d The L-shaped fish tank shown in Fig. 14-33 is filled with water and is open at the top. If d = 5.0 m, what is the (total) force exerted by the water (a) on face A and (b) on face B? d 2d 3d A d B d d. 2d

d The L-shaped fish tank shown in Fig. 14-33 is filled with water and is open at the top. If d = 5.0 m, what is the (total) force exerted by the water (a) on face A and (b) on face B? d 2d 3d A d B d d. 2d

Name: dThe L-shaped fish tank shown inFig. 14-33 is filled with water and i
Uploaded: 2024-03-20T06:51:10.000Z
Channel: Bartleby
Description: dThe L-shaped fish tank shown inFig. 14-33 is filled with water and is open atthe top. If d = 5.0 m, what is the (total)force exerted by the water (a) on face Aand (b) on face B?d2d3dAdBdd.2dFigure 14-33Problem 20.

Principles of Physics: A Calculus-Based Text

5th Edition

ISBN:9781133104261

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter15: Fluid Mechanics

Section: Chapter Questions

Problem 8P

See similar textbooks

Similar questions

Roofs are sometimes pushed off vertically a tropical cyclone, and buildings sometimes explode outward when hit by a tornado. Use Bernoulli’s principle to explain these phenomena.
Referring to Figure 14.20, prove that the buoyant force on be cylinder is equal to the weight of the fluid displaced (Archimedes' principle). You may assume that be buoyant force is F2F1 and that the ends of be cylinder have equal areas A. Note Eat be volume of be cylinder (and that of be fluid displaces) equals (h2h1)A .
Fluid originally flows through a tube at a rate of 100 cm3/s. To illustrate the sensitivity of flow rate to various factors, calculate be new flow rate for following changes with all other factors remaining the same as in original conditions. (a) Pressure difference increases by a factor of 1.50. (b) A new fluid wit 3.00 times greater viscosity is substituted. (c) The tube is replaced by one having 4.00 times the length. (d) Another tube used with a 0.100 times the original. (e) Yet another tube is substituted with a radius 0.100 times the original and half length, and pressure difference is increased by factor of 1.50.
What is the pressure drop due to the Bernoulli Effect as water goes into a 3.00-cm-diameter nozzle from a 9.00-cm-diameter fire hose while carrying a flow of 40.0 L/s? (b) To what maximum above be nozzle can this water rise? (The actual height will be significantly smaller due to air resistance.)
A Styrofoam slab has thickness h and density s. When a swimmer of mass m is resting on it, the slab floats in fresh water with its top at the same level as the water surface. Find the area of the slab.
Water pressure inside a hose nozzle can be less than atmospheric pressure due to the Bernoulli effect. Explain in terms of energy how the water can emerge from the nozzle against the opposing atmospheric pressure.
Explain why the fluid reaches equal levels on either side of a manometer if both sides are open to the atmosphere, even if the tubes are of different diameters.
Review. The lank in Figure P14.15 is filled with water of depth d = 2.00 m. At the bottom of one sidewall is a rectangular hatch of height h = 1.00 m and width w = 2.00 in that is hinged at the top of the hatch, (a) Determine the magnitude of the force the water exerts on the hatch, (b) Find the magnitude of the torque exerted by the water about the hinges.
Calculate the contact angle for olive oil if capillary action raises it to a height of 7.07 cm in a glass tube with a radius of 0.100 mm. Is this value consistent with that for most organic liquids?
An oil gusher shoots crude 25.0 m the through a pipe with a 0.100-m diameter. Neglecting resistance but not resistance of the pipe, and assuming laminar flow, calculate pressure at be entrance of be 50.0-m-Iong vertical pipe. Take of the oil to be 900 kg/m3 and its viscosity to be 100(N/m2) s (or 1.00 Pa s). Note that you must take into account the pressure due to 50.0-m column of oil in pipe.
Assuming bicycle tires are perfectly flexible and support the weight of bicycle and rider by pressure alone, calculate the total area of the tires in contact with be ground if a bicycle and rider have a total mass of 80.0 kg, and gauge pressure in the tires is 3.50105 Pa.
Check Your understanding Repeat ExampIe12.4 assuming that the forearm is object of uniform density that weighs 8.896 N.