Derive condition of symmetry for Z- parameters. Consider the condition of symmetry as shown in figure Network Network

Q: Find the F.T. of the fall wing Signals (functions): F((t)=3 sgn(3t)- 1+jt Ans: F(W)==-2πew jw

A:

Q: Find the F.T. of the following Signals (functions) C. f(t) = 35gn (3t) 17;t d. f(t) = 1 + cos (6#+ +…

A:

Q: What is the impedance of the circuit consisting of 50 W resistor, 100 mH inductor, and 50 uF…

A:

Q: 3) Reduce (Simplify) the logic circuit expression A BU

A: Given logic circuit,

Q: Q4:- Find the load impedance (ZL) for the network in Fig.3 for maximum power to the load and find…

A: Given:

Q: (a) Determine the equivalent frequency domain impedance, Z for the circuit shown in Figure Q2(a). Z…

A:

Q: A circuit whose resistance is 20 Ω and inductance 10 H has a steady voltage of 100 V suddenly…

A: Given: R=20ΩL=10H Steady voltage, Vs=10V Let the Resistor is in series with Inductor.

Q: An electric power plant can produce electricity at a fixed power P, but the plant operator is free…

A: (a) Power lost= I2×R where, I= current through transmission line R= total resistance of transmission…

Q: 3.41 The input-output relationship of a system is giv by (a) r(t) = (c) where r(t) and c(t) are…

A: Given, The input output relationship of a system, rt=d2ctdt2+3dctdt+2ct Where rt is input and ct is…

Q: sketch a diagram showing the ohmmeter face for a reading of 1.2k ohms. Indicate the setting of the…

A: An ohmmeter is an instrument that measures the resistance of a circuit. It is also used to check the…

Q: Two positive point charges, 1 µC and 5 µC are separated by a distance of 3 m. Calculate the…

A: Given data, Q1=1 μCQ2=5 μCr=3 m

Q: What is the disadvantage of slip ring induction motor...?

A: Slip rings are mechanical devices that enable electrical power and signal transfer from a fixed…

Q: Please answer these question complete solution and readable (I'll rate it if it is complete…

A: Given data, Expression of currents are given, i1=102sinωt, i2=202sinωt+600

Q: Explain with the aid of a well labelled diagram the operating principle of an oil circuit breaker…

A: OIL CIRCUIT BREAKER It is one of the circuit breakers that uses oil as insulating medium for arc…

Q: Two coils in differential connection have a self-inductance of 2 mH and 4 mH and mutual inductance…

A: Given data, Self inductances are given, L1=2 mH, L2=4 mH Mutual inductance, M=0.15 mH

Q: In a 6-pole DC machine, 90 mechanical degrees corresponds to how many electrical degrees? (a) 270…

A: Given a DC machine has, Total number of poles, P = 6 Mechanical degree, θm=90°

Q: Explain regenerative braking in detail as applied to electric motive

A:

Q: Q1 Interpolate the sequence x[n] = {3, 6, 7) using the filter h[n] = {0.5, h[0] = 1,0.5} by a factor…

A: Solved using convolution method

Q: An alternate voltage signal with a root mean square value of 1.57 V, which is superimposed to a…

A: Given:  Vrms=1.57 VVdc=-4 V Required: Reading of the multimeter when the ACV function is selected?

Q: a) V1: c) V3: c) IT: V1 b) V2: d) RT:

A:

Q: For a second order system, natural frequency of oscillation is 10 rad/sec and damping ratio is 0.1.…

A: In this question,  We need to determine the settling time for the 2%.  We know  2% settling time =…

Q: please answer asap A 40Kw motor with a heating time constant of 120 minutes has a final…

A:

Q: Determine fundamental period of given signal x(t) = 2 cos 1.5 nt + sin 3.5 t

A:

Q: You are a student of Accra Institute of Technology who is offering the course Signals and Systems.…

A:

Q: Electrical Engineering a light beam illuminates a detector made of n type silicon with doping…

A: A light beam illuminates a detector made of n-type silicon with doping Nd=9.3×1016 cm-3 such that…

Q: 17. What are the basic gates in MOS logic family? a) NAND and NOR

A: The solution is provided in the following section.

Q: 2. How to solve electric circuit analysis using transform method (series circuit analysis & parallel…

A:

Q: a) Explain the cooling process of an oil-immersed transformer.

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Q3) Current division method a) Determine the current Given: R1 = 10 , R₂ = 22, i in the Is = 4 A…

A: Given circuit, Where, R1=10 ΩR2=2 ΩIs=4 A

Q: 4. Use Thevenin's theorem to find the current flowing in the 82 resistor for the circuit shown in…

A: Given data : The given circuit is shown below,

Q: 7.35 Find the solution to the differential equation 2dy (1)/dt+ 3y(t) = x(t) if (a) x(t) = 2te, with…

A: Given data : The differential equation is, 2dytdt+3yt=xt,  if (a). xt=2te-t with initial condition…

Q: what is circuit breker ? function

A: Given: what is a circuit breaker? Required: Function of the circuit breaker

Q: 19. What is the minimum distance required for single error detection according to Hamming's analysis…

A: In this case, using Hamming's analysis, the correct option needs to be selected.

Q: R(S)' a. Controller s+1 s+6 V₁(s) S-2 V(s) Fig.1b: Block diagram of the shock absorber Y Posi Find…

A:

Q: The carrier c(t) = 100 cos(2πft) is frequency modulated (FM) by the message signal m(t) = 5 cos(…

A: (1) From message signal mt=ACcos2π104t, the maximum frequency is fm=104 Hz. Determine the modulation…

Q: 19. A fully loaded 15-hp Induction motor operates from a 480 V, 60 Hz line at an efficiency of 83…

A:

Q: Find, graphically, the convolution between xit) and hit) __X(t) = sint tho ₂ h(t) = S(t) = S(t-1) 4…

A: Standard input function  Impulse function  Step function  Ramp function  Parabolic function

Q: The switch in the circuit in Fig. P7.1 has been closed for a long time before opening at t = 0. a)…

A: We are authorized to answer only 3 subparts at a time since you have not mentioned which part you…

Q: For an AC transformer, higher is the secondary leakage 1.higher is the secondary induced e.m.f…

A:

Q: What is the load, in amps, for a three-phase, 480V feeder supplying a load calculated at 112.5kVA

A: Apparent Power =3 VL ILActive Power =3 VL ILcos(ϕ)Reactive Power =3 VL ILsin(ϕ)

Q: If the resolution of a digital-to-analog converter is approximately 0.4% of its full-scale range,…

A: Given: A digital to analog converter with resolution % R = 0.4 % of its full scale range

Q: A 4 − μ F capacitor is initially charged to 300 V. It is discharged through a 100 mH inductance and…

A: Conditions For Oscillation: For oscillation, the condition should be Undamped or Underdamped and For…

Q: A circular coil having140 turns and a diameter of 4.50 cm is placed in a uniform magnetic field. The…

A: Given, Turns in the coil, N=140 Diameter of coil, d=4.50 cm Initial magnetic field, B1=0.300 T Final…

Q: b. The circuit shown in figure 8 is the project work that students in Circuit Analysis class last…

A:

Q: Explain the concept of spread spectrum modulation.

A: Spread-spectrum modulation: Before transmitting a signal, a group of signaling techniques known as…

Q: A common application of control systems is to regulate the temperature of a chemical process, as…

A:

Q: 4. Find the F. T. of the following Signals using differentiation pro ** <-2 2 2 t t ANTR Ans FCw) =…

A: In this question,  We need to determine the Fourier transform of given signal.  We are solving this…

Q: A load of 100 Ω is to be matched to a transmission line with a characteristic impedance of 50 Ω. Use…

A: Given: Characteristic impedance, Zo=50Ω Load impedance, ZL=100Ω

Q: Use thenodalanalysisto find the branch currentsi1,i2, andi3in the given circuit.

A: Given: Required: i1,i2 and i3

Q: Q1: Find the period of the following Signals: 4 Ult) + 4cOS5πt. 2-2 Sin (3πt) 2. given the Signal…

A: As per guidelines given to us we can only provide the solution of first question in multiple type of…

Z parameter

The Z-parameters that are the impedance parameters of a two-port network are defined by expressing the two-port voltages V1 and V2 in terms of two-port currents I1 and I2. The Z-parameters are calculated by open circuiting one of the two ports at a time henceforth they are called open-circuit impedance parameters.