Solve item d to f For the network of Fig. 11.65:(a) Determine re.(b) Find A, = V,/V;.(c) Calculate Z;.(d) Find Aysmi = V,/Vs.(e) Determine fty flo and fLe:(f) Determine the low cutoff frequency.(g) Sketch the asymptotes of the Bode plot defined by the cutoff frequencies of part (e).(h) Sketch the low-frequency response for the amplifier using the results of part (f).15.14 V5pFpFC, - 12 pFC- 40 pFC 8 pF战 k047 µF047 MF20FFigure 11.65 Problems 15, 22, and 33

Answered: Image /qna-images/answer/0d227f20-5b74-4012-b6b2-3b131497a9b2.jpg

Answered: (d) Find Am = V./Vs. (e) Determine fLo…

Engineering

Electrical Engineering

(d) Find Am = V./Vs. (e) Determine fLo fLe and fLp: (f) Determine the low cutoff frequency. Smi

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

please let me know the answers of belows; 1)A DSB transmission uses a 1kW carrier and is amplitude modulated to adepth of 20%. What ist the total power being transmitted? 2)A DSB transmission uses a carrier of 600kHz amplitude modulated by aninformation signal containing components extending from 100Hz to6kHz. The total bandwidth being transmitted is:a) 5.9kHzb) 606kHzc)200Hzd) 12kHz
A 25 V, 2.5 kHz supply is connected to a network comprising a variable capacitor in parallel with a coil of resistance 250 ohm and inductance 80 mH. Determine for the condi tion when the supply current is a minimum (a) the capacitance of the capacitor, (b) the dynamic resistance, (c) the supply current, (d) the Q-factor, (e) the bandwidth, (f ) the upper and lower half-power frequencies and (g) the value of the circuit impedance at the −3 dB frequencies.
An amplifier, having a temperature of 30 K is placed in a microwave environment with a noise temperature of 40 K. Estimate the available noise power per unit bandwidth.
A superheterodyne receiver is to tune the range 88.1MHz to 107.1MHz. The RF circuit inductance is 1μH. Low-side injection is used.a. Calculate the minimum capacitance of the variable capacitor in the RF circuitb. Calculate the RF circuit capacitance tuning ratio c. If the receiver has a single converter stage and IF of 800kHz, calculate the capacitance tuning ratio of the local oscillator d. If the maximum capacitance of the variable capacitor of the local oscillator is 0.2pF, calculate the minimum capacitance e. If the receiver has a single converter stage and IF of 800kHz, calculate the image frequency of 103.7MHzf. Calculate the IFRR (in dB) of (e) if Q of the preselector is 50 g. To increase the IFRR of (e) to 40dB, double conversion is used. What must be the frequency of the 1st IF?
4. The front end of a television receiver, having a bandwidth of 7 MHz andoperating at a temperature of 27° C, consists of amplifiers having a gain of 15, followed by a mixer whose gain is 20. The amplifier has a 300Ω input resistor and a shot noise equivalent resistance of 500Ω . For the mixer; these values are 2.2kΩ and 13.5 kΩ, respectively, and the load resistance of the mixer is 470 kΩ. Calculate the equivalent noise resistance for this television receiver.5. A receiver connected to an antenna whose resistance is 50Ω has an equivalent noise resistance of 30Ω. What is the receiver’s noise temperature?
R= 300 ohm, L= 40 mH, C= 600nF, V(AC)=5 Volt, F= 100 Hz Calculate theoretically the voltages XL (Inductance = Resistance of the coil), XC (Capacitance = resistance of the capacitor), Z (Impedance = Equivalent resistance of the circuit), VL, VC, VLC and the current value I (mA). Also explain the relationship of XL and XC with frequency in two words. Write the relation that gives the resonant frequency.
Problem 1 The transistor parameters for the given circuit are β = 100, VBE (on) = 0.7 V, and VA = ∞. Determine the midband gain AvM, corner frequencies fL and fH, and bandwidth BW of the given amplifier. Problem 2 Determine the corner frequencies and limiting horizontal asymptotes of a commonemitter amplifier with an emitter bypass capacitor. For the given circuit, RE = 4 kΩ, RC = 2 kΩ, RS = 0.5 kΩ, CE = 1 μF, V + = 5 V, and V − = −5 V. The transistor parameters are: β = 100, VBE(on) = 0.7 V, and ro = ∞.
A communication system has five stages, with gains and attenuations of 12, 245, 68, 231, and 9 dB. What is the overall gain?
Given a common emiiter amplifier (Fixed BIas) with the following network: RB = 900k, Rc = 1k, Beta = 150, Vcc = 12V. Determine the input impedance." 6.8 ohms 3.1k ohms 2.7k ohms 1k ohms The circuit does not operate as an amplifier 1.974k ohms 8.621 ohms
A 210743 transistor that operates at a frequency of 20 MHZ, Ic= lmA, Vce 12V with the following parameters and in common emitter expressed in millihos yi=2.7+j22.07, i = 0.01+j55, yf=53-j26, yr =- 0.-j4.5 Calculate its operating parameters to be used as an amplifier. With an Rg of 50Ω and a Ro 50Ω.
ı just need the fınal answer Since Vcc = 20 V, RS = 3 kΩ, RB = 380 kΩ, RC = 1.2 kΩ, RE = 2.2 kΩ, RL = 911 Ω and β = 90 in the circuit in the figure, find the value of the output voltage (Vo). NOTE-1: It is within the 1 kHz mid-band frequency and the capacitors are negligible at this frequency. NOTE-2: The output impedance (r0) of the transistor will be neglected. a. 64,14 mV b. 83,88 mV c. 93,75 mV d. 74,01 mV e. 103,62 mV f. 24,67 mV g. 34,54 mV h. 49,34 mV
calculate both quality factor Q and resonance frequency if it exists