degree. modulating voltage change by During AM, the phase angle of the

Q: Find Z for the maximum average Power transfer to the Lead for the circuits Shown below. JIr

A:

Q: Find the average value of each voltage.

A: Two periodic signals are given. Both these signals are clipped versions of sinusoidal signals.

Q: Calculate the phase margin and damping factor that correspond to an overshoot of (a) 0.5 percent,…

A: To determine the phase margin and damping factor of the given different values of overshoot.

Q: A 3 HWCR has a supply of 110V / phase. Find out the value of mean voltage for a delay angle of 150°…

A:

Q: C.) An impedance of 45 + jxL ohms is connected across another impedance of 30 – j120 ohms. The…

A: Inductive reactance XL is determined as shown below

Q: Problem: Caleulate Average valur, Runs value and Form fuctor of the sawtuutlh wave shon in the…

A: we need to find the average value,rms value,form factor.

Q: Problem: Caleulate Average value, Rus value aud Form fuctor of the sawtootla wave show in the…

A: we need to find average value , Rms value and Form factor for the sawtooth waveform given.

Q: 3. A series circuit composed of a 0.2 henry inductor and a 74 micro farad capacitor is connected to…

A:

Q: If the waveform has positive phase angle then its shifted to the left Select one: True False

A: Phase angle is defined as the angular displacement of waveform from the refrence point. In most of…

Q: A series circuit composed of a 0.2 Henry inductor and a 74-microfarad capacitor is connected to a…

A:

Q: The time-average power The total power crossing

A:

Q: ——- is the RMS value of output voltage of the step down chopper which is having 230v as a input for…

A:

Q: For am RC circuit with a reactance magnitude of 820ohm and resistance of 572 ohms what is the phase…

A:

Q: The Form Factor value of following waveform is

A:

Q: Determine the lag angle between the input AC and the output AC of the circuit in the figure below

A: we will use voltage division rule to output voltage phase angle. impedance of capacitor = 1j2πfC

Q: a/ What is the function of the inductance L in a single phase halfwave thyristor?

A: A half wave rectifier with a load consisting of R and L. If the SCR is triggered at a firing angle…

Q: The resistor in a series RCL circuit has a resistance of 120.0 ohms, while the RMS voltage of the…

A: The series RLC circuit is an important circuit analysed in circuits. All the three elements R,L and…

Q: Question: In the PWM method of controlling the average output voltage in a chopper,the on-time is…

A:

Q: Find the Peak Factor and form factor if random waveform has value of RMS value and Average value as…

A: The required parameters can be calculated by using the given RMS value and Average Values. The form…

Q: vo Vị

A: I am attaching detailed solution image of this question.

Q: Change over a long span of time means a. High Frequency b. Low Frequency c. High Phase d. Low phase

A: Correct option is b) Low frequency change over a long span of time means low frequency.  This means…

Q: In non-sinusoidal wave sources, the dissipated power in the load is depends on the value of . .…

A: Non sinusoidal wave source is Applied to the load then power dissipation?  Non sinusoidal wave have…

Q: Explain shortly the difference between the average power Pave and the reactive power Q of a…

A: The real power and reactive power relation can be given as .

Q: An impedance of 45 + jxL ohms is connected across another impedance of 30 – j120 ohms. The…

A: "Resonance" in the electrical circuits meance phenomena at which net impedance of the circuit…

Q: For the waveforms in Figure, determine the phase differences. Whichwaveformleads? В wt -60° 180° O…

A: Determine the phase difference and leading wave ?

Q: For the block diagram shown, draw the frequency spectrum (indicating voltage and frequency of each…

A: Given the block as shown below: We need to draw the frequency spectrum at points A, C.

Q: Obtain the equivalent circuit of thevenin at ab and the average power at the load

A: It can be redrawn as

Q: 23An RLC series circuit consists of a 240W resistor, 5.0mF capacitor, and 3.0mH inductor connected…

A:

Q: The reactive factor is the cosine of the phase angle between the voltage and the current Select one:…

A:

Q: What is phase angle?

A: To discuss about phase angle.

Q: A series circuit composed of a 0.2 Henry inductor and a 74-microfarad capacitor is connected to a…

A:

Q: value of load impedance that absorbes maximum average power.

A: Given circuit is -

Q: B. For a signal of i(t) = 13- sin(2t) A, determine, and find the 1. average value 2. RMS value

A: Given: A signal of it=13-sin2t A

Q: Output voltage for Vmax = 350V and f = 60Hz and calculate the average value of its current.

A: The solution can be achieved as follows.

Q: Three Impedances each of (6-j26)Q are connected in mesh across a three-phase 425V ac supply.…

A: According to question: Let the three impedances are connected in star. The phase current is…

Q: The corona loss on a particular system at 50 Hz is 1 kW/km per phase. What is the corona loss at 60…

A: Given, For,Frequency, f1=50 HzCorona loss, P150Hz=1 kWkm per phaseAt,Frequency, f2=60 HzCorona loss,…

Q: Q/ Prove that the output of discrete LTI system for a sinusoidal input is sinusoidal

A: We need to prove the given statement.

Q: AC Power Analysis For the following waveforms, determine the average, effective, peak factor and…

A: The average value of the half-wave rectified waveform is…

Q: If the filter capacitance is decreased in n unregulated power supply, what happen to the ripples…

A: Given: Two multiple choice questions related to rectifiers and ripple voltage. Please find the below…

Q: The Thévenin impedance of a source is ZTn= 120 - 60 0, while the peak Thévenin voltage is VTh= 175…

A:

Q: Determine the magnitude of the source voltage

A:

Q: Determine Rab, Rbc, Rbd

A: Given circuit,

Q: For admittance locus the maximum obtained power factor is depend on:

A: => Power factor :- It is the cosine of angle between voltage and current flowing through the…

Q: 3. An impedance of 45 + jxL ohms is connected across another impedance of 30 – j120 ohms. The…

A: Resonance occurs when impedance offered by the circuit is optimum i.e. either maximum or minimum. At…

Q: (c) Determine the total current before and after power factor correction.

A: In the given question three different types of loads are connected in parallel. We will first write…

Q: What is the RMS value of 169sin 377t?

A: Given sinusoid is 169sin 377t.

Q: Determine the phase spacing D.

A:

Q: 3) A system has poles at 0.01 Hz, 1Hz and 80 Hz; zeros at 5 Hz, 100 Hz and 200 Hz, respectively. The…

A: Given :  In the given question they have mentioned the pole and zero frequencies such as,   Pole…

Q: determine for each : Frequency, Average Value over half a cycle, RMS Value, Form Factor, and Peak…

A:

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.