d) Determine the internal pressure that is required to open the pressure relief valve. e) Heat is added to the pressure cooker with the relief valve in place. The pressure relief valve opens when the pressure reaches the value caleculated in (d) and allows vapor to escape in order to maintain the pressure at this value. What are the temperature and quality of the water in the pressure cooker at the instant that the pressure relief valve opens at state 2? Add state 2 to your T-v sketch from (c). ) What is the fraction of the volume of the pressure cooker that is filled with liquid at the instant that the pressure relief valve opens (at state 2).

d) Determine the internal pressure that is required to open the pressure relief valve. e) Heat is added to the pressure cooker with the relief valve in place. The pressure relief valve opens when the pressure reaches the value caleculated in (d) and allows vapor to escape in order to maintain the pressure at this value. What are the temperature and quality of the water in the pressure cooker at the instant that the pressure relief valve opens at state 2? Add state 2 to your T-v sketch from (c). ) What is the fraction of the volume of the pressure cooker that is filled with liquid at the instant that the pressure relief valve opens (at state 2).

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter2: Matter And Energy

Section: Chapter Questions

Problem 29RQ: If 3000 ft3 of air is crossing an evaporator coil and iscooled from 75F to 55F, what would be the...

See similar textbooks

Similar questions

The two ways that fresh air enters a structure are _______and_____.
One British thermal unit will raise the temperature of _____ 1b of water _____F.
In a tank with a height of 1 meter, open to the atmosphere at the top, there are two immiscible liquids (which do not mix) and whose densities are 13,600 kg/m3 and 750 kg/m3, respectively. The tank is completely full and each liquid occupies half of the container. If the atmospheric pressure of the place is 105 Pa, at what depth, measured from the top of the tank, is the value of the gauge pressure equal to half the value of the atmospheric pressure of the place? Consider that the gravitational acceleration of the place is 9.8 m/s2? a) 84.76 cmb) 34.75 cmc) 50.00 cmd) 37.51 cm
7. An air bubble rises from the bottom of the well where the temperature is 20°C to the surface where the temperature is 50°C. If the existing atmospheric pressure at the surface of the well water is 101.3kPa, determine the percent increase in volume of the bubble if the pressure in the bottom of the well is 200kPag. Draw a figure or FBD that will support the problem. Explain each step by step formula.
Q2/ A vessel having a capacity of 0.05 m3 contains a mixture of saturated water an saturated steam at a temperature 245oC the mass of the liquid present is 10 kg. find the following: i- The pressure. ii- The mass. iii- The specific volume. iv- The specific enthalpy. v- The specific internal energy.
An airtight dispenser for drinking water is 25 cm × 10 cm in horizontal dimensions and 20 cm tall. It has a tap of negligible volume that opens at the level of the bottom of the dispenser. Initially, it contains water to alevel 3.0 cm from the top and air at the ambient pressure, 1.00 atm, from there to the top. When the tap is opened, water will flow out until the gauge pressure at the bottom of the dispenser, and thus at the opening of the tap, is 0. What volume of water flows out? Assume the temperature is constant, the dispenser is perfectly rigid, and the water has a constant density of 1000 kg/m3
For the compressed liquid, what property(ies) is (are) used to determine other properties (1) if the compressed liquid table is used?___________ A. Pressure only B. Temperature only C. Pressure and Temperature D. either pressure or temperature
Condition State T > Tsat T < Tsat P > Psat P < Psat H > Hsat H < Hsat Fill in the table by determining if the state of the fluids is compressed liquid or saturated vapor at the given conditions.
The pressure in an automobile tire depends on the temperature of the air in the tire. When the air temperature is 25 degC, the pressure gage reads 210 kPa. If the volume of the tire is 0.025 m^3, the pressure rises in the tire when the air temperature in the tire rises to 50 degC. Determine the amount of air, in kg, that must be bled off to restore pressure to its original value at this temperature. Assume the atmospheric pressure to be 100 kPa
Helium is used in the Carnot engine where the volumes beginning withconstant temperature heat addition are V 1 = 0.3565 m^3 ; V 2 = 0.5130 m^3 ; V 3 = 8.0m^3 ; V 4 = 5.57 m^3 . Determine the thermal efficiency. Use 1.66 as the specificratio of helium. show diagram
COnsider the system
A 6m 3 tank contains helium at 127 C and in evacuated from atmospheric pressure to a pressure of 740mm Hg vacuum. Determine (a) mass of helium remaining in the tank (b) mass of helium pumped out (c)the temp of the remaining helium falls to 10 C, what is the pressure in Kpa? R of helium is 2077.67J/kg-K.