Demonstrate your ability to configure a switch in Packet Tracer. Your tasks include configuring initial settings using the Cisco IOS. You are to use a switch and two hosts/PCs on a cabled and powered network and ensure that you have carryout the following: Use a console connection to access the switch. Name the switch Use the password for all lines.

Demonstrate your ability to configure a switch in Packet Tracer. Your tasks include configuring initial settings using the Cisco IOS. You are to use a switch and two hosts/PCs on a cabled and powered network and ensure that you have carryout the following: Use a console connection to access the switch. Name the switch Use the password for all lines.

Comptia A+ Core 1 Exam: Guide To Computing Infrastructure (mindtap Course List)

10th Edition

ISBN:9780357108376

Author:Jean Andrews, Joy Dark, Jill West

Publisher:Jean Andrews, Joy Dark, Jill West

Chapter7: Setting Up A Local Network

Section: Chapter Questions

Problem 12TC

See similar textbooks

Similar questions

Please answer All 5. At what layers of the OSI Model can switches operate (give both the name and number)? 6. What routing protocols support VLSM? 7. What CLI commands on a Cisco ISR need to be entered in “global config” to set an ip address on a serial interface (DTE side) and activate it (choose an appropriate serial interface and ip address)? 8. What commands issued in a Cisco Catalyst Switch will make a port function as a trunk (List any and optional applicable commands)?
You as a network administrator want to protect the network from unauthorized traffic, and for this reason, you decide to change the native VLAN to an unused VLAN so that the untagged traffic is essentially directed toward a dead-end. Which of the following commands will you use to do this on a Cisco switch? a. set native-vlan-id b. set port-mode trunk c. switchport trunk native vlan d. ip dhcp snooping
Let's say you're checking your inbox first thing on a Monday morning at BMCC and your messages get there. Assuming the website at BMCC does not know the MAC address of the machine where these emails are being read. Specifically, walk me through the steps used by the ARP protocol to determine which machine on the local area network will be receiving the incoming Internet data. After 22 years, IPv6 Addressing change for around 30% of Internet traffic is complete. If you look carefully at the TCP and IP headers for IPv4 to IPv6 addressing, you'll see that the Ethernet frames' Maximum Transmission Unit (MTU) presents a problem for the transition.
You are the network manager for a computer training center that allows students to bring their own laptops to class for learning and taking notes. Students need access to the Internet, so you have configured your network’s DHCP server to issue IP addresses automatically. Which DHCP option should you modify to make sure you are not wasting addresses used by students who have left for the day?
Silicone Printers has raised a ticket claiming that it was unable to view websites from its workstations, because with every attempted access, the system displayed an error message that read "there is another device using the same IP address." What would you, as a network engineer, check for in such a scenario? Incorrect gateway Duplicate IP addresses Incorrect subnet mask DHCP scope exhaustion
Your DHCP server’s scope is too small for the number of computers that are connecting to it each day. The majority of your users are wireless and come and go during the day. Due to change control restrictions, you can’t increase the size of your DHCP scope to add more addresses until the weekend. What else could you do to provide a temporary solution to this issue?
H1 is unplugged from this LAN by the system administrator. Does this change affect the switch table? Explain your answer.