Convert the decimal value -16.3 using the 32 bit IEEE 754 standard.
Q: 21) Design a logic cct. That give output equal one when the input between 5 and 25 22) redesign the…
A: 1) We have to design the logic circuit, that give output one, when the input between 5 and 25, which…
Q: H.W. for Bipolar +Ao logics → Am -A togico→-Aen Vth ?? frove
A: prove pc=Q(Aσn)=Q(SNR)
Q: Q13/Assume that the microprocessor can directly address 64K with a and 8 data pins The memory map…
A: Dear student, the whole answer is attached in step 2 since it is one part direct question.
Q: Show (in binary) the IEEE 754 single precision floating point representation of each of the…
A: Note: As per the guidelines will be solving only 3 subparts. Please repost for others. Each number…
Q: Write comparison between Diode transistor logic and Transistor Transistor logic
A: We need to find the difference between Diode Transistor logic and Transistor Transistor Logic Diode…
Q: Q12: the length of buss address in 8086: a) 8 bits b) 10 bits c) 16 bits d) 32 bits
A: Address buses is used for carrying memory address from the processor
Q: Q3 What is a Field-Programmable Gate Array? What are the major components of an FPGA? Q1 Please…
A:
Q: Find the transfer functions for the two systems shown in Figure (E.(S)/E(S)). R2 E'(s) EAN) E(s)…
A: In this question we will find transfer functions...
Q: 8.2. Draw the equivalent Logic Gate Circuit of the Ladder Circuit below. Out1 H
A: The functioning of a digital logic circuit is defined by a collection of laws and rules called…
Q: 2) A single-phase full-bridge inverter has a DC voltage source V = 230 V. The rms value of the…
A: Option B is correct. The detailed solution is provided below.
Q: There is 180 degree phase displacement between two SCR gate signals in single phase half bridge…
A: Single phase half bridge inveter is used to convert Dc voltage to AC voltage, it consist of two SCR…
Q: why 8085 up have 16 bit Address than 80864p Contaim do bit Address
A: 8085 microprocessor: The 8085 is a 8 bit microprocessor which is produced by intel it is…
Q: Using the DC operating conditions from the following table, give the noise margin HIGH (NMH) for the…
A: Given that, VOHmax=2.4 VIHmin=2 A Noise margin is the amount of noise that CMOS can withstand…
Q: [Erickson 19.6(2"d edition)/22.6(3rd edition)]In a certain resonant inverter application, the de…
A:
Q: Convert to Octal, Decimal and Hexade ximal. 319812
A:
Q: i. Draw the circuit diagram of 4-bit Ripple Carry Adder.
A: To draw the circuit diagram of 4 bit ripple carry adder 4 full adders are connected one after…
Q: Convert the following binary number into BCD. 110010.01
A: The solution can be achieved by first converting binary number to decimal then from decimal to BCD.
Q: Consider Analog to Digital Converters, calculate the following for a 3-bit quantizer with a range…
A: Since you have asked multiple subparts I will answer the first three subparts for you . a):- The…
Q: ii. Draw logic diagram of half subtractor.
A:
Q: Draw 8259A interfacing connections with 8086 at the address 0744H.
A: The 8259A interfacing connection with 8086 at address 0744h is shown below:
Q: Example Assuming that a 3-bit ADC channel accepts analog input ranging from 0 to 5volts, determine…
A:
Q: BE819)16 |binary (1100.101)2 to BCD code conversions: Ren
A:
Q: :8086MP memory is logically divided into segments, the size of each segment is 128Kbyte 1Mbyte…
A: Note: Since you have not specified any question to be answered, as per our honor code, we are…
Q: Please write the RISC-V assembly instructions that create the 32-bit constant Ox23453456 and store…
A: ASSEMBLY LANGUAGE INSTRUCTIONS: ADDI : This instruction modifies the contents of the source register…
Q: 1. bit microprocessor type. d.8 1.u8086 is а.4 b.16 с.20 2.u8086 have . Data line а.4 b.16 с.20 d.8…
A: As per our guidelines when student posts mcq question we have to answer first three questions.…
Q: The following digital IC is: TTL AND gate OTTL NOT gate CMOS NAND gate TTL NAND gate OCMOS AND gate…
A: Given, Digital IC (integrated Chip ) is SN 7400 N
Q: Q5. Design a code converter circuit that converts 2 bits binary number system to Gray code.
A:
Q: Q1: Design XNOR logic gate by using McCulloch-Pitts neuron model? 1 A XNOR B
A: As per policy, I can only answer 1st question. If you want others then, please resubmit.
Q: in Intel 8086 microprocessor, the memory address for the code segment 771F h and offset 3584 h is O…
A: memory address = code segment + offset 1. Given code segment = 771F and offset = 3584 H code…
Q: For an 8-bit flash ADC with Vref = 2.5 V, what is the output binary code if Vin = 1.78 V? 01101101…
A:
Q: Which of the following is correct regarding the comparison between TTL and CMOS? >CMOS design is…
A:
Q: Show IEEE 754 binary representation of the number (-0.75)10 in single precision Format
A: Given:Decimal Number=-0.75
Q: 2. Design transistor level circuits for a 4-bit even parity generator using (i) CCMOS logic (ii)…
A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…
Q: Design a Flash ADC for 4 bit conversion. (Show the design details
A: Analog circuits may face the more power constrained situations. Designing of Microprocessor and SoC…
Q: 78510 BCD (Binary-Coded-Decimal) %3D
A:
Q: Construct 3 input NAND using Register Transistor Logic (RTL).
A: 3 input NAND gate required 3 Transistors In RTL logic we use combinations of BJT and Resistors
Q: - Explain the difference between binary and BCD using a decimal value 15.
A: As per our policy, i have attempted 1 question. Difference between binary and BCD using a decimal…
Q: 2. How many X states does a decimal- to-binary encoder have on its Karnaugh's map? (X=don't care) а.…
A: For th equestion the answer is as follows
Q: Each frame (cycle) of E-1 PCM system is containing? a. 264 bits; b. 128 bits; c. 254 bits; d. 256…
A: E-1 PCM SYSTEM: The structure of the E-1 frame is as follows:
Q: The dynamic range of PCM is equivalent to the following; a. Number of levels -1 O b. Number of bits…
A: Dynamic range of pcm is equivalent to 2^n -1 The possible number of levels are 2^n n is no of…
Q: - Explain the difference between binary and BCD using a decimal value 20.
A: Note :As per our Guidelines we are supposed to answer only 1 question. Kindly repost the other…
Q: Which of the following is a RISC architecture? a) 80286 b) MIPS c) Zilog Z80 d) 80386
A: RISC or Reduced Instruction Set Computer is a computer system with highly optimized set of…
Q: ICs 74LS is categorized as O a. Low voltage TTL O b. Low Power CMOS O c. Low power TTL O d. Low…
A: Given IC 74LS belongs to which category
Q: CMOS ICS with a prefix 74 series are used for .... O a. security O b. military O c. commercial O d.…
A: The CMOS ICs of 74 series logic family are used for commercial operating temperature range
Q: How many address lines at required for a 16M x 8 ROM chip? A.16M B.23 C.21 D.24 E.13 F.11 G.14 H.8
A: Given, 16M x 8 ROM chip address lines are decided by 16 M data lines=8
Q: Design a BCD to decimal decoder. NOTE: SUB: DIGITAL LOGIC AND DESIGN(DLD) DEPTT:CS/IT.
A: BCD to decimal decoder: Let ABCD be the BCD number and D0,D1,.....D9 be the output decimal number.
The decimal value is (-16.3)10
Since it is a negative number, so MSB will be 1.
Convert the integer part into binary
(16)10 --> (10000)2
Step by step
Solved in 3 steps
- BCD isA. Bit Coded digitB. Binary Coded DecimalC. Bit Code digitD. Binary Coded DigitWrite an assembly language program for 8085 microprocessor to add 2 digit BCD numbers stored in memory location C050H and C051H respectively and store the result in memory location C052H.Microprocessor , For a data segments for an 8086 µP memory system has 64 kB size, with segment address is 1234 H. Find the offset for a memory address 125FC H.
- Design and Implementation of Binary to BCD (binary coded Decimal ) notation using Verilog code.A 14-bit ADC has VFS = 5.12 V and the output code is (10101110111010). What is the size of the LSBfortheconverter?What range of input voltages corresponds to the ADC output code?Design transistor level circuits for a 4-bit even parity generator using (i) CCMOS logic (ii) pseudo-nmos logic (iii) pass transistor logic, (iv) transmission gate logic.