Design a two way light control then implement the design using: A.PAL realization. B. LUT programme. C. FPGA with VHDL code.

Q: For a FM system, the maximum freq deviation is 75 kHz and the maximum freq of the info. signal is 10…

A: According to Carson's formula, the bandwidth (B) of a frequency modulated system can be expressed as

Q: What is the processing gain in a DSSS system with a 1.5-MHz channel and a data rate of 20 kbps?

A: In Direct sequence spread spectrum the pseudorandom code which occurs at fast rate can increases the…

Q: rite a short note on quadra

A: Quadrature amplitude modulation : Quadrature amplitude modulation is also known as QAM it is the…

Q: What is the purpose of the Enable line in a multiplexer

A: Multiplexer also known as data selector.

Q: the question is "if we need to send an ECG data. determine a minimum and maximum data rate require…

A: In modern times, data or information is usually sent via digital format. The digital format is…

Q: Explain the relationship between Id and Vds of Mosfet ?

A:

Q: Using Verilog continuous assignment statements or VHDL signal assignment statements, write a…

A:

Q: 17.1 What are the keys to a successful mixed-signal PCB layout?

A: Types of PCB  Single layer PCB Multi Layer PCB High frequency PCB Double layer PCB HDI layer PCB…

Q: Q1:make a comparison between PAM and PPM?

A: Given :    Note :  It is a kind notice that according to the guidelines of the company is supposed…

Q: 1. Describe the operation theory of FM modulation.

A: Brief description : Note : According to the guidelines of the company if the questions are of…

Q: Specifically describe in a real world application scenario how virtualization is different from…

A: Networking- In technological term A network is a collection of computers, servers and other devices…

Q: Q1/ Draw block diagram for AM modulation? Q2/ Draw block diagram for AM demodulation? Q3/ What are…

A: "Since you have posted a question with multiple sub parts we will solve first three subpart for you…

Q: 3. Define: a) The circuit that causes one signal to modulate another, and give the names of the two…

A:

Q: Difference between active high and active low pin?

A: The solution can be achieved as follows.

Q: Explain the Base Width Modulation effect.

A: Base width modulation is also known as early effect . The decrease in effective base width with…

Q: What are some of the advantages of SAS versus SCSI?

A: The advantages of SAS over SCSI are given below---

Q: 17,4 How many reference planes are needed for a mixed-signal PCB? a

A: For a mixed-signal PCB, the system would have a single reference plane. If the system will have more…

Q: What will happen if a signal, whose voltage is above the maximum tolerable voltage of the ADC, is…

A: If we give a voltage which is above maximum voltage of ADC then ,then the ADC will show its maximum…

Q: Explain the benefit of using IF stage in super heterodyne receivers.

A: A general block diagram of SUPERHETERODYNE RECEIVER:-

Q: Contrast the advantages and disadvantages of digital transmission.

A: Advantages of digital transmission are, It provides immunity towards the noise. These signals are…

Q: Explain: Description of GPIB instrument interface

A: Solution: The GPIB or IEEE 488 transport is a truly adaptable framework, permitting information to…

Q: CWhat are the Q- point values of IC,VCE?

A: The solution can be achieved as follows.

Q: How many OC signals are combined into a 40 Gbps SONET network

A: D) 516096 From table 39813.12 Mbps i.e 40 Gbps the number of OC signals/channels combined are 516096

Q: Describe clearly the working of Super heterodyne receiver with a neat sketch and also write down the…

A: WORKING OF SUPER HETERODYNE RECEIVER: The Super heterodyne receiver  is utilized in many types of…

Q: Suggest another FSK modulation circuit and explain its operation briefly.

A: FSK Modulation is a half-century old technique for communication which is used in variety of…

Q: In a PCM system, the maximum frequency of the analog input signal is 4 kHz. If the number of…

A: Given that  Maximum frequency of the analog input signal (fm) = 4 kHz Quantization level=2 =2n So…

Q: 4. Explain the benefit of using IF stage in super heterodyne receivers.

A: In super heterodyne receivers we use IF stage here are the benefits for this

Q: Q. What are the types of CMKs in AWS KMS?

A: It is asked about the types of CMKs in AWS KMS.

Q: a) Explain with a neat diagram the construction and working of a TRF receiver.

A: The TRF is known as tuned radio frequency receiver and it is used for tuning or selecting the radio…

Q: a) Answer the following questions in more than two lines. i) What type of signals do a WDM use?…

A: FDM, TDM, and WDM are types of analog and digital multiplexers.

Q: A. Determine the High-level and Low-level noise margins for 5 Volt CMOS Family.

A: BJT and MOSFET are the class of transistors used in analog electronics. They are widely used…

Q: Q 2(a) Give three classifications of stability and give an example of each type. Q 2(b) How is…

A: Given :   Here in the question they want to know the classification of the stability of a system.…

Q: HW 3 What is aliasing phenomenon, and what is it's effect on the data recovery in DCS, show how can…

A: Aliasing phenomenon that occurs during the improper sampling process. It is also the process of…

Q: Modify the Laser Circuit FSM to output x for 25 ns, assuming Tclk = 5 ns. Draw the new State…

A: Note: As per Bartleby guidelines, as both question are different, solution for only first question…

Q: Data flow Model.

A:

Q: what is Successive approximation ADC? please explain

A: Here is block diagram of SAR. It uses Bisection method to keep or alter the bit for set or reset.…

Q: 1- Why the PMMC instrument can be used for dc measurement only?

A:

Q: what do you mean by term parity of a digital world ?

A: In digital world, parity is a technique that checks whether the data is lost or written over when it…

Q: In a public switch telephone network (PSTN),how the analog speech signal is converted to digital…

A: The human voice generates sound waves, a telephone converts the sound waves into analog signals.…

Q: If an 8086 running at 10MHz performs bus cycles with two wait states, what is the duration of the…

A: 8086 Microprocessor: This microprocessor is a 16-bit microprocessor having a 20 address lines and…

Q: 3. Explain the benefit of using IF stage in super heterodyne receivers.

A: Super heterodyne receiver is also known as beat receiver, this receiver consist a oscillator which…

Q: Explain the purpose of ASI and CPI testing in VAST deployments.

A: VSAT: A two-way ground system that collects and sends satellite data is called the very small…

Q: Which of the following is not an outdoor propagation model? a) Longley-Rice model b) Ericson…

A: In this case, from the given list of propagation models, the one which is not applicable for outdoor…

Q: What are the uplink and the downlink frequency bands for GSM 1800?

A: In the following section, the information on the uplink and downlink frequency bands of GSM 1800…