control systems In the electromechanical system given below, it can be seen that the coil can be represented by the series R-L circuit and also the coil It is known that the electromagnetic pulling force (F) is also proportional to the coil current, that is, F = βi. The input of the system is the voltage v applied to the coil and the output is the x path taken by the core. Accordingly, the system find the differential equations and transfer function

Q: Exercise: 1. Find transient and steady state characteristic of the following transfer function VA.…

A:

Q: 3) Consider a causal LTI system implemented as the RLC circuit shown in Figure-2. In this circuit,…

A: Need to solve for given series RLC circuit

Q: Obtain the dynamic model (differential equation) of the electrical system below with input vs and…

A:

Q: Given is the parallel connected RLC network as depicted in the figure below. L R 1)I(t) iz(1) The…

A: As mentioned Matlab is not needed so we are solving theoretically. A parallel RLC network is given.…

Q: Problem 3: Consider a second-order system described by the following transfer func- tion: 0.04 G(s)…

A: The solution is given below.

Q: Based on the response curve, answer the following questions: (a) What can be said about the order…

A: The time response plot subjected to a unit-step input of a spring-mass-damper system. The peak value…

Q: 1 G(s) (s + 10)(s+ 1) 6. Plot the step response of the closed-loop system 7. Draw a block-diagram of…

A:

Q: 5. The figure below shows a system consisting of a continous-time LTI system followed by a sampler (…

A: (a) Applying the Laplace transform to the given equation:

Q: (a) A mechanical system is shown as in the following figure, where k is the spring coefficient, b is…

A:

Q: Since the simplified model of the bumper of this vehicle is as follows, x(t) m F.(t) b a- Find the…

A: (a) When the car is pushed a distance x(t) in the right direction. Write the expression for the…

Q: Consider the two differential equations: тx" + bx' + kx%3D F(t) dI + RI +1 = dt E(t) C where m, b,…

A: Since you have asked a question with multi sub-parts, we will solve the first three parts for you.…

Q: Solve All parts or will dislike answer  A. Find the open-loop transfer function  . Y(S) / R(S) B.…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: d) Design a N-state synchronous up-down counter, where N=1+4. Write down the equations for your…

A:

Q: Question 1. Write the differential equation for each system given in Fig.1(a) and (b). R(s) C(s)…

A: First of all we should write the transfer function of the given  system    The transfer function we…

Q: Q5) The translational problem shown below has a linear and a nonlinear spring and is subjected to…

A: We are authorized to answer one question at a time since you have not mentioned which question you…

Q: In practice a machine, described a second-order transfer function G(s), will be Question 2 subjected…

A:

Q: transient.pdf For the block diagram in the attached pdf. Find K, so that t,=0.4 for a 2% tolerance…

A: First we will find the closed loop transfer function and we will campare with standard second order…

Q: A system has a damping ratio of 0.5, a natural frequency of 100 rad/s, and a dc gain of 1. Find the…

A:

Q: . Given vehicle mass and damping coefficient as shown in figure 4, and using f(t) as the input, and…

A:

Q: Electronic Pacemaker ctronic pacemakers regulate the speed at whic.. the heart pumps blood. We…

A:

Q: 6. A plant with transfer function G„(s) given by 1 Gp(s) = s(s + 4) is subject to a reference input…

A:

Q: Transfer Function of a system is given below C(s) 200 R(s) s+ 5 s+25 a. Draw the poles of the…

A: In this question , we will find different parameters of second order control system..

Q: For the circuit shown in figure below, find the differential equation relating output y(t) to the…

A: To find the differential equation of parallel circuits, Kirchoff's current law is used. according to…

Q: A series RLC circuit has the following parameters: R = 0.2 2, L = 200 mH, C = 8 mF and V(t) = 10 sin…

A: Given data: R=0.2 Ω L = 200 mH C = 8 mF v(t)=10sin(8πt) V (a)The differential equation for the…

Q: Given the ff. second-order differential equation: y[n] + 1.4y[n-1] + 0.45y[n-2] = x[n] - x[n-1]…

A:

Q: PROBLEM 1: Differential Equation (DE) and Transfer Function (TF) la) Find the u->y TF of the…

A:

Q: 100 2. A robotic arm transfer function is given as G(s) = „find ; s²+(K+1)s+100 a) Natural frequency…

A:

Q: 2. In an invasive blood pressure measurement set-up, the catheter tip is covered with surgical glove…

A: According to question: The damping ratio and natural frequency of oscillation is calculated as ∵…

Q: The system described by the following differential equation dy(t) -8y²(t) = x(t– 1) dt is: O A.…

A: A A differential equation said to be linear if and only if :- (1) degree of differential equation…

Q: Tollowing of systems. Classity each as overdamped, underdamped, undamped or critically damped…

A: Note: As per our company guidelines we are supposed to answer ?️only the first 3️⃣ sub-parts. Kindly…

Q: A series RC circuit with R = 40Ω and C = 0.1F is connected to a sinusoidal voltage v = 180sin(20t +…

A:

Q: 1. y = x+ C,e* + C,e-2*

A: It is given that: y=x+C1ex+C2e-2x

Q: (c) After substituting the parameters given in the problem, find the steady-state current, i from…

A: For a DC motor driving a mechanical load, Ra=2, La=1, I=1, V=4, c=2, TL=0;Km=3.138, Kt=Kb=2,…

Q: s+1,5 For the system with forward path gain G(s) and feedback gain H(s) = , input r(t) = u(t) will…

A: Error analysis for parabolic input:…

Q: 2. System stability associated with the a. Forced response b. Transient response c. Natural…

A: Although it is known that any system consist two type of responses  (i) natural response  (ii)…

Q: 3. For a second-order system that yields a 15% overshoot and a settling time of 0.7 seconds,…

A:

Q: Activity 2: The differential equation governing the voltage, v , of a parallel RLC circuit is given…

A:

Q: |A robotic arm transfer function is given as G(s) „find ; s2+(K+1)s+100 a) Natural frequency b)…

A: As per our company guidelines we are supposed to answer only first 3 subpart kindly repost other…

Q: For the system with forward path gain G(s) s+8 g2+8s+3 and feedback gain H(s) =0 input R(s) = ; will…

A:

Q: 100 A robotic arm transfer function is given as G(s) „find ; +(K+1)s+100 a) Natural frequency b)…

A:

Q: Consider the electric circuit shown below. Q.3 a) Determine the differential equation that relates…

A: According to the question (a) Determine the differential equation that relates the input x(t) to…

Q: Given the circuit, derive the differential equation defining the inductor current. What are the…

A: Given the circuit network: We need to derive the differential equation defining the inductor…

Q: 6. A torsional spring of stiffness K is 1 Nm/rad, a mass of moment of inertia I = 1 kg.m² and a…

A:

Q: Write down the general differential equation describing the dynamic response of a second order…

A: The deflection torque during the transient period needs to overcome the inertia of the moving…

Q: Given is the parallel connected RLC network as depicted in the figure below. L C R ↑ )I(t) The…

A: In this question,  RLC circuit are connected in parallel to each other.  Input is I(t) while output…

Q: Provide the nature of the response (undamped, overdamped, undamped, critically damped) of the output…

A:

Q: Which of the following is not a primary objective of control system analysis and design? Select the…

A: 1. Answer: create a schematic   Explanation:   a). It is not a valid option. Reducing the…

Q: control system has a closed loop T.F. with unity feedback as Y(s) U(s) = K(s + 3) s(s + 2) + K(s +…

A:

Q: What's the damping ratio zeta for this system with its closed-loop poles as shown?

A: The poles are at  -4+j8 and -4-j8