determine the input impedance of the circuit in Fig. 9.24 at = 10 rad/s.
A: It is given that:
Q: ? By using Current Divider Rule (CDR) find i1 & i2 + 11 12
A: The circuit is given that:
Q: Obtain the transfer function using A. block diagram reduction B. signal flow graph R(s) G₁ G₂ H₂ G₂…
A: Given: Block diagram of a control system as, To find: Transfer function using: a) Block diagram…
Q: Question: A communication satellite is transmitting a signal to a ground station on Earth. The…
A: here we have to find the received power and SNR at the receiver.Given information is Frequency f=10…
Q: A three phase salient pole, 440 volts, wye connected synchronousgenerator operates at a power angle…
A: a three phase salient pole synchronous generator has voltage Vt = 440 V (phase / line voltage)…
Q: Find the minimum value of R for which the output voltage keeps exactly at V Rs R1 Given Vs =25 V.…
A: VS=25 V, Vz=15 V, Rs=25 kΩ. Circuit diagram is given as,
Q: 4. Calculate the resistance Re for this circuit to drive the transistor into saturation. The BJT…
A:
Q: A 3-phase 400 volt, balanced star connected lagging load take a current of 5A. The power is…
A: Given- 1 3-phase 400 volts, balanced star connected lagging load with, Current, I=5 A. The power is…
Q: pls answer qiuckly
A: In this question We need to determine the equivalent circuit of the transformer into refer the high…
Q: QUESTION 2 Assume Figure 2 is an ideal operating amplifier circuit. Show that the leftmost…
A: given condition is V1 = Vo - Vin to show the leftmost amplifier works…
Q: Three - 25 KVA single-phase transformers are connected in delta – delta. One of the transformers has…
A: it is asked to find the maximum real power of delta-delta transformer if one of transformer is…
Q: For R1=1.4, and V1=0.1 in the series diode configuration shown below, state whether the diode is on…
A:
Q: Problem 1. For the circuit below find v(t) using Laplace transformation at t>0 i,(0) = 3A, vc…
A:
Q: Combine the two series voltage sources into one source.
A: Need to convert the two source into single source and the same can be obtained by using the source…
Q: What is the input resistance, Rin, in the circuit in Figure 4 when n=2 Rin 100 Ω n:1 || 4Ω
A: Number of turns in primary side of transformer n = 2.
Q: Consider the decaying exponential function x (t) illustrated in Figure 10. Find the Fourier…
A:
Q: 3. Voltage-Divider Bias Configuration +20V 오 $250ka Is lloke Determine: ftc 700-2 Q V $12515452 IB,…
A:
Q: The critical frequency at a particular time is 12.5 MHz. What is the optimum working frequency for a…
A: Given: Critical frequency, fc=12.5 MHz Angle of incidence, ϕ=65°
Q: find small signal gain Av. of the amplifier from Vin to Vout assuming that Rc = 5Kohms Rs = 0 and Rl…
A: β= 100Rc = 5 kΩRE = 200 Ω
Q: 4. v(t) = 750 cos (5000 t +30°) V (a) Find the peak value, the phase, the frequency, and the period…
A: V(t)=750cos(5000t+30°) v We need to calculate a) peak value, phase , frequency,time period of v(t)…
Q: d) Determine the Input-Output relationship equation for the following system. Then comment and give…
A: According to the question, for the given system as shown below We need to find, i. Linearityii.…
Q: explain the Reasons for coordinating electrical protections
A:
Q: Calculate the Laplace Transform of x(t)=3 u(t) + e -²t u(t) + e 4t u(-t). Draw the Region of…
A:
Q: Design a four-bit combinational circuit 2's complementer. (The output generates the 2's complement…
A: Need to design 4-bit combinational circuit that performs 2's complement of the input.
Q: An enhancement-lype MOSFET is fabricated 0.4μm find the 16 fm. Process in with L=0.8 μm and w= value…
A:
Q: Sketch the Bode plots for 100 ja (jw+4)(jw+10)² H()=-
A:
Q: Question 3. A three-phase impedance load balanced A a connected load in parallel with a balanced y…
A: Given,Impedances,Z∆=6+6j Ω.ZY=2+2j Ω.Zn=1j Ω.Voltages,V0=10∠60° V.V1=100∠0° V.V2=15∠200° V.
Q: how you find cutoff frequency
A: The above question is based on low-pass filter whose transfer function is given.
Q: A digital transmission system has a bit rate of 45 megabits/second. How many PCM voice calls can be…
A: In a digital transmission system, The bit rate is 45 Mbps. Word length is of 8 bits.
Q: Draw a filter circuit (High pass filter) Using a resistance and coil and plot the frequency range?
A: Need to design the High Pass FIlter using the resistance and coil and also the frequency response…
Q: A unit step response is applied on a system with 30 transfer function, G(s): Find the time s+45…
A: A unit step response is applied on a system with a transfer function, G(s) = 30s+45 Find the time…
Q: - zero sequence current
A:
Q: Discuss briefly the following Boolean Algebra terms and give at least five ( 5 ) examples each : a.…
A: Here asked to explain briefly about Boolean algebra and mention atleast 5 examples of a)SOP b)POS
Q: 6.32 The four capacitors in the circuit in Fig. P6.32 are con- nected across the terminals of a…
A: “Since you have posted a question with multiple sub parts,we will provide the solution only to the…
Q: Find I1 and I2.
A: For the given magnetically coupled circuit the value of unknown current I1 and I2 needs to be…
Q: 8. Solve the following circuit for current in loop A, B and C. Use the following system of linear…
A: For the given circuit along with the system of linear equations, the loop current needs to be…
Step by step
Solved in 4 steps with 3 images
- (b) In which encoding scheme Nyquist theorem is used and Why? Explain complete procedure of that Encoding scheme with example with the advantages and Disadvantages of this theorem.Q22) This true or false Question from DIGITAL COMMUNICATIONS Course,just write for me the final answer. The bit error probability for orthogonal signaling is greater than the bit error probability for bipolar signaling. a. True b. FalseExplain why NRZ coding is not attractive for signal transmission applications?! Short answer please