Question 16Which of these atmospheric reactions leads to acid rain?ON2+ 3 Hy+2 NH:O 0+ H+ 2 HCIQuestion 17Which of the following treat smog from industrial smokestacks by passing the stack gases through water?O Wet scrubberO Bectrostatic precipitatorO Catalynic converterO Cyclone separator

Answered: Image /qna-images/answer/9a83194d-a1a7-4db8-9275-171f9b42caf5.jpg

Answered: D Question 16 Which of these…

Science

Chemistry

D Question 16 Which of these atmospheric reactions leads to acid rain? OC•O Co, ON+3Hy 2 NH; O 0+ Hy2 HCI

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

1) Commercial fuming Sulphuric acid (Oleum-H2S2O6) is 99.9% solution. Please convert it into molarity.2) Find out the Volume (dm3) of product (gas) at RTP when 0.58 M, 150 mL NaOH (aq.) reacts with 350 mL, 0.25 NH4Cl.
(a) A commercial 737 jet transporting 143 passengers and 5 crew members from Kansas City (MCI) to Baltimore (BWI) burned 11,800 lb (about 1700 gallons) of Jet A fuel en route. Jet A fuel is kerosine based, consisting primarily of CnH2n+2 hydrocarbons, with n =6 to 16, so the carbon:hydrogen ratio is close to 1:2. During this flight, how much CO2 was released into the atmosphere? Assume the combustion of the fuel was complete, so all the fuel was burned to form CO2 and H2O. Give both the mass of CO2 produced (in kg and in lbs) and the volume it would occupy at 298 K, 1 atm.(b) How much CO2 would be released into the atmosphere if those passengers and crew made the trip instead, in pairs, in hybrid cars at 40 miles per gallon. Assume the density of the gasoline is 0.75 kg L-1 and that carbon and hydrogen dominate the composition in a ratio of 1:2. The road trip is 1082 miles.
Answer the problem using the rubrics below as a guide: Given and Asked - Complete data and proper units and significant figures (SF). Equation or formula used - Necessary equations needed in solving the problem are shown. Solution -Complete and organized solution/s shown Correct answer with correct significant figures (SF) and unit. Hydrogen is prepared commercially by the reaction of methane and water vapor at elevated temperatures. CH4 (g) + H2O (g) ⇌ H2 (g) + CO (g) What is the equilibrium constant for the reaction if a mixture at equilibrium contains gases with the following concentrations, at a temperature of 760°C? CH4 = 0.126 M H2O = 0.242 M CO = 0.126 M H2 = 1.15 M
Report sheet analysis of KCIO3/KCI Unknown substance 1 Mass of empty 400mL beaker 164.93g, Mass of 30mL beaker+test tube 96.181g, Mass of 30mL beaker+test tube+unkown mixture 97.218g, Mass of unkown substance 1 1.037g, Mass of 400mL beaker and water 304.97g, Temperature of O2 20 celsius, Atmospheric pressure 750.1 torr. Mass of water ___, Volume of O2___, Vapor pressure of water ___torr, Partial pressure of O2 (Po2) ___torr, Partial pressure of O2 (Po2) ___atm, Moles of O2 (no2) ___, Moles of KCIO3 in unkown ___, Grams of KCIO3 in known ___, % by mass KCIO3 in unknown ___.
Combustible vapor-air mixtures are flammable over a limitedrange of concentrations. The minimum volume % of vapor thatgives a combustible mixture is called the lower flammable limit(LFL). Generally, the LFL is about half the stoichiometric mix-ture, the concentration required for complete combustion of thevapor in air. (a) If oxygen is 20.9 vol % of air, estimate the LFL forn-hexane, C₆H₁₄. (b) What volume (in mL) of n-hexane (d=0.660 g/cm³) is required to produce a flammable mixture of hexane in 1.000 m³of air at STP?
Sulfur dioxide emissions from coal-based power plants areremoved by flue-gas desulfurization.The flue gas passes through a scrubber, and a slurry of wet calcium carbonate reacts with it toform carbon dioxide and calcium sulfite. The calcium sulfite then reacts with oxygen to form calcium sulfate, which is sold as gypsum. (a) If the sulfur dioxide concentration is 1000 times higher than its mole fraction in clean dry air (21010), how much calcium sulfate (kg) can be made from scrubbing 4 GL of flue gas (1 GL1X10^9L)? A state-of-the-art scrubber removes at least 95% of the sulfur dioxide. (b) If the mole fraction of oxy-gen in air is 0.209, what volume (L) of air at 1.00 atm and 25°C is needed to react with all the calcium sulfite?
The volume of HCI is 100 mL , mass of solid added is 1.008g, moles of solid 0.0276 Mol, mass of HCI is 100g, initial temperature is 21.8 degrees Celsius, Final temperature is 30.7 degrees Celsius, Calculate q rxn(= -mc Delta T of HCI),
1) Mass of flask, aluminum foil, and rubber band 68.45g 2) Temp. Of boiling, water 98.20 0C 3) Barometric pressure 755 mmHg 4) Volume of flask (volume of vapor occupies flask) 152 ml 5) Mass of flask, aluminum foil, rubber band, and condensed vapor 68.60g 6) Mass of condensed vapor is (5)-(1) Find Molecular weight of unknown ______ g / mol Calculation PV = (m/M)RT) è M = (mRT) / PV = ? Unknown liquid- Based on Molecular weight determine which unknown below has this molecular weight: Methanol, Ethanol, Isopropanol, Propanol. UNKNOW IS : __________________________
Baking soda (sodium hydrogen carbonate) is used as a leavening agent on making bread according to the reaction below. Calculate the volume of CO2 (g) formed at 200°C and a pressure of 740 mm Hg if the baker used 5.50 g of baking soda. (Molar Mass of NaHCO3 is 84.0071 g/mol) Enter answer without unit. NaHCO3 (s) + HCl (aq) ---> H2O (l) + CO2 (g) + NaCl (aq)
A bucket has 100 m3 of air, 60 m3 of water and 3 m3 of sediment. You add 2 mol of benzene to the water in the bucket. 1) Draw a conceptual model of this system. 2) Using arrows or some other symbols, identify what will happen to the benzene at equilibrium. Write the mass balance for this. Is it open or closed? Write the mass balance for an open system. What is fugacity used for? What is the difference between steady state and equilibrium?
Chemistry For this exercise, you can simulate the described conditions by changing the values in the Run Experiment tool, under the Experiment tab, in the simulation. The hints run through each step in the calculation, where the equations are given before this part. The second hint calculates the temperature change, which is the only step that requires the simulation. Use the simulator to react 61 mLmL of 1.6 MM HNO3HNO3 with 57 mLmL of 1.8 MM KOHKOH at an initial temperature of 20.00 ∘C∘C; note the final temperature. Use the data from the simulation to calculate the change in enthalpy per mole of product (nn). Estimate the density of the liquid to be 1.00 g/mLg/mL. Final temp: 31.27 C
Initial concentrations For mixture #1 (see p.15 for preparation), show the worked out calculations for the initial concentrations of .... The first question