Answered: Convert 68°F to °C.

Engineering

Civil Engineering

Convert 68°F to °C.

Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)

5th Edition

ISBN:9781305084766

Author:Saeed Moaveni

Publisher:Saeed Moaveni

Chapter11: Temperature And Temperature- Related Variables In Engineering

Section: Chapter Questions

Problem 36P: For Problems 11.11, 11.12, and 11.13, calculate the U-factors.

See similar textbooks

Related questions

Q: Problem 2: A line measured with a 50-m long steel tape was determined to be 645.22 meter when the…

Q: What is the vicat time of setting? 2. What is the final time of setting?

A: from table H=225 MIN E=195 MIN C=29 mm D=20 mm NOW FROM FORMULA vicat time=H-EC-DX(C-25)+E…

Q: Problem No. 2 The correction in the length of the 100 m steel tape at a temperature of 40°C is…

Q: 9. A 50m steel tape is of standard length at 25°C. If the coefficient of thermal expansion of steel…

A: Given, Steel tape length=50m at 25°CThermal expansion=0.0000115/°CCorrect length=1547.50m at 33°C

Q: Determine the pressure difference between points A and B in Fig. 2-51. I Pa+ [(0.88)(9.79)](0.21) –…

Q: SITUATION 2: A 30 m tape measured a 412 m distance at a temperature of 520C. The tape is of a…

A: Length of tape, distance measured, standard temperature, temperature during measurement have been…

Q: What is the equivalent value of T = 60° C in kelvins?

A: Kelvin: Kelvin is a unit of temperature in the SI unit system. It is a thermodynamic temperature…

Q: Q2: Air stream at 27°C moving at 0.3 m/s across 100 W incandescent bulb, glowing at 127 °C. If the…

Q: A heat load calculation is being done to determine how much heat is beinglost through a wall. The…

A: To calculate the net area of the wall, We have to reduce the area of the window from it. Breadth of…

Q: urface where temperature is 18°C. If the volume increases by 88.39% upon reaching he water surface.…

Q: 2. A line was measured using a 50 m tape and was recorded as 746.22 m. when the average temperature…

Q: The measured distance between the two poles is 318 m. The tape used was standardized at 20 degrees…

Q: A steel tape, known to be of standard length at 20°C, is used in laying out a runway 2500 m long.…

Q: 5. A slab of concrete used in highway construction is set in place when the ambient temperature is…

A: The given data is: Ambient temperature=20 °C Length of slab, L=20.478 m Maximum temperature=55 °C…

Q: H.W: Convert temperature at 30.Cfrom Celsius to Fahrenheit . Note: Fo= Co*9/5+32

A: Answer to first question Given Temperature,T=30℃

Q: Air at 25 ° C blows over the hot steel plate whose surface temperature is maintained at 150 ° C. The…

Q: 2. A line was measured using a 50 m tape and was recorded as 746.22 m. when the average temperature…

A: The length of line measured = 746.22mThe standard length of tape at 20°C, l1 =50mThe average…

Q: A 50m steel tape is of standard length at 25° C. If the coefficient of thermal expansion of steel is…

A: Given data, Standard temperature T0 = 25oC Coefficient of thermal expansion α = 0.0000115/°C…

Q: At a temperature of 22.5 °C the length of the tape is decreased by 0.0045 m. What will be the…

Q: Change 303°K to degree Celsius and degree Fahrenheit

A: It is required to convert the temperature from Kelvin to celcius and Fahrenheit.

Q: 5) A line measured with a 40.0 m long steel tape was determined to be 7500.0 m when the average…

Q: - Oil SG =0.72 9.43 psi 30" Air - Water 12" -Mercury SG = 13.6 h

Q: 2.21 The difference between the air and the inside wall temperature in a room is 10°F (5.5°C). What…

A: Given Data: The difference between the air and inside wall temperature is ΔT=5.5°C The height of the…

Q: Write the one major disadvantage of fabric filter.

A: Answer:- Fabric filter:- It is that system in which the particulate laden gas stream passes through…

Q: 1. A steel tape have a standardized length of 30.00m, with 5 kg tension, at 30 °C, and supported…

Q: : liquid level in

A: To find : Ratio of rise in liquid. Given : The ratio of the surface tension S and density ρ of…

Q: kN to m3 150 lb Convert: ins

A: To convert the unit system from lb/in3 to kN/m3. Given, To convert: 150 lbin3 to kNm3 To perform…

Q: Example 1.6: If the monthly mean of average daily temperature and monthly mean of maximum daily…

A: Given data: Monthly mean of the average daily temperature, Ts = 38 oC Monthly mean of maximum daily…

Q: The measured distance from A to B was 300.0m. The tape used has a standard length of 30m, at 20 °C…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: Given: Open water source Net radiation = 200 W/m2 %3D Air temperature 25 °C %3D Density of water =…

A: open water resource is given with above data and it has been asked to calculate evaporation rate…

Q: a) What are the four heat fluxes (Q) across the sea surface? b) complete the labels for all curves…

A: Four heat fluxes: Short-wave solar radiation, Sensible heat flux, latent heat flux, long-wave…

Q: A rectangular lot was measured using a 50-m steel tape at 30 oC. If the recorded length and width of…

A: To Find :- error in the area of the rectangular lot measured.

Q: Air G 1.5 ft SAE 30 oil Water 0.5 ft B 2 t 2,5 ft Mercury

A: The pressure of the water column is calculated by using the formula, the pressure is equal to the…

Q: rectangular lot was measured using a 50-m steel tape at 30 oC. If the recorded length and width of…

Q: topic: surveying A rectangular lot was measured using a 50-m steel tape at 30 oC. If the recorded…

Q: A cylinder of 0.9 m in volume contains air at 0°C and 39.24 N/cm absolute pressure. The air is…

Q: 100°? air flows through a round aluminum tube of ID 60mm and OD 80mm at 4 ?? .The tube is covered in…

A: Take 25 °C as room temperature r1=30 mmr2 = 40 mmr3 = 45 mm Assume unit length of the tube Thermal…

Q: Perform the following temperature conversions: (a) Convert 55°F to (1) Rankine, (2) Celsius, and (3)…

Q: When the temperature was 3 deg. C, the distance from E to F was measured using a steel tape that has…

Q: Given: Open water source Net radiation = 200 W/m2 %3D Air temperature = 30 °C Density of water = 996…

A: Evaporation is generally the method that modifies the water from a liquid to a gas and also vapors.…

Q: Air flows from a 10 cm pipe in which the temperature and pressure are 4-C and 280 kPa, respectively,…

Q: If a 136.51 g Al rod (c=0.900 J/g°C) is at 100.0°C and placed into 250.0 g of water at 21.8°C, what…

A: Given: The mass of the Al rod is 136.51 g. The specific heat of the Al rod is 0.9 J/ g°C. The…

Q: a) What is the effect of temperature on the tape? (Too Long or Too Short)?: b) What is the effect of…

A: a. As the temperature at field is greater than the standardised temperature, the tape becomes too…

Q: 1. Current mean temperature is 27°C. Current Vapor pressure is 2.337 kPa. (a) What is the dew point…

Q: When the temperature was 3 °C, the distance from E to F was measured using a steel tape that has a…

Q: line was measured using a 50m tape and was recorded as 746.22m. when the average temperature during…

Q: A rectangular lot was measured using a 50-m steel tape at 30 oC. If the recorded length and width of…

Q: It is required to layout on the ground a rectangular lot 505.20 m long and 251.70 m wide. The tape…

A: Given data- Rectangular lot(A) =505.20 m ×251.70 m A = 127158.84m² Length of tape…

Q: its PVI at elevation 264.9 from PVC. decimal places.

Concept explainers

Hydrogen Energy

Energy is a quantity that cannot be defined, its existence can only be felt. In simple language, if a system possesses energy, it can do a specific kind of work. There are many forms of energy sources which people can use to obtain work. Solar energy, tidal energy, hydroelectric energy, geothermal energy, wind energy are some of the renewable energy sources which are primarily used for the production of electricity.

Question

Convert 68°F to °C.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

A steel tape, known to be of standard length at 20°C, is used in laying out a runway 2500 m long.Determine the correct length when the temperature is 42°C.
Convert: Convert a (15.5 °C+ 17) temperature into °F temperature.
Calculate the thermal resistance due to convection for the following situations: a. warm water with h = 200 W/m2 K b. warm air with h = 10 W/m2 K c. warm moving air (windy situation) h = 30 W/m2 K
For Problems 11.11, 11.12, and 11.13, calculate the U-factors.
12. Change 303°K to degree Celsius and degree Fahrenheit Complete FBD, FORMULA, AND SOLUTION
A rectangular lot was measured using a 50-m steel tape at 30 oC. If the recorded length and width of the lot are 197.56m and 105.63m respectively.Determine the Error in the area, if the coefficient of thermal expansion is 0.0000116/ oC and standard temperature of the tape is 25 oC. fundamentals of surveying
3- 50 m tape was used to measure line SF; if the measured distance was 1288.54 m. Find the corrected distance if the true length of the tape is 49.96 m, the field temperature is 33, the standard temperature is 20, the thermal expansion coefficient is 0.00002.
Estimate the vapor pressure, air pressure, relative humidity, and air density at a height of 1500 m into the atmosphere. The total pressure is 100 kPa, air temperature is 28°C and the dew point temperature is 16°C near the ground, the lapse rate 6°C/km, which is constant for both air temperature and dew point temperature. The gas constant R is 287 J/kg-K and constant with respect to altitude. Relative Humidity at 1500m, in % Round to one (1) decimal place
topic: surveying A rectangular lot was measured using a 50-m steel tape at 30 oC. If the recorded length and width of the lot are 197.56m and 105.63m respectively. Determine the Error in the area, if the coefficient of thermal expansion is 0.0000116/ oC and standard temperature of the tape is 25 oC.
24. A 30 m. steel tape is 2 mm too long at 20° C with a pull of 55 N. A rectangle in measured with this tape. The sides are recorded as 144.95 m. and 113.00 m. The average temperature during the measurement is 30° C with a pull of 55 N. Use coefficient of expansion of steel tape as 0.0000116/°C. What is the true area?
A steel tape is 30 meters long at 20 degree Celsius with a pull of 60 N. A rectangular lot is measured using this tape. The sides are recorded as 145 meteres and 113 meters. The average temperature of the tape during measurement is 29.4 degree Celsius with a pull of 60 N.
An electrical current flows through a long bar, generating thermal energy at a rate uniform volumetric of q = 2 × 105 W/m 3. The bar is concentric with a hollow ceramic cylinder, creating an air-filled space between the two. If the external surface temperature cannot exceed 40 °C, what is the minimum speed that the ambient air should be blown? the neighborhood meets at 25 °C and the emissivity of the ceramic is 0.8. If the bar has an emissivity of 0.2, what is the bar surface temperature?