Describe the various pipes commonly used in water conveyancing

Q: The rigid bar ABC is supported by a pin at B and two vertical steel rods. Initially the bar is horiz...

A: Given data,  E = 200 GPa α = 11.7 x10 ^-6 /C° ∆T = 50 °C   To find out the stress in each rod. 

Q: uzzle velocity of 150 m/sec. directed upward at 60o with the horizontal. Determine the a) total time...

A:

Q: 1. Given a compound beam as shown, construct the influence lines for R, Re R Vg Mg, and M Compute th...

A:

Q: The distance between center of gravity and center of pressure on a submerged gate is decreasing as s...

A: step 1-

Q: What concetrated load can be carried by a 250 x 250 mm beam if the length is 2000 mm and the modulus...

A:

Q: 3. Using the data about the active sludge treatment stage below, determine the sludge age. Suspended...

A: Dear student,  Please find the answer in the below attachments  Thank you 

Q: When it comes to structural testing, what are the several stages?

A: Structural testing, also known as glass box testing or white box testing is an approach where the te...

Q: The population of a certain barangay is known to increase at a rate proportional to the number of pe...

A:

Q: RC Frame System Mostly used form of construction Columns and beams are not there Thickness of the wa...

A: RC Frame System 1.Mostly used form of construction to provide better strength and to increase the li...

Q: ne frame shown below carries

A: given:

Q: the

A:

Q: cantilever beam is shown below, Determine the Moment Equation for 0<x<L.   Note: Determine/derive ...

A: In order to determine the Moment equation as a function of x for given beam the support reactions ha...

Q: e amount of water evaporated from a water surface is estimated by the following except for A) evapor...

A: Lysimeter data is used as it gives the most accurate result and is based on experiments

Q: A hydrographic survey was conducted on a reservoir to determine its capacity by contour method. The ...

A:

Q: A trapezoidal masonry dam with vertical upstreamn face is 7 m high, 2 m at the top and 4 m wide at t...

A: Given; B=3 m H= 6 m μ=0.8 Weight of concrete= 23.5 KN/m3

Q: The Intramuros Golf course wants to collect rainwater into its area spanning over 10 hectares. The g...

A: a golf course is there which wants to collect the rainwater into its area spanning over the 10 hecta...

Q: A small balcony constructed of wood is supported by three identical cantilever beams (see figure). 4...

A: Let q be the UDL load acting on beam ; So; q = w L22 Where ; w = design load = 6.1 kPa = 6.1 KN/m3 =...

Q: Which formula can be used to estimate the Book Value?

A:

Q: How do you respond to a flashflood that is fast approaching in your area? A have a plan to protect e...

A: (E) is the correct answer.  Flash Floods are sudden floods that are caused due to number of events. ...

Q: A cable of uniform thicknes ings between two points 120 part, with one end 3 m aboL

A: A cable is there which have the uniform thickness which hangs between two points. The cable is loade...

Q: A simple curve has an external distance of 11.28 m and a middle ordinate of 10.54 m. The tangents in...

A: Given: The external distance is 11.28 m. The middle ordinate is 10.54 m. The station at V is 321+021...

Q: raw shear force and bending momentdiagram for beam below 100 KN/m M = 1200 kN.m %3D A 2 m 4 m Im' 1m

A:

Q: A circular footing of 3 m diameter has to carry a gross load of 4500 kN. The foundation soil is Ciay...

A:

Q: A watershed 600 ha in area experienced a rainfall of unifom intensity 2.0 cm/h for duration of 8 hou...

A:

Q: Determine the force (P) required to prevent block from moving, given that us = 0.4 and uk = 0.23. F ...

A: Given data,  μs = 0.4 μk = 0.23 F1 = 803 unit θ = 33°   To find out the force P required to prevent ...

Q: kN M = kN - m

A:

Q: The big cylinder can with one closed end is submerged under water with air. The cylinder has dimensi...

A: Initial presure inside the cylinder  Patm=101325 Pa Initial volume of Air V1=π4D2H When cylinder sub...

Q: Draw the B.M.D. for the following, (EI) is constant. 40kN/m ↑ ↑ ↑ ↑ ↑ ↑ f A В C 3m 3m

A:

Q: Determine the force (P) required to prevent block from moving, given that us = 0.39 and uk = 0.29. F...

A:

Q: The figure as shown below is a rigid bar which is supported by two rods and a pin support. If the sa...

A:

Q: Determine the force (P) required to prevent block from moving, given that us = 0.39 and uk = 0.29. F...

A:

Q: - 4@50 =-- 4@100- -rest @ 175- 2-032 - 012 2-020 – 400 mm -175mm -→ (®\SECTION -1525 mm- CANTILEVER ...

A:

Q: Member(s) of the frame shown below carries/carry zero force is/are 10 kN- EO 60B 30°

A: The member force is zero when at a joint the two members are collinear and there is no external forc...

Q: Determine (approximately) the internal moments at joints A and B of the frame? 3 kN/m F H 6 m D F 6m...

A:

Q: ntal axes for the section shown.

A: solution of above problem is below:  

Q: Evaluate the braced frame system shown for the lateral drift an set it for an acceptable limit of h/...

A: given data-A-36 steel is used, E- 29,000 allowable tensile strength = 21,5 ksi.

Q: Determine the kinetic energy in joules, of a 2 gram riffle bullet traveling at 1640 ft/s

A: The given question is related with mechanics . In this question we are provided with value of mass r...

Q: From the beam shown below, the location of the hinge and roller supports are at 0 and 6 m respective...

A: L = 10m

Q: (All loads are in kN) 4. For the compound beam and loads as shown, find (a) the maximum reaction at ...

A:

Q: 55 kips. D 55 kips- C 5 ft 55 kips B 5 ft/ F 27.5 kips A A5 ft G 8 ft 8 ft 8 ft E.

A:

Q: Differentiate between random and systematic errors; include causes for each.

A: Every measurement has a confidence interval, which is referred to as an error. This error might occu...

Q: A 25-kg projectile is fired vertically upward from the ground. If the velocity is 35 m/s at 5 m abov...

A:

Q: A catapult is used to throw large projectiles by the ancient civilization. If a catapult swung from ...

A: ASKED: To compute the force exrted by the catapult on the projectile.   Given, Mass of the projectil...

Q: A woman having a mass 70 kg stands in an elevator which has a downward acceleration 4 m/sec? startin...

A: Given, Mass, m= 70 kg Downward acceleration, a = 4 m/s2 Elevator distance, s = 6 m

Q: A sample material with circular cross-section tapers uniformly. Over a gauge length of 200mm, it tap...

A:

Q: A simply supported beam shown is laterally supported at its ends and is subjected to the following s...

A:

Q: A regular cube of unknown material carries additional load of 3000 Newtons and becomes half submerge...

A:

Q: 18 KN A 45 KN 3m 3m Ri 12m Bm R2

A:

Q: The short column below is subjected to Pu = 1500 kN. . Use f’c = 28 MPa and fy = 415 MPa, Clear cove...

A: Given, Pu=1000 kN F'c=28 MPaFy=415 MPa Clear cover= 40 mm

Q: The rigid bar ABC is supported by a pin at B and two vertical steel rods. Initially the bar is horiz...

A:

Electric Circuit and Components

An electrical circuit or electrical network is a pre-determined pathway to make the electrons flow in the desired direction. The flow of electrons will set up a current flow in the circuit. Normally, the flow of electrical current is opposite to the flow of electrons. An electron is a fundamental sub-atomic particle of an atom possessing a negative charge. To initiate the flow of current and achieve the desired output, the electrical circuit should necessarily be composed of closed pathways. The pathways are made-up of good conductors of electricity such as aluminium and copper.