DEGREE: ELECTRICAL ENGINEERING  SUBJECT/COURSE: INDUSTRIAL ELECTRONICS TOPIC: TRANSFORMERS   NOTE: Please solve in this way.  1. Please have a good handwriting, some of the answers are not readable. Thank you! 2. GIVEN. (Include symbols and units) 3. ILLUSTRATION (Required). 4. Step-by-step SOLUTION with Formulas and Symbols. No Shortcut, no skipping, and detailed as possible 5. FINAL ANSWERS must be rounded up to two decimal places with corresponding unit. PROBLEM: An 80:5 current transformer is connected to a 5-amp ammeter. if the latter reads 3.65 amp, what is the line current?

Q: Determine the equivalent impedance across a and b in polar form. Write the angle only in four decima...

A: In this question We need to determine the equivalent impedance across terminal a and b.  We are solv...

Q: Consider a silicon pn junction at T 300K. Assume the doping concentration in the n region is 1020cm ...

A:

Q: Consider a silicon pn junction at T = 300 K. Assume the doping concentration in the n region is 1020...

A: Given That T=300Kni=1.5×1010cm-3 doping in n region =1020cm-3doping in p region =1019cm-3forward bia...

Q: At Input wavefront →t -5 Voltage across the capacitor

A:

Q: The time period of a sine wave is 0.05 seconds. The frequency of the sine wave is О а. 20 Нz O b. 40...

A: Given, Time period of sine wave is, T = 0.05 sec

Q: 12–94. A golf ball is struck with a velocity of 80 ft/s as shown. Determine the speed at which it st...

A: Please refer the attached images for the complete answer..

Q: ketch the transfer curve for a p -channel device with IDSS = 4 mA and VP = 3 Vsfer curve for a p -ch...

A: It is given that: IDSS=4 mAVP=3 V  

Q: Select one: a. I1 = -6A, I2 = -5A b. I1 = -6A, I2 = 2 A c. I1 = 5A, I2 = -6A d. I1 =...

A: Given network,

Q: Given an analog filter Ha(s) = designed from H«(s) by many-one mapping method, assuming sampling per...

A:

Q: find the cir ca it carrent below lov lo0001 35 50052

A: Use basic network laws The current through any element depends on the voltage and resistance of it S...

Q: 18 1. Given a unity positive feedback system with open-loop transfer function G(s) =- s' +s* – 7s – ...

A: Control systems are represented by transfer function. This  can be written in both time domain and s...

Q: A shunt generator delivers 100 A at terminal voltage of 250 V. The armature resistance and shunt fie...

A:

Q: A 31kVA, 2300/460V, 2 winding transformer is to be connected as an auto transformer to step-up the v...

A:

Q: A synchronous motor takes 25kW from 400V supply mains. The synchronous reactance of the motor is 4oh...

A: Find the active and reactive power interms of Ef , Vt and Xs, delta . Then obtain the delta from act...

Q: What is the mass of an electron?

A:

Q: A 3-ф, star-connected synchronous motor takes 48 kW at 693 V, the power factor is 0.6 lagging. The i...

A:

Q: 2. A pair of automotive headlamps is connected to a 12 V battery via the arrangement shown in figure...

A: Given circuit,

Q: S; + Se A So Σ Sib Figure Q1(a)

A:

Q: alternator has 6 poles. (a) At what speed must the machine be driven to develop 60 cycles? 25 cycles...

A:

Q: Farad with supply frequency of 50 Hz. What is the capacitive reactance

A:

Q: 2. Kirchhoff's Current Law (KCL) Experimental Procedure Design the circuit using resistors and power...

A: “Since you have posted a question with multiple sub-parts, we will solve the first three subparts fo...

Q: Using KVL, find the currents I, and I2 in the circuit shown below.

A:

Q: Applying the different laws and identities in Boolean algebra, determine the minterm expansion of th...

A:

Q: Show Work Here: R 1.5 Amp 2. Calculate the missing values for the circuit below: Show Work Here: Amp...

A:

Q: 1. Find the Thevenin equivalent voltage VTH seen at the boundaries of R2. 2. Find the Thevenin equiv...

A:

Q: 8Ω + 5A 12Ω

A:

Q: What will be the output voltage during the negative half cycle of the input voltage? V-SV 20 -10

A:

Q: Give example problems for impedances and admittance.    Equation: Z = R ± jX or Z2 = R2 + X2

A: Please refer the attached images for the complete answer..

Q: an FM broadcast transmitter, the carrier signal is being deviated between 103.505MHz and 103.495MHz,...

A: We need to analyse the given frequency modulation signal .

Q: Obtain the truth table of the following functions, and express each function in minterms and/or  max...

A: Given expression : a)  (c’ + d)(b + c’) Truth Table is given by, d b c y 0 0 0 1 0 0 1 0 0 ...

Q: R1 R4 3.0 kn 1.5 kn +10V +V R2 R3 2.5 kn 7.5 kn Figure 4.5

A:

Q: DC motor position control system b. Antenna Control system

A: Open Loop System- A system which is controllable in which input of the system does not depends on th...

Q: Normally, you would construct the KCL equations for each nonreference essential node using the same ...

A:

Q: A 120 V, 5.6 kW, 1900 rpm d shunt motor requires only 16 volts to send armature-full-load current th...

A: Answer-        

Q: three phase inverter

A: Diode- When diode is forward biased it is short circuited in a circuit ideally. When diode is revers...

Q: ? She is very young. How is she

A: The given sentence is shown below: She is very young.How ........ is she?

Q: A 2300/230-volt distribution transformer is tested for polarity. If 118 volts is impressed across hi...

A:

Q: 2. What is the minimum B. Wrequired to nodulate the voice signal by using AM-DSB -SC? 3. Why we used...

A: As per guidelines,  we can only provide the solution of one question in multiple type question. To f...

Q: Consider a silicon pn junction at T 300 K with an acceptor doping concentration (1 x 10 cm) and a do...

A: We need to find out built in potential for given diode .

Q: A capacitor is constructed with parallel metal plates, If the plate separation is 2 mm and the capac...

A: Option b  0.23 square meters Capacitance for parallel plate capacitors can be found directly by usin...

Q: e and f is 5

A:

Q: Ammeter A) CH2 lc IR CH1 Ocilloscope utlet O V Hz 20µF 2800 250 GND

A: Since the value of L=800H and freuency is f=60Hz the inductive reactance is given as: XL=2πfL=2π×60×...

Q: 5. For the below system, find the following: a). What is the system type? b). What is the appropriat...

A:

Q: 4. Given the system as shown below, find the following: a). The closed-loop transfer function b). Th...

A: The solution is given below

Q: 1. If the current in the 6-ohm resistor is 18 amperes, determine the voltage E and the following cur...

A:

Q: Determine Vo during the Positive Half Cycle of the input voltage. 10 ka 10 V Si 5.3 V= 7.3 V -10 V

A:

Q: Determine the magnitude of the current flowing through a 4.7 kΩ resistor if the voltage across it is...

A:

Q: RT, IT, 11, I 2, 1 3, I 4, I 5, 16 I3 R1= 3kN R3= 2k2 I Rs= 5kN I6 111V R2= 8kN R= 7k2 R= 6k2

A:

Q: Q.3 Find the technique (2TF RIS) Ha RLS), és)

A: Transfer function: It shows the relation between output and input of the system.

Q: Given: R1 = 2 kA R2 = 1.3 kN R3 = 5.8 k E = 12 V D1: Si, rB = 3 0, rR = 225 k D2: Si, rB = 4 , rR = ...

A:

Analog to Digital Converters

The analog-to-digital converter (ADC) allows circuits controlled by microprocessors, Arduinos, Raspberry Pi, and various reasonable digital circuits to be connected to the real world. In the real world, analog signals have a continuous stream of information from a variety of sources and sensors capable of measuring sound, light, temperature, or movement, in addition to the many digital systems that interact with their environment by measuring analog signals from those transducers.